Influence of impact-ionization-induced base current reversal onbipolar transistor parameters

In this paper we describe a set of measurements representing a complete characterization of impact-ionization effects in bipolar transistors. We demonstrate that impact-ionization significantly influences the dependence of base resistance on current and voltages applied to the device. A dc method for the simultaneous extraction of all parasitic resistances in bipolar transistors is presented. The method can separate the influence of current-crowding on the base resistance from that of base width and conductivity modulation; the collector parasitic resistance is measured in the active region. Starting from the parameters extracted by means of these techniques, a complete and accurate circuit-model of impact-ionization effects can be defined     

Stress corrosion cracking of cold-worked austenitic stainless steels

Stress corrosion cracking (SCC) of AISI 304L and AISI 316L stainless steels, cold-worked under various conditions (i.e. at different degrees of deformation obtained by drawing and rolling at room temperature and at liquid nitrogen temperature) has been carried out in H₂O containing 1000 ppm Cl^? at 250°C and in a boiling MgCl₂ solution. The effect of heat treatments at 400 and 900°C on the SCC of previously cold-worked steels has also been studied. Particular attention was directed towards heat treatment at 400°C. In steels deformed at room temperature, it increases the SCC resistance. By contrast, for steels deformed at liquid nitrogen temperature, heat treatment at 400°C reduces the SCC resistance if carried out for short periods of time (1–6 h). Hardness measurements, structural analyses via X-rays, scanning and transmission electron microscopy (SEM and TEM), as well as modified Strauss tests, seem to prove that reduced stress corrosion resistance is not to be related to the chromium-rich carbides precipitation which could have been accelerated by the presence of α′-martensite. Instead, they tend to suggest that perhaps this phenomenon is connected to an increase in the level of internal micro-stresses which are generated by a reciprocal re-ordering of the α′ and γ structural phases.     

Envelopes with microplastics generated from recycled plastic bags for crude oil sorption

Oil spill accidents in marine environments and the lack of disposal of post-consumer plastic are environmental problems worldwide. This study presents a sustainable alternative for both issues through envelopes filled with microplastics (MPs) from recycled bags for the sorption of spilled crude oil. Through particle size analysis by three different sieves (4, 9, and 20 mesh), different MP sizes were characterized by scanning electron microscope (SEM), Brunauer–Emmett–Teller (BET), density, contact angle (CA), and Fourier-transform infrared spectroscopy (FTIR). According to their sizes, the MPs were distributed in envelopes and submitted to crude oil sorption capacity and efficiency evaluation. Three MP particle sizes were obtained (from the largest to the smallest, according to the sieve mesh, MP4, MP9, and MP20). SEM images of samples exhibited irregular and porous surfaces, and MP4 had the smallest pore size (8.6 μm). BET showed that MP4 had the highest surface area (0.074 m²/g). The CA > 90° exposed that all samples were hydrophobic. FTIR spectrum demonstrated that the samples from the recycled bags were made of high density polyethylene (HDPE). The MP4 envelopes also had the best crude oil sorption results in capacity and efficiency (1.73 g/g and 68%, respectively), being a promising recycled sorbent in crude oil spillage applications.     

Fatigue cracks nucleation on steel, acoustic emission and fractal analysis

In this paper, a new acoustic emission (AE) diagnostic technique, for the study of fatigue cracks nucleation and propagation on steel, was investigated. Using the fractal analysis, and the box-counting method (BCM) in particular, it is possible to characterize the spatial distribution of the prime AE sources through the fractal dimension (D) that evolve with the number of fatigue cycles (N) of the specimen. D–N curves were found useful to identify the condition of incipient collapse due to the nucleation and propagation of fatigue cracks on steel. It is possible to use the fractal dimension as a damage parameter. In all tested specimens, the crisis occurs within the same range of values of fractal dimension. The results suggest that it is possible to anticipate the detection of crack beginning relating to the other theoretical or experimental techniques.     

The effect of ionising radiation on photosynthetic oxygenic microorganisms for survival in space flight revealed by automatic photosystem II-based biosensors

Photosynthetic microorganisms are expected to be useful to maintain an oxygenic atmosphere and to provide biomass for astronauts in the International Space Station as well as in future long-term space flights. However, fluxes of complex ionizing radiation of various intensities and energies make space an extreme environment for the microorganisms, affecting their photosynthetic efficiency. To automatically monitor the photosynthetic Photosystem II (PSII) activity of microorganisms under space conditions an optical biosensor, which utilizes chlorophyll fluorescence as biological transduction system, was built; the PSII activity was monitored by the biosensor during balloon flights at stratospheric altitudes of about 40 km. The effect of space stress on quantum yield of PSII varied among the tested species depending on the growth light conditions at which they were exposed during the flights.     

Neutronic characterization of the MEGAPIE target

The MEGAPIE project aimed to design, build and operate a liquid metal spallation neutron target of about 1 MW beam power in the SINQ facility at the Paul Scherrer Institut (Villigen, Switzerland). This project is an important step in the roadmap towards the demonstration of the accelerator driven system (ADS) concept and high power liquid metal targets in general. Following the design phase, an experimental program was defined to provide a complete characterization of the facility by performing a “mapping” of the neutron flux at different points, from the center of the target to the beam lines. The neutronic performance of the target was studied using different experimental techniques with the goals of validating the Monte Carlo codes used in the design of the target; additionally, the performance was compared with the solid lead targets used before and after the MEGAPIE experiment.     

Characterisation of SiOxCyHz thin films deposited by low-temperature PECVD

SiO_xC_yH_z thin films were deposited from hexamethyldisiloxane (HMDSO)/O₂ mixtures in a parallel plate, capacitively coupled, RF plasma reactor. Polyethylene terephthalate (PET), Si(1 0 0) wafers and KBr tablets were chosen as substrates. Effect of HMDSO/O₂ ratio, total treatment pressure and power input on the properties of the deposited films were investigated. The structure and bondings were studied by means of Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy. Wettability characteristics of the deposited thin films were investigated by means of water droplet contact angle measurements. Surface morphology was investigated with atomic force microscopy. Barrier properties of the SiO_xC_yH_z thin films were investigated by measuring the water vapour transmission rate of the coated PET substrates. Correlations between the characteristics of the deposited film and their barrier properties were discussed.     

Ifosfamide and vinorelbine: an active regimen for patients with relapsed or refractory Hodgkin's disease

Twenty-six patients with relapsed or refractory Hodgkin's disease (HD) were treated with an intensive salvage regimen combining ifosfamide (3000 mg/m2/d, days 1-4 through continuous intravenous infusion) and vinorelbine (25 mg/m2, i.v. days 1 and 5) with mesna uroprotection and G-CSF support. Courses were given at 3-week intervals. Ten patients achieved a complete and 10 patients a partial response, yielding an overall response rate of 77%. The main toxic effect was neutropenia and the combination was well tolerated.     

''Dual positivity'' for neural tube defects and down syndrome at maternal serum screening: gestational outcome

The pattern of anatomical features of the brain revealed by magnetic resonance imaging (MRI) is described in six patients incidentally identified as having acallosal brains. The complex of morphological features associated with complete agenesis of the corpus callosum included lateral displacement of slitlike anterior horns of the lateral ventricles (bullhorn-like shape), dilatation of the posterior horns of the lateral ventricles, absence of the septum pellucidum, lateral displacement of the cingulate gyri, complete separation of fornices and the presence of the anterior commissure and longitudinal callosal bundles (Probst's bundles). No compensatory enlargement of the anterior commissure was seen in the patients. The planimetrically measured cross-sectional areas of the anterior commissures were between 2.0 and 4.2 mm2 (mean 3.1) (in ten normal subjects they were 4.5, SD 0.4; range 3.8-5.2 mm2) and were reduced in four and normal in two patients. Inconstant morphological features were an absence of the posterior commissure and a radial pattern of the sulci and gyri on the medial aspect of the hemispheres. Conventional clinical testing revealed no abnormalities except a slight impairment of walking heel-to-toe in two patients. None of the patients had subjective restrictions of activities of daily life, which shows the efficacy of unknown compensatory processes.