Fast handoff with reducing waste rate approach for wireless resources management in UMTS mobile networks

3G Wideband CDMA systems adopt the Orthogonal Variable Spreading Factor code tree as the channelization codes management for achieving high data rate transmission in personal multimedia communications. It assigns a single channelization code for each accepted connection. Nevertheless, it wastes the system capacity when the required rate is not powers of two of the basic rate. One good solution is to assign multiple codes for each accepted connection but it causes two inevitable drawbacks: long handoff delay and new call setup delay due to high complexity of processing with multiple channelization codes, and high cost of using more number of rake combiners. Especially, long handoff delay may result in more call dropping probability and higher Grade of Service, which will degrade significantly the utilization and revenue of the 3G cellular systems. Therefore, we propose herein an adaptive efficient codes determination algorithm based on the Markov Decision Process analysis approach to reduce the waste rate and reassignments significantly while providing fast handoff. Numerical results demonstrate that the proposed approach yields several advantages, including the lowest GOS, the least waste rate, and the least number of reassignments. Meanwhile, the optimal number of rake combiners is also analyzed in this paper. This research was supported in part by the National Science Council of Taiwan, ROC, under contract NSC-93-2213-E-324-018.     

快速纳秒响应二代近贴聚焦像增强器的批量生产

叙述了二代近贴聚焦像增强器批量生产所用真空设备性能及特点，同时给出了管子工艺考核结果及管子纳秒时间响应特性。工艺考核结果表明，制管工艺可靠、性能稳定，管子批量生产合格率大于70％。     

基于模式理论光栅椭偏参数反演的数值模拟

将一种广泛用于求解系统优化问题的方法——正单纯形法，求解光栅的椭偏方程。首先，利用求解光栅的傅立叶模式理论对TE和TM波的复反射系数进行求解。然后计算出其相应的椭偏参数(△，Ψ)，并在该值的基础上加入不同偏差的随机高斯噪声，将加入噪声后的值(△m，Ψm)作为模拟测量值。最后使用优化算法进行反演。通过对几种常用面形光栅椭偏参数的数值模拟，一方面表明傅立叶模式理论计算光栅的椭偏参数不仅精度高。而且速度快；另一方面表明利用正单纯形法得到的光栅参数值很接近于正演时假设的参数值，从而从理论上证明了利用椭偏法测量光栅各种光学参数的可行性。     

The Two-Dimensional Clifford-Fourier Transform

Recently several generalizations to higher dimension of the Fourier transform using Clifford algebra have been introduced, including the Clifford-Fourier transform by the authors, defined as an operator exponential with a Clifford algebra-valued kernel. In this paper an overview is given of all these generalizations and an in depth study of the two-dimensional Clifford-Fourier transform of the authors is presented. In this special two-dimensional case a closed form for the integral kernel may be obtained, leading to further properties, both in the L ₁ and in the L ₂ context. Furthermore, based on this Clifford-Fourier transform Clifford-Gabor filters are introduced. AMS subject classification numbers: 42B10, 30G35 Fred Brackx received a diploma degree in mathematics from Ghent University, Belgium, in 1970 and a Ph.D. degree in mathematics from the same university in 1973. Since 1984 he is professor for mathematical analysis at Ghent University and currently he is leading the Clifford Research Group. His main interests are function theory and functional analysis for functions with values in quaternion and Clifford algebras. The research covers Clifford distributions, generalized Fourier, Radon and Hilbert transforms, orthogonal polynomials and multi-dimensional wavelets. Nele De Schepper received a diploma degree in mathematics from Ghent University, Belgium, in 2001. Since then she holds an assistantship at the Department of Mathematical Analysis of Ghent University and is a member of the Clifford Research Group. Her main interests are function theory and functional analysis for functions with values in Clifford algebras. The research covers generalized Fourier transforms, orthogonal polynomials and multi-dimensional wavelets. Frank Sommen received a diploma degree in mathematics from Ghent University, Belgium, in 1978, a Ph.D. degree in mathematics from the same university in 1980, and a habilitation degree in mathematical analysis in 1984. From 1978 until 1999 he was at the National Fund for Scientific Research (Flanders). Since 2000 he holds a Research professorship at Ghent University. His main interests are function theory and functional analysis for functions with values in quaternion and Clifford algebras. The research covers Clifford distributions, generalized Fourier, Radon and Hilbert transforms, orthogonal polynomials and multi-dimensional wavelets, algebraic analysis, hyperfunctions and radial algebra.     

电力系统谐波检测的现状与发展

准确、实时地对电力系统谐波进行检测有着重要的意义。本文根据电力系统谐波测量的基本方法，对近年来电力系统谐波检测的新方法进行了分析和评述。最后对电力系统的谐波测量进行了总结并提出了看法。     

Quasi-Chun-Ching Shih''''s Fractional Fourier Transform with Periodicity of 2,3 and M

Based on Chun-Ching Shih's idea, the basic transform was substituted and the quasi-ChunChing Shih's fractional Fourier transform with periodicity of 2, 3 and M was deduced. The two former transforms and the Chun-Ching Shih's fractional Fourier transform were only the particular cases of quasiChun-Ching Shih's fractional Fourier transform with periodicity of M.     

An automatic torque ripple compensation system for direct drive motors

A serious problem in motion control is the occurrence of torque ripple. Since a direct drive (DD) motor with a magnet rotor uses a rare-earth magnet, the torque ripple is more serious than that of conventional servomotors. This paper presents an auto-compensation of torque ripple using a software-implemented torque observer. The frequency and amplitude of torque ripple can be obtained in the controller by using the estimated torque from an observer, and the autonomous generation of a compensating current component for a torque ripple is possible. The proposed algorithm has been verified by experiments.     

Comments on the shortcomings of predicting the precision of Cavalieri volume estimates based upon assumed measurement functions

It is well known that the estimation of an object's volume by means of serial cross-sections, the so-called Cavalieri method, yields an unbiased estimate. But by itself it provides no means by which to estimate how precise this estimate is unless the shape of the volume is fully known beforehand. This knowledge can only be partially determined from the serial section information that is collected. Methods have been developed that claim to surmount this difficulty by using the serial section data to create a mathematical model of the volume's shape properties. The model then is used to estimate (predict) the precision of the volume estimate (its CE) from the single set of data available. Unfortunately, the theory underlying the model is flawed and so the model itself amounts to no more than an unsubstantiated guess about the shape of the volume. Therefore, the precision of the volume estimates that one obtains from the method is only as good as the model and this cannot be ascertained from the single set of acquired data. In this letter I explain the inadequacies of the modelling method. I suggest that it be used only with caution, if at all. Instead I suggest two alternative ways to predict the CE, one that is based upon a rule-of-thumb approach to the object's shape, and another that is based upon spectral analysis of the measurement function and that is easy to implement with available computer software.     

Wiener models of direction-dependent dynamic systems

Analysis of systems with direction-dependent dynamics is currently limited to cases in which the dynamics in the two directions of the output are first order; results for such systems have been published for both pseudo-random maximum-length binary (MLB) and inverse-repeat maximum-length binary (IR-MLB) inputs. These relatively limited analytical results make it useful to examine alternative ways of modelling such systems and in this paper, Wiener models are considered for this purpose. Methods for optimising the Wiener model parameters by matching the system and model cross-correlation functions, outputs, and discrete Fourier transforms of the outputs are considered, and the results are compared. These methods are also applied to a first-order direction-dependent system with a maximum-length ternary (MLT) input, for which no analytical results are currently available, and to a second-order system with an IR-MLB input.     

Modified Imidazoles: Degradation Inhibitors and Adhesion Promoters for Polyimide Films on Copper Substrates

Polyimide films on copper substrates that are exposed to elevated temperatures and an oxidizing environment will be subject to degradation. In order to halt this degradation without changing the properties of the system, a polymeric agent could be placed between the polyimide and the copper. This paper will investigate three such materials that will not only slow down the degradation of the polyimide and the oxidation of the copper, but will also improve adhesion within the system. Fourier transform infrared reflection-absorption spectroscopy (FTIR-RAS) will be used to investigate the polyimide/polymeric agent/copper system.