ACAT inhibitors derived from hetero-Diels-Alder cycloadducts of thioaldehydes

Acyl-CoA:cholesterol acyltransferase (ACAT) is the enzyme largely responsible for intracellular cholesterol esterification. A systemic inhibitor of ACAT is believed to be able to slow or even reverse the atherosclerotic process. Towards that goal, a series of cyclic sulfides, derived from the hetero-Diels-Alder reaction of thioaldehydes with 1,3-dienes, and bearing carboxamide substituents, were prepared and evaluated for in vitro (in several tissues and species) and ex vivo ACAT inhibition. Minor changes in subsequent structure were found to have a significant effect in optimization of the biological activity of this series of compounds.     

Improved Thermal Performance of AlGaN/GaN HEMTs by an Optimized Flip-Chip Design

AlGaN/GaN high electron mobility transistors (HEMT) on sapphire substrates have been studied for their potential application in RF power applications; however, the low thermal conductivity of the sapphire substrate is a major drawback. Aiming at RF system-in-a-package, the authors propose a flip-chip-integration approach, where the generated heat is dissipated to an AlN carrier substrate. Different flip-chip-bump designs are compared, using thermal simulations, electrical measurements, micro-Raman spectroscopy, and infrared thermography. The authors show that a novel bump design, where bumps are placed directly onto both source and drain ohmic contacts, improves the thermal performance of the HEMT     

The catalysis of the Ruff oxidative degradation of aldonic acids by titanium‐containing zeolites

Ti‐BEA and Ti‐FAU, obtained by post‐synthesis treatment, and TS‐1, obtained by direct hydrothermal synthesis, have been tested as catalysts for the Ruff oxidative degradation of calcium d‐gluconate to d‐arabinose using diluted hydrogen peroxide as oxidant. Only large‐pore zeolites Ti‐BEA and Ti‐FAU were found to be active. It was shown, in particular, that a very rapid leaching of titanium occurred and that the titanium species present in the solution were responsible for the catalytic activity observed. This revised version was published online in August 2006 with corrections to the Cover Date.     

A 2D finite element analysis of the effect of numerical parameters on the reliability of Ti6Al4V machining modeling

Abstract

The numerical analysis, based on the finite element modeling (FEM), presents nowadays an efficient computational tool. It allows a better understanding of several thermo-mechanical phenomena involved during the machining process. However, its reliability heavily depends on the accurate definition of the numerical model. In this regard, a FE analysis focused on the 2D modeling of the Ti6Al4V dry orthogonal machining was carried out in this study. The relevance of different numerical meshing approaches and finite elements topologies was studied. The effect of the friction coefficient on the numerical chip morphology, its geometry, the cutting and the feed forces was investigated. The adequacy of several compared adaptive meshing approaches, in terms of the modeling of severe contact conditions taking place around the cutting-edge radius, was underlined in the current study. However, numerical serrated chips, closer to the experimental ones, were only predicted when the pure Lagrangian formulation was adopted and a proper determination of the failure energy was carried out. The definition of different mesh topologies highlighted the efficiency of the 4-node quadrangular mesh, with a suitable edge length, in increasing the agreement with the experimental data, while reducing the computing times.     

Site‐Selectively Coated,Densely‐Packed Microprojection Array Patches for Targeted Delivery of Vaccines to Skin

Densely packed dry‐coated microprojections are shown to deliver vaccines to targeted locations within the skin that are rich in immune cells, thus inducing protective immune responses against a lethal virus challenge. Selectively limiting the antigen coating to the tips of the projections, which penetrate the skin, would significantly reduce the amount of vaccine required in immunization. In this paper a simple technique, dip‐coating the microprojections, is introduced to meet this goal. By increasing the coating solution viscosity, an otherwise strong capillary action is mitigated and the desired controlled coating length on projections is achieved. Following application to the skin, most of the coated vaccine material is rapidly released from the projections (82.6% in mass within 2 min) to the target locations within the skin strata and a potent immune response is induced when a conventional influenza vaccine (Fluvax) is tested in a mouse model. The utility of this coating approach to a variety of molecules representative of vaccines (e.g., chicken egg ovalbumin (OVA) protein, DNA, and fluorescent dyes) is demonstrated. These collective attributes, together with the simplicity of the approach, position the dip‐coating method for practical utility in large vaccination campaigns.     

Deep-space calibration of the WindSat radiometer

The WindSat microwave polarimetric radiometer consists of 22 channels of polarized brightness temperatures operating at five frequencies: 6.8, 10.7, 18.7, 23.8, and 37.0 GHz. The 10.7-, 18.7-, and 37.0-GHz channels are fully polarimetric (vertical/horizontal, /spl plusmn/45/spl deg/ and left-hand and right-hand circularly polarized) to measure the four Stokes radiometric parameters. The principal objective of this Naval Research Laboratory experiment, which flys on the USAF Coriolis satellite, is to provide the proof of concept of the first passive measurement of ocean surface wind vector from space. This paper presents details of the on-orbit absolute radiometric calibration procedure, which was performed during of a series of satellite pitch maneuvers. During these special tests, the satellite pitch was slowly ramped to +45/spl deg/ (and -45/spl deg/), which caused the WindSat conical spinning antenna to view deep space during the forward (or aft portion) of the azimuth scan. When viewing the homogeneous and isotropic brightness of space (2.73 K) through both the main reflector and the cold-load calibration reflector, it is possible to determine the absolute calibration of the individual channels and the relative calibration bias between polarimetric channels. Results demonstrate consistent and stable channel calibrations (with very small brightness biases) that exceed the mission radiometric calibration requirements.     

The infinite time near optimal decentralized regulator problem for singularly perturbed systems: a convex optimization approach

This paper presents LQ decentralized pole location for singularly perturbed systems. The poles are located in a sector included in the left-half complex plane. The singular perturbation method is used to define reduced and well-behaved problems. It is shown that the LQ control problem with pole location in a sector can be solved using the LMI tool. The associated parametrical optimization problem involves a linear cost objective under LMI constraints. The decentralized control problem is then solved in the reduced slow system by just introducing structure constraints on the matrix variables, constraints that do not destroy the linearity and then the convexity of the problem.     

Characterization of cell deformation and migration using a parametric estimation of image motion

This paper deals with the spatio-temporal analysis of two-dimensional deformation and motion of cells from time series of digitized video images. A parametric motion approach based on an affine model has been proposed for the quantitative characterization of cellular movements in different experimental areas of cellular biology including spontaneous cell deformation, cell mitosis, individual cell migration and collective migration of cell populations as cell monolayer. The accuracy and robustness of the affine model parameter estimation, which is based on a multiresolution algorithm, has been established from synthesized image sequences. A major interest of our approach is to follow with time the evolution of a few number of parameters characteristic of cellular motion and deformation. From the time-varying eigenvalues of the affine model square matrix, a precise quantification of the cell pseudopodial activity, as well as of cell division has been performed. For migrating cells, the motion quantification confirms that cell body deformation has a leading role in controlling nucleus displacement, the nucleus itself undergoing a larger rotational motion. At the cell population level, image motion analysis of in vitro wound healing experiments quantifies the heterogeneous cell populations dynamics.     

Demonstration of a method for the direct determination of polycyclic aromatic hydrocarbons in submerged sediments

We describe the development of a novel method for real-time in situ characterization of polycyclic aromatic hydrocarbons (PAHs) in submerged freshwater sediments. Laser-induced fluorescence (LIF) spectroscopy, a mature technique for PAH characterization in terrestrial sediments, was adapted for shipboard use. A cone penetrometer-type apparatus was designed for probe penetration at a constant rate (1 cm/s) to a depth of 3 m. A field-portable LIF system was used for in situ measurements in which the output of a pulsed excimer laser was transmitted by optical fiber to a sapphire window (6.4-mm o.d.) in the probe wall; fluorescent emission was collected by a separate optical fiber for transmission to the spectrometer on deck. Four wavelengths (340, 390, 440, 490 nm) were selected via optical delay lines, and multiple-wavelength waveforms were created. These multiple-wavelength waveforms contain information on the fluorescence frequency, intensity, and emission decay rate. Field testing was conducted at 10 sites in Milwaukee Harbor (total PAH concentrations ranged from approximately 10 to 650 microg/g); conventional sediment core samples were collected concurrently. The core samples were analyzed by EPA methods 3545 (pressurized fluid extraction, PFE) and 8270C (gas chromatography-mass spectrometry, GC-MS) for PAHs. A partial least-squares regression (PLSR) model wasthen created based on laboratory LIF measurements and PFE-GC-MS of the core samples. The PLSR model was applied to the in situ field test data, and 13 of the 16 EPA-regulated PAHs were quantified with a relative error of <30% overall (the remaining three PAHs were found at levels insufficient to quantify). We additionally describe preliminary source apportionment relationships that were revealed by the PLSR model for the in situ LIF measurements.     

Term Collections in λ and ρ-calculi

The ρ-calculus generalises term rewriting and the λ-calculus by defining abstractions on arbitrary patterns and by using a pattern-matching algorithm which is a parameter of the calculus. In particular, equational theories that do not have unique principal solutions may be used. In the latter case, all the principal solutions of a matching problem are stored in a “structure” that can also be seen as a collection of terms.Motivated by the fact that there are various approaches to the definition of structures in the ρ-calculus, we study in this paper a version of the λ-calculus with term collections.The contributions of this work include a new syntax and operational semantics for a λ-calculus with term collections, which is related to the λ-calculi with strict parallel functions studied by Boudol and Dezani et al. and a proof of the confluence of the β-reduction relation defined for the calculus (which is a suitable extension of the standard rule of β-reduction in the λ-calculus).