Rheological Property and Stress Development during Drying of Tape-Cast Ceramic Layers

Rheological property and stress development of tape-cast ceramic layers derived from nonaqueous alumina (A1₂O₃)-poly(vinyl butyral) (PVB) suspensions were observed during drying. Casting suspensions exhibited strong shear-thinning behavior, with a low shear Newtonian plateau apparent viscosity >10² Pa^.s. The apparent suspension viscosity displayed a power-law dependence on the A1₂O₃ volume fraction during the initial stage of drying (<30% solvent loss). Stress development, measured by a cantilever deflection method, and parallel weight loss measurements were performed during the drying of tape-cast layers and pure binder coatings. Maximum drying stresses (σ_max) of 1.37-0.77 MPa were observed for plasticized tapes cast at gap heights of 150-400 μm. In contrast, nonplasticized tapes of similar thickness displayed a more gradual stress increase, with σ_max values approximately an order of magnitude higher than their plasticized counterparts. The stress histories of the corresponding binder coatings were quite similar to the tape-cast layers, albeit slightly lower σ _max values were observed. Stresses decayed beyond σ_max with a logarithmic time dependence to an almost constant value of 0.2-0.4 MPa for the plasticized tapes. Based on these observations, process methodologies have been offered to minimize stress development and retention in tape-cast ceramic layers     

Polymorphic stability of some shortenings as influenced by the fatty acid and glyceride composition of the solid phase

A number of North American vegetable and animal fat shortenings, which had been analyzed previously for their physical and textural characteristics, were analyzed also for their chemical composition. The fatty acid and triglyceride composition of the solids were calculated by analyzing the composition of the original product and the liquid phase, and by determination of the solid fat content (SFC) of the fat. The solids were also isolated by isopropanol (IP) separation, and the high melting glycerides (HMG) by acetone crystallization at 15°C. There was not much difference in total saturates andtrans content between vegetable and animal fat shortenings. Changing formulations from soy-palm to soy-cottonseed does not change the total saturates plustrans content. The solids of the vegetable shortenings in the β form contained about 20% of 16:0, those in the β′ form 30% or more. The animal fat shortenings were mainly in the β form, their solids contained 30% or more of 16:0. C54 triglyceride content of the solids of β vegetable shortenings (calculated and IP-separated) was >45%, that of all animal fats was <25%. Solids of animal fat shortenings contain high levels of C52. The C54 triglycerides are β-tending and should be kept low in vegetable shortening. In the HMG the C54 should not exceed 30%. This can only be achieved by incorporation of a β′ hard fat, preferably palm hard fat. Animal fat, especially lard, crystallizes in the β form because the palmitic acid in the glyceride molecule is located in the 2-position, whereas those of vegetable fats are in the 1- and 3-position.     

The Managerial Implications of Real-Time New Product Development in Financial Services

A review of the various models of New Product Development (NPD) process shows that although different approaches have been proposed, they are in fact all variants on a linear theme: some may include feedback loops, but they all essentially advocate that certain steps precede, or are preceded by, others. An inevitable consequence on the Internet/World Wide Web (WWW or Web) is that such models are no longer applicable. Based on the lessons learned from the development of a new financial service offered via the Internet, we show how such assumptions of linearity need no longer be a constraint. In addition, innovativeness is not related to firm size. But the fact that the Web allows for the real-time development of new financial services based on on-going feedback from potential and current customers raises a new set of managerial issues that have to be tackled. The objective of this paper is to use the context of the recent launch of an innovative financial service product via the Web to explore the managerial changes that are starting to affect the banking industry.     

An accurate volumetric differential pressure method for the determination of hydrogen storage capacity at high pressures in carbon materials

Widely different hydrogen adsorption capacities have been reported for a variety of carbon materials which have attracted attention for hydrogen storage. This has led to doubts as to the validity of some of the claims and it has been suggested that one possible reason for the disparate hydrogen sorption capacities may lie in the inaccurate measurement of the hydrogen adsorbed. The aim of the work described in this paper was to make a contribution to this debate by developing a means and method of producing repeatable, accurate measurements of hydrogen sorption capacity in carbon materials. The apparatus developed is a volumetric differential pressure set-up operating at up to 10 MPa and the method has a conservative limit of detection of 0.1 wt% and an accuracy of ±0.05 wt%, using 1.0-2.5 g samples of the carbon materials studied. These included a carbon nanofiber sample and a series of activated carbons, the latter displaying a direct correlation between the BET effective surface area and the hydrogen sorption capacity of the materials. The amount of hydrogen adsorbed was less than 1 wt% for all the carbons examined.     

Single‐Step Deposition of Au‐ and Pt‐Nanoparticle‐Functionalized Tungsten Oxide Nanoneedles Synthesized Via Aerosol‐Assisted CVD,and Used for Fabrication of Selective Gas Microsensor Arrays

Tungsten oxide nanostructures functionalized with gold or platinum NPs are synthesized and integrated, using a single‐step method via aerosol‐assisted chemical vapour deposition, onto micro‐electromechanical system (MEMS)‐based gas‐sensor platforms. This co‐deposition method is demonstrated to be an effective route to incorporate metal nanoparticles (NP) or combinations of metal NPs into nanostructured materials, resulting in an attractive way of tuning functionality in metal oxides (MOX). The results show variations in electronic and sensing properties of tungsten oxide according to the metal NPs introduced, which are used to discriminate effectively analytes (C₂H₅OH, H₂, and CO) that are present in proton‐exchange fuel cells. Improved sensing characteristics, in particular to H₂, are observed at 250 °C with Pt‐functionalized tungsten oxide films, whereas non‐functionalized tungsten oxide films show responses to low concentrations of CO at low temperatures. Differences in the sensing characteristics of these films are attributed to the different reactivities of metal NPs (Au and Pt), and to the degree of electronic interaction at the MOX/metal NP interface. The method presented in this work has advantages over other methods of integrating nanomaterials and devices, of having fewer processing steps, relatively low processing temperature, and no requirement for substrate pre‐treatment.     

Evaluation of a program to motivate impaired driving offenders to install ignition interlocks

Approximately 30,000 alcohol ignition interlocks, which are designed to prevent the operation of a vehicle if the driver has been drinking, are in use in the US and Canada. Ignition interlock programs are also being initiated in Sweden and Australia. The best-controlled studies that are currently available suggest that ignition interlocks are effective in reducing impaired driving recidivism while on the vehicle. However, in the US, the practical effectiveness of these devices is limited because only a small number of offenders are willing to install them in order to drive legally. This paper reports on a study of a court policy that created a strong incentive for impaired driving offenders to install interlocks by making traditional penalties, such as jail or electronically monitored house arrest, the alternative to participation in an interlock program. Comparison of the recidivism rates of offenders subject to this policy with offenders in similar, nearby courts, not using interlocks, indicated that the policy was producing substantial reductions in DUI recidivism.     

Coding mammograms using the classification "probably benign finding--short interval follow-up suggested"

OBJECTIVE: Many benign breast lesions revealed by mammography show features indicating that the lesions have a high, but not complete, likelihood of being benign. The Breast Imaging Reporting and Data System (BI-RADS) allows radiologists to classify these mammograms as "probably benign finding-short interval follow-up suggested" (category 3). We explored whether certain factors are associated with the use of category 3 in a national cancer detection program. MATERIALS AND METHODS: We analyzed data from the National Breast and Cervical Cancer Early Detection Program, a comprehensive nationwide program that provides cancer screening for low-income and medically underserved women. The study population included all women at least 40 years old who had undergone mammography on or before September 30, 1996 (n = 372,760). RESULTS: Of the 372,760 mammograms, 7.7% were classified as category 3. The probability of receiving a category 3 classification decreased as patients' ages increased. Women who were symptomatic were nearly twice as likely as women who were asymptomatic to receive a category 3 classification, and women whose clinical breast examinations had abnormal findings were more than twice as likely as women with examinations having normal findings to receive a category 3 classification. The percentage of mammograms classified as category 3 by state or tribal organization ranged from 1.4% to 14.0%. CONCLUSION: Several patient variables, including patient symptomatology, were associated with the probability of having a mammogram classified as category 3. One of the most important determinants was where the patient underwent mammography, which suggests that variability exists among radiologists themselves in using this BI-RADS code for "probably benign" mammographic lesions.     

Pathogenesis of an infectious mononucleosis-like disease induced by a murine gamma-herpesvirus: role for a viral superantigen?

The murine gamma-herpesvirus 68 has many similarities to EBV, and induces a syndrome comparable to infectious mononucleosis (IM). The frequency of activated CD8+ T cells (CD62L(lo)) in the peripheral blood increased greater than fourfold by 21 d after infection of C57BL/6J (H-2(b)) mice, and remained high for at least a further month. The spectrum of T cell receptor usage was greatly skewed, with as many as 75% of the CD8+ T cells in the blood expressing a Vbeta4+ phenotype. Interestingly, the Vbeta4 dominance was also seen, to varying extents, in H-2(k), H-2(d), H-2(u), and H-2(q) strains of mice. In addition, although CD4 depletion from day 11 had no effect on the Vbeta4 bias of the T cells, the Vbeta4+CD8+ expansion was absent in H-2IA(b)-deficient congenic mice. However, the numbers of cycling cells in the CD4 antibody-depleted mice and mice that are CD4 deficient as a consequence of the deletion of MHC class II, were generally lower. The findings suggest that the IM-like disease is driven both by cytokines provided by CD4+ T cells and by a viral superantigen presented by MHC class II glycoproteins to Vbeta4+CD8+ T cells.