Chemical leaching and magnetic properties of non-equilibrium Al(Co–Cu) powders produced by rod milling

We report upon the chemical leaching and magnetic properties of nanoscale crystalline Al_0.6(Co₂₅Cu₇₅)_0.4 alloy powders produced by rod milling. X-Ray diffractometry (XRD), transmission electron microscopy, differential scanning calorimetry, vibrating sample magnetometry, and superconducting quantum interference device magnetometry were used to characterize the as-milled and leached specimens. After 400 h of milling, only the b.c.c. phase of the intermetallic compound γ-Al_3.892Cu_6.10808 was detected by XRD. After annealing the leached specimen at 600 °C for 1 h, the nanoscale crystalline phase was transformed into the f.c.c. Cu phase, and this was accompanied by a change in the magnetic properties. The peaks of the magnetization shifted towards lower temperature with increasing external field. The temperature behavior at T_f (45 K) for direct current (d.c.) magnetic susceptibility measurements was quite different for field cooling and zero-field cooling. After cooling the leached specimen from 800 °C, magnetization increased gradually.     

改善磁盘阵列性能的方法

磁盘阵列是解决计算机Ｉ／Ｏ瓶颈问题的有效方法之一，通过对现有磁盘阵列结构的研究，提出了４种改善磁盘阵列性能的方法，即良分利用磁盘带宽，平衡多盘的负载，减少奇偶检验数据存取时间和磁盘阵列Ｃａｃｈｅ技术等，分析结果表明：在事务处理应用领域，利用Ｃａｃｈｅ来把小写转化为大写可大大改善目前一般情况下，以一道数据大小来作为磁盘的基本存取大小是合适的选择，磁盘阵列负载平衡设计不足是指正常模式下系统请求在多盘间     

Imaging the domain pattern of the canted magnetization state in Co/Pt multilayer films

The exact magnetization pattern of magnetic films close to a spin-reorientation transition is difficult to analyze due to the intrinsically three-dimensional (3d) variation of the orientation of the local magnetization. We present a technique how this can be performed, based on the analysis of high quality 2d polarization maps from a single scanning electron microscope with polarization analysis (SEMPA) measurement with tilted sample. The key tool is the statistical distribution of all occurring polarization doublets, visualized in a 2d histogram plot. From the shape of the distribution the type of transition—canted-phase, or coexisting phases—can be inferred. For the canted-phase state, the canting angle can be accurately determined from geometrical considerations. With help of the histogram the image data can be analyzed and the three components of the magnetization can be calculated for most points of the image. For a Co/Pt multilayer film we found a cone state. The magnetization forms a complex pattern consisting of out-of-plane domains while the in-plane magnetization shows a maze pattern.     

Facile synthesis of nanocrystalline zinc ferrite via a self-propagating combustion method

Macroporous nanocrystalline zinc ferrite with single spinel-phase was prepared by a facile self-propagating combustion method using zinc nitrate, iron nitrate and glycine. The as-prepared ZnFe₂O₄ were characterized by X-ray diffraction (XRD) analysis, N₂ adsorption, scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), selected area electron diffraction (SAED) and energy dispersive X-ray spectrum (EDS). The magnetic properties of the prepared ZnFe₂O₄ were also studied.     

汽轮机轴承烧瓦与轴颈的渗巴氏合金现象

简述轴承工作性质，巴氏合金应用与相组成的基本情况。论述汽轮机转子在两个电厂长期运行后，由于轴颈发生的不正常摩擦损伤，在大修改造中由无损检查、机械加工揭示出轴颈存在严重的渗巴氏合金现象，低熔点金属Sn、Sb与Cu向转子材料晶界的深层渗入最终导致了3根大型在投转子的严重开裂与报废。图11表2     

极尖断面为折线的四极透镜磁性能研究

对传统双曲线极尖的四极透镜进行了磁性能分析。在此基础上，提出了极尖断面为折线的四极透镜结构。磁场的数值分析以及测量结果表明：该结构产生的场梯度均匀，且具有磁场集中、磁场梯度高、便于加工和安装的对称性控制等优点。该结构的四极透镜已用于ＣＹＣＩＡＥ－３０回旋加速器和ＨＩ－１３串列加速器束流输运线之中     

Crystal orientation of β-phase isotactic polypropylene induced by magnetic orientation of N,N′-dicyclohexyl-2,6-naphthalenedicarboxamide

Melt crystallization of isotactic polypropylene (iPP), containing crystallites of N,N′-dicyclohexyl-2,6-naphthalenedicarboxamide (DCNDCA) as a nucleating agent of the the β-phase iPP crystal, is carried out under a magnetic field (6 T) to obtain the alignment of the iPP crystal induced by magnetic alignment of DCNDCA. In a previous paper, DCNDCA was reported to undergo magnetic alignment in a liquid suspension. The obtained iPP sample exhibits alignment of the β-phase crystal with the c-axis aligned perpendicular to the magnetic field. The comparison of this alignment of iPP with the reported magnetic alignment of DCNDCA indicates that the β-phase crystal grows epitaxially on the DCNDCA crystal. The (330)_β plane of the iPP crystal lies on the bc-plane of the DCNDCA crystal in which the direction of the c-axis of the iPP coincides with the direction of the b-axis of the DCNDCA crystal.     

Continuous Separation of Inclusions from Aluminum Melt Flowing in a Circular Pipe using a High Frequency Magnetic Field

The continuous separation of inclusions from aluminum melt flowing in a circular pipe using a high frequency magneticfield was investigated both theoretically and experimentally The separation efficiency was calculated based on thetrajectory method and compared with experimental results. It is found that the separation efficiency is a functilnondimensional parameters t_i·d_p~2B_e~2/μ_fμ_eα~2 and α/δ.The effective way to improve the separation efficiency is to increasethe effective magnetic flux density and decrease the pipe radius. and the value of α/δ should be kept about 2 in orderto obtain the optimum separation efficiency.     

Magnetic separations in biotechnology—a review

Magnetic separation technology has a broad range of potential applications in both small and large scale biotechnology. This review considers a selection of magnetic techniques and their possible uses.