High speed p-type SiGe modulation-doped field-effect transistors

We report on the fabrication and characterization of high-speed p-type modulation-doped field-effect transistors (MODFETs) with 0.7-μm and 1-μm gate-lengths having unity current-gain cut-off frequencies (f_T) of 9.5 GHz and 5.3 GHz, respectively. The devices were fabricated on a high hole mobility SiGe heterostructure grown by ultra-high-vacuum chemical vapor deposition (UHV-CVD). The dc maximum extrinsic transconductance (g_m) is 105 mS/mm (205 mS/mm) at room temperature (77 K) for the 0.7-μm gate length devices. The fabricated devices show good pinch-off characteristics and have a very low gate leakage current of a few μA/mm at room temperature and a few nA/mm at 77 K     

Profile dependence and measurement of absolute Raman scattering cross-section in optical fibres

A simple measurement method for the absolute Raman scattering cross-section of an optical fibre is presented. This method does not require a high power pump laser and it measures the fibre directly. It is also shown that the calculation of the cross-section depends on the fibre structure, such as its refractive index profile and the differential attenuation between the pump wavelength and Raman wavelength.<>     

Photoreactivation of Escherichia coli following medium-pressure ultraviolet disinfection and its control using chloramination.

Ultraviolet (UV) disinfection is becoming increasingly popular as an alternative disinfection technology to chlorination in recent years. In this study, we investigated the photoreactivation of Escherichia coli following medium-pressure (MP) UV disinfection of synthetic water by a bench-scale collimated beam apparatus. The UV doses ranged from 1.6 -19.7 mWs/cm2 and photoreactivation was investigated for 6 hours under fluorescent light. In addition, chloramination was applied after UV disinfection to investigate its ability to control photoreactivation. It was found that photoreactivation occurred for all UV doses tested and the increase in bacteria numbers ranged from 0.04 to 1.35 log10. However, the degree of photoreactivation decreased with increased UV doses. Chloramination experiments revealed that the addition of 0.5 mg/l of monochloramine resulted in suppression of photoreactivation for 1 hour only. An increased monochloramine dose of 1 mg/l was found to prevent photoreactivation for the entire duration of the experiment. The results of this study have shown that photoreactivation occurs even after MP UV disinfection, although it is of a lesser extent at higher UV doses. This study has also established that secondary chloramination can effectively suppress and eliminate photoreactivation with a chloramine dose of 1 mg/l.     

Self-Consistent Effects on the Starting Current of Gyrotron Oscillators

Self-consistent effects on the starting current of gyrotron oscillators are examined. Field profiles in the open cavity are shown to be sensitive to the interaction dynamics. This can either significantly raise or lower the oscillation threshold, particularly for the low-Q modes. The transition from resonant-mode oscillations at the low magnetic field to backward-wave oscillations at the high magnetic field is demonstrated.     

Effect of precyclic loading on stress-corrosion-cracking initiation in an X-65 pipeline steel exposed to near-neutral pH soil environment

A study was carried out to understand the effect of precyclic loading on stress-corrosion-crack initiation in an X-65 pipeline steel exposed to a near-neutral-pH soil environment. The test specimens were precyclically loaded before corrosion exposure to represent a service history of up to about 20 years, depending on the severity of pressure fluctuation. Microcracks had initiated on the polished surface of the X-65 pipeline steel after long-time exposure at open-circuit potential (OCP) in a near-neutral-pH synthetic soil solution. These microcracks were mostly initiated from pits at metallurgical discontinuities such as grain boundaries, pearlitic colonies, and banded phases in the steel. Strong preferential dissolution was observed along planes of the banded structures in the steel. The selective corrosion attack at these metallurgical discontinuities is attributed to the galvanic nature of those areas to their neighbors. Cyclic loading prior to corrosion exposure had significant effects on microcrack initiation and propagation during subsequent corrosion exposure. Cyclic loading prior to corrosion exposure either reduced or increased the probability of crack initiation and the rate of crack propagation, depending upon the magnitude of the stress cycles. The largest reduction was seen at a peak cyclic stress of about 0.8 of the yield strength. This cyclic-loading-dependent cracking behavior might be related to the alteration of the substructures and the residual stress in the steel as a result of precyclic loading.     

A multilevel soliton communication system

A multilevel soliton communication system is proposed and assessed. In this system, at the transmitter end each channel transmits its data via fundamental solitons with a pre-specified amplitude (i.e., soliton width). At the receiver end we take advantage of the sensitive relationship between the amount or fundamental soliton self-wavelength shift and the width of the soliton in the subpicosecond region. We first compress the incoming soliton noises to the subpicosecond level and pass them through a short length of fiber at the end of which the pulses have become separated in the wavelength domain since each soliton, corresponding to a data channel, has experienced a different Raman self-wavelength shift. The channels are then easily separated by optical filters. We have derived the design constraint relations for such a system. We have then heuristically designed a 40 Gbs (four channels) system for a 1000 km propagation distance (total data-rate distance product of 40 Tb/km). Numerical simulations and noise analyses have verified the feasibility and practicality of the proposed system with very good design margins. The wavelength jitter is found to be much smaller than the desired filter spacing, and thus its contribution to the bit error rate is negligible. We also argue that the system is more tolerant to Gordon-Haus timing jitter than conventional TDM soliton systems. The system is all fiber and is, therefore very cost effective as it does not require sophisticated electro-optic and microwave circuits for demultiplexing. The system can potentially operate at much higher speeds than those achievable in conventional soliton systems and it can be used in parallel with WDM soliton system     

传输线衰减常数与柱形谐振器Q值的关系

文中严格地讨论了任意截面形状，任意模式的柱形谐振腔Ｑ值与构成该谐振器的传输线衰减常数间的关系，给出了更一般的公式，推广了Ｄａｖｉｄｓｏｎ和Ｓｉｍ－ｍｏｎｄｓ＾［１］、Ｂａｒｌｏｗ和Ｃｕｌｌｅｎ＾［２］以及Ｙｅｈ和Ｓｈｉｍａｂｕｋｕｒｏ＾［３，４］的结果。     

淀积条件对GDa—SiNx薄膜电学特性的影响

本文讨论了用辉光放电法制备氮化硅薄膜时衬底温度、射频功率和气体流量比对薄膜的电导率、介电常数和击穿强度的影响。通过优化生长条件，制备了优质非晶氮化硅薄膜，其介电常数为７．５、击穿强度为５．５ＭＶ／ｃｍ、电导率为１０－１３（Ωｃｍ）－１。