钛铜复合棒及其标准化

概述了钛铜复合棒研制开发及发展历程,并介绍了钛铜复合棒的主要性能,以及钛铜复合棒的标准化情况。     

从铅阳极泥处理后的渣料中综合回收有价金属的生产实践

叙述了从铅阳极泥回收金银后的渣料中综合回收有价金属的生产实践。根据渣料性质，将火法和湿法工艺相互结合，使渣料中的锑、铋、金、银、铅、铜得以较彻底的分离和回收。     

Highly active lanthanum doped nickel anode for solid oxide fuel cells directly fuelled with methane

Lanthanum doped nickel and YSZ composite anode (LaNi–YSZ) exhibited a greatly reduced polarization resistance and high performance for electrochemical oxidation of hydrogen and methane, which resulted from a fine anode structure with a high dispersion of nickel catalyst and a high catalytic activity towards methane.     

胜利油田污水储罐腐蚀防护方法评价

对胜利油田纯粱采油厂A3钢制生产污水（水温约60℃）储罐使用寿命过低的原因进行了实验考察。水质分析数据表明氯离子浓度高（45-48gm）是污水腐蚀性强的主要因素。A3钢在60℃污水中的腐蚀速率，由极化曲线数据计算的值大大高于失重法测定值，敞开系统中失重法测定值又高于密闭系统中测定值，挂片上出现蚀孔，说明储罐中A3钢发生了氧存在下氟离子引起的局部腐蚀（孔蚀）。元素分析结果表明．储罐阴极保护所用的牺牲阳极铝材含铁等元素量超标。牺牲阳极密封不良，在实验污水中7天后电流效率仅为2．92％，失去阴极保护能力。处于实验污水环境中的有涂层保护的A3钢．14天后出现腐蚀极化电流，表明涂层已失去完整性。要提高该采油厂及胜利油田其他采油厂污水储罐的使用寿命，必须改用合格的牺牲阳极和保护涂层材料。图3表2参7。     

Anodic oxidation of mecoprop herbicide at lead dioxide

The electrochemical oxidation of an aqueous solution containing mecoprop (2-(2-methyl-4-chlorophenoxy)propionic acid) has been studied at PbO₂ anodes by cyclic voltammetry and bulk electrolysis. The influence of current density, hydrodynamic conditions, temperature and pH on the degradation rate and current efficiency is reported. The results obtained show that the use of PbO₂ leads to total mineralization of mecoprop due to the production of oxidant hydroxyl radical electrogenerated from water discharge. The current efficiency for the electro-oxidation of mecoprop is enhanced by low current density, high recycle flow-rates and high temperature. In contrast, the pH effect was not significant. It has also been observed that mecoprop decay kinetics follows a pseudo-first-order reaction and the rate constant increases with rising current density.     

Mechanistic investigation into the electrolytic formation of iron from iron(III) oxide in molten sodium hydroxide

Iron(III) oxide tablets were electrolytically reduced to iron in molten sodium hydroxide at 530 °C and recovered to produce iron with 2 wt.% oxygen suitable for re-melting. The cell was operated at 1.7 V and an inert nickel anode was used. The thermodynamics and mechanism of the process was also investigated. By controlling the activity of sodium oxide in the melt, the cell could be operated below the decomposition voltage of the electrolyte with the net sequence of events being the ionization of oxygen, its subsequent transport to the anode and discharge leaving behind iron at the cathode. A reduction time of 1 h was achieved for a 1 g oxide tablet (close to the theoretical reduction time predicted by Faraday’s laws) at a current density of 520 mA cm⁻² with iron phase yields of ∼90 wt.%. The energy consumption was 2.8 kWh kg⁻¹.     

从铅阳极泥中回收铋的火法工艺实践

主要论述了从铅阳极泥中回收铋的全火法工艺流程改造与实践，并取得了预期的效果。     

高温合金材料在铝电解工业中的应用探讨

对高温合金在铝电解工业用作惰性金属阳极材料的选择进行阐述，并就实际应用过程中的抗氧化耐腐蚀性进行探讨；阐述适用于铝电解工业的惰性阳极合金所应具备的必要条件和必须解决的问题，并介绍目前有关的研究动态和研究方向。     

含RE铝阳极中析出相的电化学行为研究

用电子探针和能谱分析技术，观察了Al-5Zn-0．05In-0．1Sn-1Mg-0．3RE阳极中主要析出相的成分，并熔炼了析出相合金．电位测量和腐蚀后铝阳极表面的电子探针面扫描分析表明：富Sn相为阳极相，富Fe相、富RE相为阴极相；Fe相是铝阳极自腐蚀微电池中的主要阴极相，温度对析出相的电化学行为有影响．     

提高海水温度对锌合金和铝合金牺牲阳极电化学性能的影响

研究了提高海水温度对锌合金和铝合金牺牲阳极电化学性能的影响。结果表明，锌合金和铝合金牺牲阳级的电化学性能都随着海水温度的提高而变劣；凡是发生晶间腐蚀的合金，其晶间腐蚀程度都随着海水温度的提高而加剧。低含铝量的锌－铝－镉合金阳极在７０℃海水介质中，工作电位仍负于－１．０１０Ｖ，电流效率＞８０％，阳极工作表面溶解均匀，且不产生晶间腐蚀。