New nanocomposite based on poly(lactic-co-glycolic acid) copolymer and magnetite. Synthesis and characterization

The study presents the preparation of the new magnetic nanocomposite based on PLGA and magnetite. The PLGA used to obtain the magnetic nanocomposites was synthesized by the copolymerization of lactic acid with glycolic acid, in the presence of tin octanoate [Sn(Oct)₂] as catalyst, by polycondensation procedure. Magnetite was obtained by co-precipitation from aqueous salt solutions FeCl₂/FeCl₃. The particles size of magnetite was 420 nm, and the saturation magnetization 62.78 emu/g, while the PLGA/magnetite nanocomposite size was 864 nm and the saturation magnetization 39.44 emu/g. The magnetic nanocomposites were characterized by FT-IR, DLS technique, SEM, VSM and simultaneous thermal analyses (TG–FTIR–MS). The polymer matrix PLGA acts as a shell and carrier for the active component, while magnetite is the component which makes targeting possible by external magnetic field manipulation. Based on the gases resulted by thermal degradation of PLGA copolymer, using the simultaneous analysis TG–FTIR–MS, a possible degradation mechanism was proposed.     

Fenton试剂降低采油污水CODCr的研究与应用

针对辽河油区超稠油采油污水的特点，采用Fenton试剂催化氧化，对采油污水处理进行研究。实验研究及现场应用结果表明，此方法对污水的CODCr具有良好的去除效果。处理后污水经过简单生化，进一步降解污染物，能够实现稳定迭标排放，且具有能耗低、运行成本低和操作简单等特点。     

Recovery of fluorocarbons in Japan as a measure for abating global warming

The objective of this study is to evaluate the potential for recovering fluorocarbons as measures for the abatement of global warming. In this study, we focused on the three different kinds of fluorocarbons: CFCs, HCFCs and HFCs, and targeted refrigerant use because of the availability of relevant data. We first estimated future fluorocarbon emissions from the targeted appliances; we next compared those emissions in the units of CO₂ equivalent to the level of CO₂ emissions in 1990 from a quantitative point of view. As the result of this study, it was found that fluorocarbon emissions in 1999 and 2010 would be equal to approximately 7 and 3% of the level of CO₂ emissions in 1990 respectively. Moreover, if we implement a 100% recovery rate in every recovery route, we can reduce a large amount of emissions which correspond to approximately 2–5% of the level of CO₂ emissions in 1990, even if we take into account the energy-related CO₂ emissions by the transportation and decomposition of fluorocarbons.     

探讨电石法PVC烟气治理方法

分析了电石法PVC生产链中电石炉烟气及电厂烟气二氧化硫的排放情况,指出利用电石炉烟气中的CO合成氨、再将合成氨用于燃煤电厂烟气的"氨法"脱硫是具有较大应用潜力的循环经济产业链。     

Time Characterization of High Density Gas Jet from a Pulsed Supersonic Nozzle via Laser Produced Plasma

A high-density gas jet supersonic nozzle is reported in this paper. The jitter and actuation time of the nozzle is determined by the pin discharge and laser spark radiation respectively. The jitter time of the nozzle is within 10μs with the backing pressure as high as 25 bar. With a nanosecond laser pulse focused on the gas jet about 1 mm below the nozzle, the actuation time is calculated to be about 15 ms by detecting the laser produced spark radiation, which reveals the existence of the gas jet and the relative gas density evolving with time. Consequently the gas density is estimated to be well above 10^19 cm^-3, compared with theoretical simulations from the nozzle parameters.     

我国车用汽油的发展概况及发展方向探讨

介绍了我国车用汽油的发展轨迹 ,通过与国外先进标准的对比分析了我国车用汽油存在的不足 .指出我国在加入WTO后 ,更应不断升级车用汽油质量标准 ,需要从标准制定、炼油技术等多方面追赶世界先进水平 ,积极研制生产清洁型无污染汽油 ,从根本上消除汽车尾气对环境的污染 .     

Granular gases in mechanical engineering: on the origin of heterogeneous ultrasonic shot peening

The behavior of an ultrasonic shot peening process is observed and analyzed by using a model of inelastic hard spheres in a gravitational field that are fluidized by a vibrating bottom wall (sonotrode) in a cylindrical chamber. A marked heterogeneous distribution of impacts appears when the collision between the shot and the side wall becomes inelastic with constant dissipation. This effect is one order of magnitude larger than the simple heterogeneity arising from boundary collision on the cylinder. Variable restitution coefficients bring the simulation closer to the general observation and allow the investigation of peening regimes with changing shot density. We compute within this model other physical quantities (impact velocities, impact angle, temperature and density profile) that are influenced by the number N of spheres.     

电离气体选择性激发产生变色发光的研究

本文综述我们对电脑气体选择性激发产生变色发光的理论研究和实验研究，并探讨这种类型变色发光的实际应用。     

Long-term measurements of the concentrations of halocarbons in an urban area of Kraków, Poland

The results of the measurements of the concentrations of freons (F-11 and F-113), chloroform (CHCl₃), trichloroethane (CH₃CCl₃) and carbon tetrachloride (CCl₄) in air are presented. The data concern concentration measurements that have been conducted in Krakow since half way through 1997 to the end of 1999. The mean monthly values of these concentrations have been compared with the data from Mace Head, the station situated at a similar longitude as Krakow. It has been concluded that, in the observed period of time, the concentrations of the pollutants in Krakow are higher than in Mace Head. The mean monthly concentrations of F-11 and CCl₄ decrease in Krakow faster than in Mace Head (2.5 and 3.3 times, respectively). The concentrations of CHCl₃ and CH₃CCl₃ decrease at both locations, but the change is greater in Krakow. In Krakow, the observed increase of F-113 is 0.13 ppt/month and has an opposite trend than in the same period at Mace Head.     

Predictive modeling of mercury speciation in combustion flue gases using GMDH-based abductive networks

Modeling mercury speciation is an important requirement for estimating harmful emissions from coal-fired power plants and developing strategies to reduce them. First-principle models based on chemical, kinetic, and thermodynamic aspects exist, but these are complex and difficult to develop. The use of modern data-based machine learning techniques has been recently introduced, including neural networks. Here we propose an alternative approach using abductive networks based on the group method of data handling (GMDH) algorithm, with the advantages of simplified and more automated model synthesis, automatic selection of significant inputs, and more transparent input–output model relationships. Models were developed for predicting three types of mercury speciation (elemental, oxidized, and particulate) using a small dataset containing six inputs parameters on the composition of the coal used and boiler operating conditions. Prediction performance compares favourably with neural network models developed using the same dataset, with correlation coefficients as high as 0.97 for training data. Network committees (ensembles) are proposed as a means of improving prediction accuracy, and suggestions are made for future work to further improve performance.