Unperturbed dimension of poly(4-acetoxystyrene) measured in good and theta solvents

In order to obtain the additional data concerning the unperturbed dimension of poly-4-substituted styrene, light scattering measurements are performed on the twenty-two fractions with molecular weight of (0.91–352)·10⁴ of poly(4-acetoxystyrene) in dioxan at 25°C, from which the molecular weight obtained was found easily to be evaluated with the gel permeation chromatography using THF. Phase separation experiments for this polymer indicate that the theta state is attained in isopropyl acetate at 19.7°C and butyl acetate at 26.8°C. By making viscosity measurements at that state, the value of K_Θ is directly evaluated as 5.4·10^?4 dl g^?1. The limiting viscosity number is also obtained in good solvents, THF and dioxan, at 25°C and constants of the Mark-Houwink-Sakurada equation in each solvent are determined. Further, approximately the same K_Θ as above is obtained from these data with the Stockmayer-Fixman plot. The calculated value of steric factor, 2.37, on this polymer may be plausible, compared with those of polyvinylaromatic derivatives.     

New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

Improvement of emission efficiency in polymer light-emitting devices based on phosphorescent polymers

We report improvement of emission efficiency in polymer light-emitting devices (PLEDs) employing phosphorescent polymers. A hole-blocking layer was inserted between the emissive layer and the cathode to enhance recombination efficiency for the injected holes and electrons. Aluminum(III)bis(2-methyl-8-quinolinato)4-phenylphenolato (BAlq) was used for the hole-blocking layer. The resultant PLEDs exhibited significant improvement of emission efficiency. The respective external quantum efficiencies for red, green and blue PLEDs were 6.6, 11 and 6.9%. These values are very high compared with those based on conventional fluorescent polymers.     

MITI projects on recycling

MITI has actively done R&D on industrial technology for waste and reclamation and so there are many research items from small scale to large scale. However, Ecofactory and researches on recycling of metallic materials are introduced here. Ecofactory was proposed by the Mechanical Engineering Laboratory and is now at the stage of the Leading Research, a new research scheme in AISt. Researches on recycling of metallic materials are being done with subsidy. Those researches should contribute to both the preservatin of the global environment and effective recycling of waste materials.Abbreviations AIST Agency of Industrial Science and Technology - MITI Ministry of International Trade and Industry - NEDO New Energy and Industrial Technology Development Organization     

Soliton self-frequency shift in orthogonally polarised femtosecondsolitons

The soliton self-frequency shift (SSFS) in orthogonally polarised femtosecond soliton pulses is reported for the first time. It is shown that SSFS for orthogonally polarised solitons is approximately 1/3 of that for parallel polarised solitons. This is attributed to the orthogonal Raman term. The 2π and π dependences of the SSFS on the phase difference between the two solitons are newly obtained for parallel and orthogonal polarisations, respectively. The largest SSFS occurs in-phase under parallel polarisation     

30 GHz pulse train generation from a multiquantum well electroabsorption intensity modulator

Stable optical pulse trains with repetition rates as high as 20-30 GHz have been successfully generated at 1.55 mu m from an InGaAs/InAlAs multiquantum well electroabsorption modulator for the first time.<>     

Temporal integration method for image-processing-basedsuper-high-resolution image acquisition

The authors propose an image processing-based approach towards the development of a super-high-resolution image acquisition system. Imaging methods based on this approach can be classified into two main categories: a spatial integration imaging method and a temporal integration imaging method. With regard to the spatial integration imaging method, the authors have previously presented a method for acquiring an improved-resolution image by integrating multiple images taken simultaneously with multiple different cameras. They develop their work, aiming at a particular class of application where a user indicates a region of interest (ROI) on an observed image in advance, and apply a prototypal temporal integration imaging method. The prototypal temporal integration imaging method does not involve global image segmentation, but uses a subpixel registration algorithm which describes an image warp within the ROI, with subpixel accuracy, as a deformation of quadrilateral patches. The method then performs a subpixel registration by warping an observed image with the warping function recovered from the deformed quadrilateral patches. Experimental simulations demonstrate that the temporal integration imaging is promising as a basic means of high resolution imaging     

The Ig heavy chain gene is frequently involved in chromosomal translocations in multiple myeloma and plasma cell leukemia as detected by in situ hybridization

Chromosome rearrangement of 14q32.33 has recurrently occurred with variable partner sites, including 11q13.3, 8q24.1, 18q21.3, and 6p21.1 in multiple myeloma (MM). To assess the actual incidence of 14q32.33 translocation and to elucidate its implication in the pathogenesis of MM, we studied 42 patients with MM, plasma cell leukemia, or plasmacytoma and 5 with monoclonal gammopathy with undetermined significance (MGUS) by G-banding and molecular cytogenetic methods. Using double-color fluorescence in situ hybridization (DCFISH) with 2 Ig heavy chain (IgH) gene probes, a yeast artificial chromosome (YAC) clone containing variable region, and a phage clone containing gamma constant region, 14q32.33 translocation was detected as split signals of the IgH gene in 31 patients with plasma cell malignancies and 3 with MGUS. In contrast, of 40 patients who were assessed by G-banding, 3 (7.5%) showed the 14q+ chromosome. DCFISH detected a split of the IgH gene on interphase nuclei in 34 (73.9%) of 46 patients analyzed, whereas on metaphase spreads, it was in 22 (51.2%) of 43 patients analyzed. Interphase DCFISH was particularly useful to detect 14q32.33 translocation in 17 (65.4%) of 26 patients with normal karyotypes. Donor sites were identified in 11 of 22 patients demonstrated as carrying 14q32.33 translocation by metaphase FISH. Chromosome t(11;14)(q13.3; q32.33) was detected in 5 patients, t(8;14)(q24.1;q32.33) in 2, t(14;18)(q32.33;q21.3) in 2, and t(7;14)(q32.1;q32.33) in 1. A complex 14q32.33 translocation involving 3q and 16q24 was detected in 1 patient. Myeloma cells with t(7;14) showed myelomonocytoid surface antigen. Because rearrangements of 14q32.33 were closely associated with translocation of proto-oncogenes into the IgH gene, our findings indicate that 14q32.33 translocation with various partner chromosomes is a critical event in the pathogenesis of MM and MGUS.     

Histo-pathological study of a glass-ionomer/resin (Geristore) restoration system

The purpose of this experiment was to investigate histo-pathologically the pulpal reaction to a glass-ionomer/resin (Geristore) restoration system in human teeth. Black's class I cavities were prepared in 22 human teeth; these were divided into 2 groups, one with the Geristore after cavity was cleaned with 10% NaOCl solution and 3% H2O2 solution (Group G) and the other with the Geristore after the cavity was applied with Mirage-Bond (Group MG). The treated teeth were observed clinically over 90 days after operation. They were then extracted for histological examination. No unpleasant symptoms were noted. A few pathological changes were observed. No histo-pathological score differences were observed between groups G and MG. The average evaluation score of pathological results in both groups G and MG were excellent. Microorganisms observed in the cavity dentin of the group G was fewer than in group MG. In some cases, microorganisms were observed along the dentin walls. In conclusion, the pulpal injury due to this Geristore restoration system was slight, and the system was considered to be safe for the pulp and clinically useful.