磨料有序排布电镀砂轮的制备及其把持力研究

为解决电镀砂轮磨削加工中容屑空间不足的问题，采用点胶微粘接的方法制备了磨料有序排布的电镀砂轮，分析了磨料粘接效果和镀层力学性能。通过SEM分析了磨料/镀层/导电胶的结合界面，并进行了干磨削试验。研究结果表明，直径约为磨料粒径40%的胶点可粘接住磨料，单个胶点上粘接多颗磨料的占比小于6%；双脉冲电镀工艺制备的镀层显微硬度大于500HV，表层残余应力小于100MPa，磨料/镀层/导电胶之间的界面贴合紧密，无明显缺陷；砂轮在磨削时没有出现磨料脱落现象。     

超高效液相色谱串联质谱法测定烟草中的噁霉灵残留

为降低烟草中噁霉灵检测中的基质干扰，提高检测灵敏度和和稳定性，通过试验建立了以QuEChERS为样品前处理方法、液相色谱串联质谱仪为检测仪器的烟草中噁霉灵残留检测方法。样品加水浸润后，经丙酮提取、盐析试剂包除水、石墨化炭黑除杂后，采用Agilent ZORBAX 300SB-C8液相色谱柱（2.1 mm×100 mm，1.8 μm）分离，甲醇-水程序洗脱，ESI雾化，串联质谱MRM检测。结果发现，该方法在0.0025~0.0500 mg/L范围内线性良好，决定系数r²=0.9996，定量检测限1.06 μg/L，回收率在90.8%~92.0%之间，相对标准偏差为5.1%。运用该方法测定烟草中的噁霉灵，操作简单，检测精度高，满足CORESTA对烟草农残检测的要求。     

人工颅骨用复合材料中微量甲基丙烯酸甲酯的气相色谱法测定

采用氢气焰离子化检测器(FID),以正丁醇为外标物,PEG-20M为固定相,甲醇作为溶剂,气相色谱法测定复合材料人工颅骨中微量MMA的含量。其相对标准偏差<0.022,平均回收率(n=4)为98.0％～99.1％。此方法操作简便,用于实际样品分析可得到满意的结果。     

EGD级环保型润滑油及其生物降解性

 经生物降解性评定和粘度测量确定了EGD级生物降解二冲程润滑油复合基础油的组成；通过发动机清净性试验确定了添加剂组成配方和总添加量。在此基础上，研制了生物降解二冲程油(Oil B)，其达到了ISO EGD级二冲程油标准中规定的6个发动机性能指标和2个理化性能指标，生物降解性达到73.1%。     

智能天线对移动通信网性能的影响

智能天线是目前移动通信中的热点话题之一，也是提升网络容量和改善传输质量的关键技术。本文简要介绍了智能天线基本概念，原理及其在无线网络中的重大作用。     

基于多抽样率信号处理的无源雷达MTD方法

以数字电视信号为机会照射源的雷达系统研究为背景 ,提出用以多抽样率信号处理为基础的多级抽取信号处理算法解决运动目标检测中海量数据处理问题。文中叙述了数字电视广播信号回波的数学模型、多级抽取基本原理、目标检测算法 ,以数字电视信号为反射回波做了仿真 ,对运动目标进行检测 ,并对仿真结果做了分析。     

Prolonged tamoxifen exposure selects a breast cancer cell clone that is stable in vitro and in vivo

The effects of long-term tamoxifen exposure on cell growth and cell cycle kinetics were compared between oestrogen receptor (ER)-positive (MCF-7) and ER-negative (MDA-MB-231) cell lines. In the MCF-7 cell line, prolonged tamoxifen exposure (0.5 mumol/l for > 100 days) blocked cells in G0-G1 of the cell cycle, and slowed the doubling time of cells from 30 to 59 h. These effects corresponded to an increase in the cellular accumulation of tamoxifen over time [mean area under concentration curve (AUC) = 77.92 mumoles/10(6)/cells/day]. In contrast, in the MDA-MB-231 cell line, long-term tamoxifen exposure had no obvious effect on the doubling time, and reduced cellular tamoxifen accumulation (mean AUC = 50.50 mumoles/10(6)/cells/day) compared to the MCF-7 cells. Flow cytometric analysis of MDA-MB-231 cells demonstrated that a new tetraploid clone emerged following 56 days of tamoxifen exposure. Inoculation of the MDA-MB-231 tetraploid clone and MDA-MB-231 wildtype cells into the opposite flanks of athymic nude mice resulted in the rapid growth of tetraploid tumours. The tetraploid tumours maintained their ploidy following tamoxifen treatment for nine consecutive serial transplantations. Histological examination of the fifth transplant generation xenografts revealed that the tetraploid tumour had a 25-30 times greater mass, area of haemorrhage and necrosis, a slightly higher mitotic index and was more anaplastic than the control neoplasm. The control wildtype MDA-MB-231 tumours maintained a stable ploidy following tamoxifen treatment until the eighth and ninth transplantation, when a tetraploid population appeared, suggesting that tamoxifen treatment may select for this clone in vivo. These studies suggest that prolonged tamoxifen exposure may select for new, stable, fast growing cell clones in vitro as well as in vivo.     

费萨姆工艺无水氨精馏塔的模拟计算

本文以ＮＨ３－Ｈ２Ｏ系统Ｇｉｂｂｓ自由能、熵、焓和汽液相平衡的热力学模型为基础，用松弛法进行了无水氨精馏塔的模拟计算。改变无水氨采出比、回流比（直汽量）和进料板位置均影响蒸馏效果。     

Dy3+激活的几种硼酸盐在VUV-VIS范围的光谱性质

本文报道了SrAl2B2o7:Dy^3 、BaAl2B2O7:Dy^3 、SrAl3BO7:Dy^3 、La2CaB10O19:Dy^3 的紫外－真空紫外（UV－VUV）激发光谱和UV激发下的发射光谱。根据发射光谱讨论了Dy^3 离子在这几种基质中发光的黄蓝比（Y／B）。在VUV激发光谱中推测了Dy^3 的f-d跃迁及电荷迁移态（CTS）和基质吸收的位置。     

Research on Marine Boiler＇s Pressurized Combustion and Heat Transfer

The effect of pressure on combustion and heat transfer is analyzed. The research is based on the basic combustion and heat transfer theorem. A correction for the heat calculation method for pressurized furnace is made on the basis of the normal pressure case. The correction takes the effect of pressurizing into account. The results show that the correction is reasonable and the method is applicable to combustion and heat transfer of the marine supercharged boiler.