A Contemporary Survey on IoT Based Smart Cities: Architecture,Applications, and Open Issues

Wireless Personal Communications - Internet of Things (IoT) is one of the emerging technologies, which is widely used across the globe. As the idea of a smart city was founded, IoT has been...     

Spray dryer processed graphene oxide/reduced graphene oxide for high-performance supercapacitor

This study deals with the utility of mini spray dryer process to improve the dispersibility, of graphene oxide(GO) and its application for high-performance supercapacitor. Initially, the neutral solution of GO was obtained using the modified Hummer's method. After this, the prepared GO solution was processed by mini spray dryer to obtain a more purified, lighter, and dispersed form of GO which is named as spray dryer processed GO (SPGO). The SPGO thus obtained showed excellent dispersibility behavior with various solvents, which is not found in case of conventional oven drying. Furthermore, utility of SPGO and its reduced form (r-SPGO) for supercapacitor applications have been investigated. Results obtained from the cyclic voltammetry(CV) analysis, impedance, and charge-discharge behavior of supercapacitor fabricated using r-SPGO shows enhanced features. Therefore, the simple spray dried GO and its reduced form, that is, r-SPGO can be utilized as a potential candidate for the supercapacitor application. Herein, as synthesized SPGO exhibited the specific capacitance of 12.07 and 37.6 F/g with PVA-H₃PO₄ and 1 mol/L H₃PO₄, respectively, at a scan rate of 5 mV/s. On the other hand, reduced form of SPGO, that is, r-SPGO showed the specific capacitance of 27.16 and 230 F/g with PVA-H₃PO₄ and 1 mol/L H₃PO₄, respectively.     

Development of LTCC micro-hotplate with PTC temperature sensor for gas-sensing applications

Low temperature co-fired ceramic (LTCC) micro-hotplates show wide applications in gas sensors and micro-fluidic devices. It is easily structured in three-dimensional structures. This paper presents the low power consumption micro-hotplates which were developed with PTC (positive temperature coefficient) temperature sensor and inter-digitated electrodes. The paper presents two different structures for micro-hotplate with platinum as a heating element. The PTC temperature sensor using two different materials viz. PdAg and platinum paste are developed with micro-hotplates. The simulation has been achieved through COMSOL for LTCC and alumina micro-hotplates. The temperature variation with power consumption has been measured for the developed LTCC micro-hotplates. The change in resistance of PTC temperature sensors was measured with micro-hotplate temperature. The aim of this study was to place a temperature sensor with the gas sensor module to measure and control the temperature of micro-hotplate. A SnO₂ sensing layer is coated on LTCC micro-hotplate using screen printing and characterized for the sensing of carbon monoxide gas (CO). This study will be beneficial for designing hotplates based on LTCC technology with low power consumption and better stability of temperature for gas-sensing applications.     

Epidemiological study of hypertension and its determinants in an urban population of North India

OBJECTIVES: To determine age-specific prevalence of hypertension and blood pressure (BP) levels in relation to diet and lifestyle factors in North Indians. DESIGN AND SETTING: Cross-sectional survey in 20 randomly selected streets in Moradabad, North India. SUBJECTS AND METHODS: A total of 1806 subjects from North India (904 males and 902 females) age range 25-64 years. The survey methods were as follows: dietary diaries for 7 days food intake record; BP measurements; physician administered questionnaire and anthropometric measurements. Diagnosis of hypertension was based on new World Health Organization/International Society of Hypertension (WHO/ISH) criteria. Risk factors were assessed based on WHO guidelines. RESULTS: The prevalence of hypertension according to WHO/ISH criteria was 23.7% and by old WHO criteria 13.3%. In the WHO/ISH hypertensive group, isolated diastolic hypertension was present in 47.3% males and 40.6% females. Males have a slightly higher prevalence than females in the young age group, however, the prevalence rates are comparable in the older age groups. In both sexes, the prevalence rates and BP level increased with older age. Multivariate analysis revealed that age, higher body mass index, central obesity and higher socioeconomic status were independently and strongly associated with hypertension in both sexes. Higher dietary fat and salt intake and lower physical activity were weakly but significantly associated with hypertension. CONCLUSION: Association of higher socioeconmic status, higher body mass index and central obesity in North Indian adults with higher fat intake, lower physical activity and higher prevalence and level of hypertension indicate that these populations may benefit by decreasing the dietary fat intake and increasing physical activity, with an aim to decrease central obesity for decreasing hypertension in North Indians.     

Supporting real-time and multimedia applications on the Mercuritestbed

This paper describes the distributed system, network and software architecture, the application development environment, the performance, and the early lessons learned on the ATM LAN testbed Mercuri established at the Honeywell Technology Center, to develop distributed multimedia technologies for real-time control applications. We have developed a client-server-based software architecture on Sun Sparcstation-2s connected by a Fore Systems' ASX-100 ATM switch, with video processing handled by Parallax's X Video cards. The architecture enables network-transparent applications and provides simple primitives for multimedia capture, display, transmission, storage, and retrieval. A real-time multimedia-in-the-loop control application was developed as the vehicle for testing the capabilities and performance of the network. Our test measurements focus on the end-user-level performance metrics such as message throughput and round-trip delay as well as video-frame jitter under no-load and load conditions. Our results show that the maximum burst throughput that can be supported at the user level is 48 Mb/s using AAL 5, while round-trip delays for 4-kbyte messages are about 3 ms. Our experience reveals a number of performance bottlenecks and open issues in using commercial ATM switches for practical applications. Our conclusions are outlined     

A unique method for reducing losses of bends in dielectric optical wave guide

The dielectric optical wave guide is finding growing attention at millimeter wave frequencies. However the dielectric optical waveguide radiates at bends and thus transmission loss increases. These radiations are in the outword direction of bends. This output radiation at output bends arises due to change in phase velocities of the propagating wave at the centre of the dielectric guide and the phase velocity at the outer surface of the dielectric guide. A unique methiod is suggested to avoid these radiation losses.Experimental results are also shown at microwave frequencies.