Practical method for generation expansion planning based on dynamic programming

This paper presents an efficient method which provides the optimal generation mix and the optimal generation construction process. The approximation method in which the dynamic programming technique and gradient method are combined is applied to determine the optimal generation mix with hydropower generation technologies. The successive approximations dynamic programming (SADP) technique, which is very suitable for high-dimensional multistage decision process problems, is used for obtaining the optimal generation construction process. The effectiveness and feasibility of the developed technique are demonstrated on a practical power system model which has five types of generation technologies including a hydropower generation technology.     

Effects of nondensifying inclusions on the densification and microstructure of zinc oxide matrix composites

The densification and microstructure development of ZnO containing Zn₇Sb₂O₁₂, ZrO₂, and aggregated ZnO were investigated to elucidate the effect of nondensifying inclusions on the sintering of ceramic/ceramic composites. The inclusion retarded the densification, and the degree of retardation was found to depend on the chemical species of inclusion; Zn₇Sb₂O₁₂ had the largest effect, followed by ZrO₂ and then aggregated ZnO last. The experimental results for aggregated ZnO was explained by the theory which predicts the generation of backstresses. The backstresses give a less significant effect on the densification. For Zn₇Sb₂O₁₂ and ZrO₂, the microstructure of the matrix varied with distance from an inclusion particle; much porosity was observed in the region surrounding the inclusion. Circumferential voids, which are responsible for the suppression of densification, form during the initial stage of sintering. Inclusion particles generate an anchoring effect which retards the densification of the matrix immediately surrounding the inclusion particle during the intermediate stage.Supported by the Inamori Foundation.     

Gel chromism and anomalous luminescence in poly(3-alkylthiophene)

The absorption spectrum of poly(3-alkylthiophene) gel changes drastically in association with a volume instability upon changing the solvent composition and also the temperature. In the expanded state in chloroform and at high temperature, the photoluminescence is much enhanced compared with the shrunken state in ethanol and at low temperature. This gel chromism and anomalous luminescence are discussed in terms of the change of effective conjugation length induced by the steric hindrance and the dynamics of the photoexcited species.     

Interconnected power systems with superconducting magnetic energy storage

The objective of this work is to discuss the concept of back‐to‐back interconnection systems with energy storage, especially with a Superconducting Magnetic Energy Storage (SMES) incorporated into a back‐to‐back DC link. In this case, each converter of the back‐to‐back system is used as a power conditioning system for the SMES coils. Since the AC–DC converter can be designed independently of the frequency of the power system, a two‐way switch is connected to the AC side of each converter. This two‐way switch can select the interconnected power systems. By using the two‐way switches, this system can provide the stored energy in the SMES system to each interconnected power system through two AC–DC converters. For instance, lower‐cost power of each power network can be stored through two converters during the off‐peak hours and made available for dispatch to each power network during periods of demand peak. Then this system increases the reliability of electric power networks and enables the economical operations depending on the power demand. This paper describes the unique operations of the back‐to‐back interconnection with SMES and discuses the optimal SMES configuration for a 300‐MW‐class back‐to‐back interconnection. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(2): 37–43, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20482     

The structure of acetylene flames for diamond synthesis

An acetylene flame was photographed with an SIT camera through optical filters, and the signals were Abel transformed to obtain two-dimensional emission-intensity profiles. It was found that the intensive emissions of CH* and C*₂ are localized at the feather boundary, while the OH* emission is localized at the intermediate zone. The structure of the acetylene flame was made clear: it consists of a carbon-radical-rich feather and an oxygen-radical-rich intermediate zone. The carbon-radical concentrations are approximately in equilibrium near the burner exit while they decrease almost linearly via interdiffusion and reactions with the oxygen-radicals in the intermediate zone.Numerical simulations including detailed gaseous and surface reactions reproduced well previous preliminary calculations showing that CH₄ is rapidly produced in the boundary layer near the substrate followed by an increase in CH₃. This result satisfactorily explains the measured dependence of growth rate on the substrate temperature and ratio.     

Mapping evapotranspiration using MODIS and MM5 Four-Dimensional Data Assimilation

Evapotranspiration (ET), the sum of evaporation from soil and transpiration from vegetation, is of vital importance in the hydrologic cycle and must be taken into consideration in assessments of the water resources of any region. The MODerate resolution Imaging Spectroradiometer (MODIS) sensor offers a promising opportunity for estimating daily ET with a 1 km spatial resolution, but is hampered by frequent cloud contamination or data gaps from other factors. In this study, 1) a stand-alone ET model was applied and tested during clear or partial cloudy sky conditions using MODIS-based inputs of land surface and atmospheric data and 2) meteorological simulations by using Four-Dimensional Data Assimilation (FDDA) system between MODIS and the 5th Generation Meso-scale Meteorological Model (MM5) was used in cloudy conditions to facilitate continuous daily ET estimates. The MODIS ET algorithm modified from Mu et al. (2007) is based on the Penman-Monteith equation and was applied to predict ET at flux measurement sites. This algorithm considers both the effects of surface energy partitioning processes and environmental constraints on ET. We devised gap-filling approaches for MODIS aerosol and albedo data that were identified as bottlenecks to determine retrieval rates of insolation and ET. MODIS-derived input variables (i.e., meteorological variables and radiation components) for estimating ET showed a good agreement with flux tower observations at each site. The retrieval rate of MODIS ET doubled at four flux measurement sites after gap-filling with negligible compensation was undertaken for accuracy. In spite of the high accuracy of MODIS-derived input variables, MODIS ET showed meaningful errors at the four flux measurement sites. These errors were mainly associated with errors in the estimated canopy conductance. During clear sky conditions, MODIS was used to calculate ET, while the MODIS-MM5 FDDA system provided input variables for the calculation of ET under cloudy sky conditions. The performance of the MODIS-MM5 FDDA system was evaluated by comparing ET based on MODIS, which showed a good agreement with the MODIS ET for various land cover types. Our results indicate that MODIS can be applied to monitor the land surface energy budget and ET with reasonable accuracy and that MODIS-MM5 FDDA has the potential to provide reasonable input data of ET estimation under cloudy conditions.     

Descent three-term conjugate gradient methods based on secant conditions for unconstrained optimization

The conjugate gradient method is an effective method for large-scale unconstrained optimization problems. Recent research has proposed conjugate gradient methods based on secant conditions to establish fast convergence of the methods. However, these methods do not always generate a descent search direction. In contrast, Y. Narushima, H. Yabe, and J.A. Ford [A three-term conjugate gradient method with sufficient descent property for unconstrained optimization, SIAM J. Optim. 21 (2011), pp. 212–230] proposed a three-term conjugate gradient method which always satisfies the sufficient descent condition. This paper makes use of both ideas to propose descent three-term conjugate gradient methods based on particular secant conditions, and then shows their global convergence properties. Finally, numerical results are given.     

Oxidation kinetics for <Emphasis Type="Italic">cis</Emphasis>-9,<Emphasis Type="Italic">trans</Emphasis>-11 and <Emphasis Type="Italic">trans</Emphasis>-10,<Emphasis Type="Italic">cis</Emphasis>-12 isomers of CLA

The autoxidation processes of the cis-9,trans-11 (c9,t11) and trans-10,cis-12 (t10,c12) isomers of CLA were separately observed at ca. 0% RH and different temperatures. The t10,c12 CLA oxidized faster than the c9,t11 isomer at all tested temperatures. The first half of the oxidation process of t10,c12 CLA obeyed an autocatalytic-type rate expression, but the latter half followed first-order kinetics. On the other hand, the entire oxidation process of c9,t11 CLA could be expressed by the autocatalytic-type rate expression. The apparent activation energies and frequency factors for the autoxidation of the isomers were estimated from the rate constants obtained at various temperatures based on the Arrhenius equation. The apparent activation energies for the CLA isomers were greater than those for the nonconjugated n−6 and n−3 PUFA or their esters. However, the enthalpyentropy compensation held during the autoxidation of both the CLA and PUFA. This suggested that the autoxidation mechanisms for the CLA and PUFA were essentially the same.     

Physiology and Pathophysiology of Heparan Sulfate in Animal Models: Its Biosynthesis and Degradation

Heparan sulfate (HS) is a type of glycosaminoglycan that plays a key role in a variety of biological functions in neurology, skeletal development, immunology, and tumor metastasis. Biosynthesis of HS is initiated by a link of xylose to Ser residue of HS proteoglycans, followed by the formation of a linker tetrasaccharide. Then, an extension reaction of HS disaccharide occurs through polymerization of many repetitive units consisting of iduronic acid and N-acetylglucosamine. Subsequently, several modification reactions take place to complete the maturation of HS. The sulfation positions of N-, 2-O-, 6-O-, and 3-O- are all mediated by specific enzymes that may have multiple isozymes. C5-epimerization is facilitated by the epimerase enzyme that converts glucuronic acid to iduronic acid. Once these enzymatic reactions have been completed, the desulfation reaction further modifies HS. Apart from HS biosynthesis, the degradation of HS is largely mediated by the lysosome, an intracellular organelle with acidic pH. Mucopolysaccharidosis is a genetic disorder characterized by an accumulation of glycosaminoglycans in the body associated with neuronal, skeletal, and visceral disorders. Genetically modified animal models have significantly contributed to the understanding of the in vivo role of these enzymes. Their role and potential link to diseases are also discussed.     

Study of drive system for linear induction motor using magnetic energy recovery switch

This paper proposes a power supply suitable for driving linear induction motors. The power supply consists of a voltage source inverter (VSI) and a magnetic energy recovery switch (MERS). Circuit configuration and operation principles of the power supply are described. Power factor correction by MERS can increase the output power. Technical advantages of using MERS compared with increasing the rated voltage of VSI are discussed. Some experiments with a linear induction motor were conducted. The results confirm that MERS can reduce the capacity of the VSI or increase the output with the same VSI capacity. The number of devices and magnitude of losses are evaluated on a large‐scale drive system. A half‐bridge type of MERS is provided and discussed. The half‐bridge MERS mitigates disadvantages of using MERS. © 2009 Wiley Periodicals, Inc. Electr Eng Jpn, 169(4): 65–74, 2009; Published online in Wiley InterScience ( www.interscience. wiley.com ). DOI 10.1002/eej.20832