Inconel 690传热管GTAW对接焊接头组织及力学性能研究

对Inconel 690传热管材进行钨极气体保护焊(GTAW)对接焊,采用拉伸试验机、压扁试验机和光学显微镜测试和分析传热管焊接接头,同时利用ANSYS软件开展焊接接头在设计工况失压时的一次应力强度校核。研究结果表明:焊缝中心为树枝胞状晶,熔合线附近为粗大柱状晶。室温时接头的平均抗拉强度为619 MPa,平均屈服强度为292 MPa,350℃时接头平均抗拉强度为475 MPa,平均屈服强度为206 MPa,拉伸接头断裂从熔合区开始贯穿整个焊缝组织,呈塑性断裂。压扁试验和反向压扁试验结果表明管接头完好。通过ANSYS分析可知,设计工况下传热管接头350℃许用应力强度150 MPa限值可满足其一次应力强度要求,且裕量较大。     

课程思政在现代学徒制煤化工专业课程中的教学探索——以"煤质分析及煤化工产品检验"课程为例

现代学徒制是一项深化产教融合、校企合作的育人机制,是创新技术技能人才的现代培养模式.山西铁道职业技术学院与山西安泰控股集团有限公司深度合作开展山西省现代学徒制试点项目,合作目的之一是培养企业煤化工专业人才.学校教师结合学生(员工)在企业车间岗位上的技能知识,系统地讲授煤化工专业课程"煤质分析及煤化工产品检验"理论知识,同时针对企业员工日常学习思想政治知识较少的实际,润物细无声地加入思政元素,实现专业知识与实践技能相结合,技能知识与思政教育相融合,真正培养知识型、技能型、创新型高素质技能人才,努力构建职业教育产业发展命运共同体.     

Iterative equalization combining algorithm in intersymbol interference channel

To realize joint optimization of spatial diversity and equalization combining in the intersymbol interference (ISI) channel, an iterative equalization combining algorithm is proposed. The proposed algorithm uses the coefficients of Turbo equalization to calculate the combination weights without estimating the signal to noise ratio in each diversity branch. The equalized symbols from different diversity branches are combined, and the extrinsic information output from the decoder is fed back to the equalizers, so as to exchange soft information between the equalizers and the decoder. The performance of the proposed algorithm is analyzed using the extrinsic information transfer (EXIT) chart and verified by simulations. Results show that our approach fully exploits time domain information from the multipath channel and spatial domain information from multi receiving antennas, which efficiently improve the performance of the receiver in the severe ISI channel.     

印度卫星导航系统发展及现状研究

介绍了印度 GPS 辅助型静地轨道增强导航系统(GAGAN)和印度区域卫星导航系统(IRNSS)的最新研究进展，重点介绍了 IRNSS 系统的体系结构、信号样式和导航电文，分析了 IRNSS 系统的能力，最后介绍了印度导航系统的发展计划。     

Effect of Biochar as Reductant on Magnetizing-roasting Behavior of Pyrite Cinder

The effect of biochar substituted for anthracite as reductant on magnetizing-roasting pyrite cinder was investigated.The key of magnetizing-roasting is the gasification reaction between reductants and CO2.Since biochar could react with CO2 more rapidly at lower temperature,the reactivity of biochar is better than that of anthracite.The gasification of biochar could produce reducing condition ofφCO/(φCO+φCO2)about 10%-20% between 700-800 ℃,which is in accord with the atmosphere and temperature of Fe2O3 reduction.So it is beneficial to the reduction of iron mineral of pyrite cinder.Compared with anthracite,biochar could decrease the roasting temperature from825 to 750 ℃ and roasting time from 20 to 15min,which shows that a better effect of magnetization could be obtained in the condition of lower temperature and shorter time.Using biochar as reductant,iron concentrate extracted from pyrite cinder as about 64%iron grade could be produced,and the recovery is over 90% under the condition of above 90% grinding particle less than 0.045 mm and magnetic intensity of 0.124-0.194 T.     

恢复邢台百泉泉水流量可行性研究

通过百泉泉区天然状态与超采状态下的水环境对比分析,并对岩溶水补给量和开采量进行计算,阐述恢复邢台百泉泉水流量的可行性,随着“引朱济邢”和“南水北调”供水工程的实施,邢台百泉水生态环境的恢复将变为现实。     

钴卟啉/双模型介孔分子筛的制备

通过对双模型介孔分子筛(BMMS)的改性,用疏水性的基团将介孔分子筛表面的羟基硅烷化,利用N端基和钴原子的配位将钴卟啉嫁接到介孔分子筛孔道中,得到了分散度高、热稳定性好的有机无机复合双模型介孔分子筛;并通过XRD、BET、TG-DTA等手段对制备的样品进行了表征.结果表明,硅烷化将钴卟啉成功地接枝在BMMS的表面,使钴卟啉得到较好的分散,提高了钴卟啉的热稳定性,且仍保持了BMMS的结构.制备的钴卟啉/BMMS催化剂将用于环己烷和环己烯的非均相催化氧化.     

宽工作电压范围单电源CMOS误差放大器

采用0.8μm标准数字CMOS工艺(VTN0=0.836V,VTP0=0.930V),设计并流片验证了具有宽工作电压范围(3～6V),可作SOC系统动态电源管理芯片内部误差放大器应用的单电源CMOS运算放大器。该误差放大器芯核同时具有适合低电压工作,并对工艺参数变化不敏感的优点。对于相同的负载情况,在3V的工作电压下,开环电压增益AD=83.1dB,单位增益带宽GB=2.4MHz,相位裕量Φ=85.2°,电源抑制比PSRR=154.0dB,转换速率Sr=2.2V/μs;在6V工作电压下,AD=85.1dB,GB=2.4MHz,Φ=85.4°,PSRR=145.3dB,Sr=3.4V/μs。