An iterative method for suboptimal control of linear time-delayed systems

This article presents a new approach for solving the Optimal Control Problem (OCP) of linear time-delay systems with a quadratic cost functional. The proposed method can also be used for designing optimal control time-delay systems with disturbance. In this study, the Variational Iteration Method (VIM) is employed to convert the original Time-Delay Optimal Control Problem (TDOCP) into a sequence of nonhomogeneous linear two-point boundary value problems (TPBVPs). The optimal control law obtained consists of an accurate linear feedback term and a nonlinear compensation term which is the limit of an adjoint vector sequence. The feedback term is determined by solving Riccati matrix differential equation. By using the finite-step iteration of a nonlinear compensation sequence, we can obtain a suboptimal control law. Finally, Illustrative examples are included to demonstrate the validity and applicability of the technique.     

Synchronous Full-Scan for Asynchronous Handshake Circuits

Handshake circuits form a special class of asynchronous circuits that has enabled the industrial exploitation of the asynchronous potential such as low power, low electromagnetic emission, and increased cryptographic security. In this paper we present a test solution for handshake circuits that brings synchronous test-quality to asynchronous circuits. We add a synchronous mode of operation to handshake circuits that allows full controllability and observability during test. This technique is demonstrated on some industrial examples and gives over 99% stuck-at fault coverage, using test-pattern generators developed for synchronous circuits. The paper describes how such a full-scan mode can be achieved, including an approach to minimize the number of dummy latches in case latches are used in the data path of the handshake circuit.     

浅析异步电机电子软起动器的现状和展望

本文在分析异步电机电子软起动器的现状和展望的基础上，以一个当前正在设计完善的电子软起动器为例，基本说明新型电子软起动器的特点和结构功能。     

应用金属迭片挠性联轴器改造D1000-32型风机

使用液力偶合器因故障频繁，对高炉稳产、高产造成严重威胁，而且维修费用较高，对偶合器改造后，应用金属迭片挠性联轴器其故障率、维修费用都很低。     

MC-CDMA系统迭代检测中的一种信道估计算法

在DS—CDMA系统中，联合译码的迭代多用户检测是克服多址干扰增加系统容量的有效方法。本文将多用户检测和译码相结合的迭代检测技术应用于MC—CDMA系统，其中，多用户检测器由串行干扰消除和其后的MMSE滤波器组成。文中提出一种时域信道估计作为迭代初始值的频域信道估计算法，比单纯的频域信道估计方法节约导频符号数量，并且由于信道估计性能的改善，加快了迭代检测的收敛速度。     

改进异步电机直接转矩控制系统的仿真研究

本文介绍了直接转矩控制系统的控制原理,并针对基于直接转矩控制的异步电动机运行时存在较大的电流及转矩脉动问题,提出一种新的控制方案,并基于Matlab 6.5对这种新方法进行仿真,仿真结果表明该方案能有效的解决电流及转矩脉动的问题.     

就地补偿在动力厂水泵电机上的应用实例

就我公司动力厂给水车间155kW水泵电机无功就地补偿的可行性及经济效益进行了分析和研究，对工厂用电如何节能降耗有一定的参考价值。     

求非线性方程近似解的逐次迭代法

本文提出了求解非线性问题的一种新方法——逐次迭代法，本方法先是给出一个初始近似解，然后将这个近似解进行校正迭代，使之接近于真实解，把一个非线性问题转化为一个线性问题来解决。     

A feasibility study of a direct-mapping parallel processing method to solve linear equations in load-flow calculation

With the growing size and complexity of power systems, system analysis—such as transients calculation—takes much time. Hence, fast calculation methods are required. Although parallel processing is a hopeful method, there have been difficulties in the parallel solution of linear equations which appear in power-flow calculations by the Newton-Raphson method. This paper aims at the fast calculation of the power-flow problem by means of parallel processing. In order to improve the suitability to the parallel solution of the differential equation in transients calculation, we assume the use of a direct-mapping parallel processing machine to map directly the network of a power system onto a network of processors. Under this assumption, we propose a new parallel-processing-oriented method in which the linear equation is solved by linear iterations between nodes with Aitken acceleration. We simulate the method on three model power systems and compare this Parallel Iterative Method (PIN) with a Parallel Direct Method (PDM) which uses the banded matrix according to the number of operations required. As a result, we can expect that PIM may solve linear equations faster than PDM with m processors, although the PIM might be inferior to the PDM with m × m processors, where m denotes the half-band width of the banded matrix.     

一种考虑不同期合闸的行波合闸保护新方法

当线路末端故障时，行波在线路末端的反射情况比较复杂，反向电流行波的极性有可能与正向电流行波的极性相反，而此时测距结果又与线路无故障时相同。因此，会造成行波测距式与行波极性比较式合闸保护的不正确动作。根据行波的折、反射理论，分析出当线路无故障时正向电流行波仅在线路末端发生反射，且电流行波的反射系数为-1，而当线路存在故障时，正向电流行波将在故障点发生反射，无论故障是否在线路末端，电流行波的反射系数都不会是-1。根据这一特征，提出了一种新的行波合闸保护方法。从原理上保证了在各种情况下保护都可以正确动作，大量的电磁暂态仿真结果也证明了这一点。