铝合金热轧板锭熔铸技术及设备

本文概述了近年来铝合金热轧板锭的熔铸设备和熔铸技术的发展和最新成就，重点介绍晶粒细化、熔体净化、检测及铸造新技术，为国内铝板带企业跟踪国际铝合金板锭熔铸技术、开展技术攻关和进行技术创新提供有益的参考。     

现场总线在冶炼烟气制酸系统中的应用实践

分析了冶炼烟气制酸工艺的特点，介绍了由PROFIBUS-DP现场总线构建的冶炼厂烟气制酸监控系统，详细介绍了其硬件配置及相应的软件设计。     

LFP-901(902)D型保护装置在大朝山电站的应用

大朝山电站500 kV两回输电线路与云南电网联系紧密,输送负荷大,可靠性要求较高,为此对500 kV线路继电保护的合理选配有重要意义。文章阐述了LFP-901(902)D型保护装置的原理,并提供了在大朝山电站的运行经验和数据。     

ca油田稠油油藏系统保护油气层研究

针对ca油田多层状砂泥薄互层稠油油藏的特点,开展了热采和非热采条件下储层变化特征研究、钻井和固井过程入井液的研究、采油工艺技术等系统保护油气层研究,了解各种变化的作用过程和原因,有效地预防现场施工中可能发生的储层伤害,从而达到储层保护、提高采收率的目的。     

2.4GHz动态CMOS分频器的设计

对现阶段的主流高速CMOS分频器进行分析和比较,在此基础上设计一种采用TSPC(truesingle phase clock)和E-TSPC(extended TSPC)技术的前置双模分频器电路.该分频器大大提高了工作频率,采用0.6μm CMOS工艺参数进行仿真的结果表明,在5V电源电压下,最高频率达到3GHz,功耗仅为8mW.     

结构化编程实现Sniffer

随着各高校校园网络规模的不断扩大和各种应用的急剧增加,各种新的网络问题也在不断出现。Sniffer是网络管理员进行网络管理的有效工具,可以有效地对网络进行实时监控,及时发现网络中存在的各种问题。本文首先介绍了Sniffer的工作原理,其次给出了实现Sniffer功能的编程流程图,并用C语言给出了编程所需的关键代码。     

Physico-chemical characterization of hybrid polymers obtained by 2-hydroxyethyl(methacrylate) and alkoxides of zirconium

Hybrid monolithic materials were prepared through polymerisation of 2-hydroxyethyl methacrylate (HEMA) mixed with zirconium alkoxides (Zr(OBuⁿ)₄, Zr(OPrⁿ)₄ and Zr(OEt)₄), modified by acetylacetonate groups. The molar ratio HEMA/Zr varied between 1 and 4. Thermo-Gravimetry coupled with Mass Spectroscopy (TG-MS) analyses, ¹³C MAS NMR and Dynamical Mechanical Thermal Analysys (DMTA) indicated the polymeric chains were interconnected by the inorganic component.The presence of zirconium alkoxides modified substantially the poly-HEMA properties. Glass transition temperature of hybrid materials derived from butoxy and propoxy was found in the range 50-80 °C, depending on the composition. The typical swelling of p-HEMA in the water, was suppressed by the presence of zirconium compounds. After immersion in distilled water, hybrid polymers showed an initial slight weight increase, followed by a small mass loss, which increases proportionally to the length of alkoxyl group (ethoxide(propoxide(butoxide) and reaches a constant value after about 40 days. The hybrids remained always rigid and transparent. Flexural modulus and strength of about 400-900 and 4-8 MPa were measured.     

双转向垂向控缝技术实验研究及现场应用

针对压裂过程中缝高较难控制的问题，研制开发出新型的油溶性垂向双转向剂，并开展了室内实验研究。首次验证了转向剂对裂缝延伸的控制机理，确定了转向剂的适用浓度及控缝能力。实验表明，转向剂可以增加隔层应力3～4MPa左右。在此基础上研究了控制裂缝高度施工方案的设计方法，并利用全三维软件结合垂向应力剖面对控缝技术进行了优化。现场推广应用30井次，取得了较好的控缝效果。     

Identification of in vitro phosphorylation sites in the growth cone protein SCG10. Effect Of phosphorylation site mutants on microtubule-destabilizing activity

SCG10 is a neuron-specific, membrane-associated protein that is highly concentrated in growth cones of developing neurons. Previous studies have suggested that it is a regulator of microtubule dynamics and that it may influence microtubule polymerization in growth cones. Here, we demonstrate that in vivo, SCG10 exists in both phosphorylated and unphosphorylated forms. By two-dimensional gel electrophoresis, two phosphoisoforms were detected in neonatal rat brain. Using in vitro phosphorylated recombinant protein, four phosphorylation sites were identified in the SCG10 sequence. Ser-50 and Ser-97 were the target sites for protein kinase A, Ser-62 and Ser-73 for mitogen-activated protein kinase and Ser-73 for cyclin-dependent kinase. We also show that overexpression of SCG10 induces a disruption of the microtubule network in COS-7 cells. By expressing different phosphorylation site mutants, we have dissected the roles of the individual phosphorylation sites in regulating its microtubule-destabilizing activity. We show that nonphosphorylatable mutants have increased activity, whereas mutants in which phosphorylation is mimicked by serine-to-aspartate substitutions have decreased activity. These data suggest that the microtubule-destabilizing activity of SCG10 is regulated by phosphorylation, and that SCG10 may link signal transduction of growth or guidance cues involving serine/threonine protein kinases to alterations of microtubule dynamics in the growth cone.     

一种软件实现虚拟景深的方法

影视后期制作或图像合成中，动态实时改变显示画面的景深能进一步增强画面的真实感，但由于实时性要求较高，软件实现在处理速度方面容易产生瓶颈。为此，采用预处理的办法，分别对前景和背景进行低通滤波，得到前、背景各自的模拟帧序列，通过调节前景和背景帧序列的位置，模拟确定其各自的变焦程度，然后将前景和背景动态合成具有虚拟景深效果的画面。