Aluminum based reflective nanolens arrays to improve the effectiveness of ultraviolet inactivation of Escherichia coli O157:H7 and Listeria monocytogenes in water and a sucrose solution

Food Science and Biotechnology - Aluminum based reflective nanolens arrays were developed via a series of aluminum electropolishing and anodization steps with subsequent selective dissolution of...     

Removal of imidacloprid and acetamiprid from tea infusions by microfiltration membrane

Removal of imidacloprid and acetamiprid in tea infusions by microfiltration membrane using dead‐end model was investigated in the present study. The results showed that microfiltration significantly promoted the removal of both pesticides (P < 0.05) in tea infusions. Furthermore, the extent of removal was strongly influenced by the pore size of membrane, operational pressure and the concentrations of tea infusions. The initial concentration of imidacloprid and acetamiprid showed no significant effect on their removal rates. The maximum removal rates were 79.7% for imidacloprid and 81.9% acetamiprid. The changes in major chemical components of tea infusions after microfiltration were evaluated. The results indicated that microfiltration caused no considerable changes in total polyphenols and total free amino acids, and small but statistically significant losses (6.3–18.0%) of eight catechins and three methylxanthines when filtration volume reached to 200 mL. The present study validated the application of microfiltration as a potentially feasible and promising method for the removal of imidacloprid and acetamiprid residues from tea infusions.     

Preparation and characterization of mullite whisker reinforced ceramics made from coal fly ash

Ceramics with mullite whiskers were prepared from coal fly ash and Al₂O₃ raw materials, with AlF₃ used as an additive. The phase structures and microstructures of the ceramics were identified via X-ray diffraction and scanning electron microscopy, respectively. The results show that pickling of coal fly ash is an effective method for enhancing the flexural strength of ceramics. Sintering temperature and AlF₃ addition were also key factors influencing the creation of ideal ceramics. The ceramic made from pickled coal fly ash, 6?wt% AlF₃, and sintered at 1200?°C, exhibited the highest flexural strength of 59.1?MPa, and had a bulk density of 1.32?g/cm³ and porosity of 26.8%. The results show that ceramic materials made under these conditions are ideal candidates for manufacturing ceramic proppants for the exploitation of unconventional oil and gas resources.     

电动汽车动态无线电能恒功率充电

电动汽车充电时,且电池电量低于80％时,为了保证充电效率一般采用恒功率充电.在动态无线电能传输系统中,电动汽车的不断移动会导致发射线圈和接受线圈的互感系数变化,致使电动汽车充电不稳定.为实现恒功率充电,提出了一种基于模型预测控制(MPC)的动态无线电能传输系统(DWPT)恒功率输出的控制方法.通过对系统建立数学模型,对输出功率进行模型预测,建立最小化目标函数来获得期望输出功率所对应的最优占空比,使输出功率恒定.进行了模型预测控制的动态无线电能传输系统Simulink仿真,通过对比不同线圈互感系数下的输出功率,验证了该方法的可行性,并且通过搭建实物测得的数据也证实了该方法的可行性.     

SUBSCRIPTION 2018

正Four issues per volume a year,CHINA’S REFRACTORIES is distributed worldwide by airspeed delivery at no extra cost to subscribers.     

FCC汽油叠合生产柴油的研究——(Ⅰ)叠合催化剂的研制

采用中孔γ-Al2O3为载体，以非贵金属Ni为活性金属组分，以金属Sn为助剂组分，制备了FCC汽油叠合生产柴油的催化剂。在实验室小型连续流动式固定床装置上，以FCC汽油为原料，考察了主活性金属负载量、助催化剂、催化剂制备条件对催化剂性能的影响。研究结果表明，在活性金属Ni质量分数为8％，助催化剂Sn质量分数为1％，浸渍时间6h，焙烧温度500℃，焙烧时间4h的条件下，制备的叠合催化剂的催化性能最好。并对催化剂进行了1500h的稳定性试验和再生性能考察，结果表明该叠合催化剂具有良好的稳定性和再生性能。     

Effect of Fog and Clouds on the Image Quality in Millimeter Communications

The effect of fog and clouds in millimeter communication is discussed, and the attenuation caused by fog and clouds is reviewed. Signal-to-noise ratio (SNR) of image is derived using relating models of fog and clouds attenuation. According to the relation of image quality and its signal-to-noise ratio, the system behavior is forecasted theoretically. It is shown that the signal-to-noise ratio of receiver at certain transmitter power is inverse with radio wave frequency, from about 70dB at 10GHz to 48dB for fog and 49dB for clouds. The image quality of received signal at certain transmitter power is inverse with radio wave frequency, from about 7 grade at 10GHz to 5.27 grade for fog and 5.37 grade for clouds. The above calculated results are consistent with experimental results.     

合成己二腈反应技术研究——(Ⅴ)己二腈工业反应过程模拟与反应器改造

对己二腈工业反应器提出了两釜串联带回流的模型,通过模拟计算得出模型的级间返混系数 f=6的结论。该模型能较好地预测工业反应器中物料组分浓度变化和气、液两相的流动特性;指出了现工业反应器的鼓泡中和段体积偏小是造成己二酸浓度偏高的关键;提出了可以通过增加串连一个鼓泡预反应段的改造方案,能有效地降低己二酸的浓度,从7%降至4%左右,从而能较好地减缓腐蚀和结焦。     

运用NOAA AVHRR和Landsat TM数据估算多年水稻种植面积

介绍了综合运用NOAA AVHRR和Landsat TM数据进行多年水稻种植面积监测的一种方法,以湖北省为例,首先运用Landsat TM数据计算了该省1992年的水稻种植面积;接着运用1992年和1994年的NOAA AVHRR数据分别计算这两年的水稻像元数,以这两年水稻像元数的变化来反映水稻种植面积的变化;最后运用线性模型,估算1994年的水稻种植面积。所得的1994年水稻种植面积与湖北省农调队资料相比精度为84.5%。运用同样的方法估算1995年该省的水稻种植面积,精度达90%以上。     

A model for evaluation and administration of security inobject-oriented databases

The integration of object-oriented programming concepts with databases is one of the most significant advances in the evolution of database systems. Many aspects of such a combination have been studied, but there are few models to provide security for this richly structured information. We develop an authorization model for object-oriented databases. This model consists of a set of policies, a structure for authorization rules, and algorithms to evaluate access requests against the authorization rules. User access policies are based on the concept of inherited authorization applied along the class structure hierarchy. We propose also a set of administrative policies that allow the control of user access and its decentralization. Finally, we study the effect of class structuring changes on authorization