A design of experiments investigation into dry separation using a Knelson Concentrator

Enhanced gravity, or centrifugal, separators have revolutionised gold processing over the past decades, significantly increasing the recovery of fine (−100 μm) free gold. One of the main drawbacks of centrifugal gravity concentrators is the large volume of water required (even if it is all recycled). With water becoming an ever increasingly important “commodity”, reducing this is of importance both from an environmental and a monetary point of view. This work investigated operating a laboratory scale Knelson Concentrator with a dry feed and using air as the fluidising medium. The feed used was a synthetic mixture of tungsten and quartz, used to mimic a gold ore. The response surface method and central composite design techniques were used to design the experiments and to model the results, with the experimental variables being the bowl speed (G-Level), air fluidising pressure and the feed rate. The models corresponded well to the experimental results, indicating that for this experimental setup, the optimal conditions were a bowl G-Level of 40 G, a feed rate of 220 g/min and an air fluidising pressure of 8 psi.     

牛头山水电站混凝土双曲拱坝设计和水库提前蓄水研究

牛头山水电站大坝为抛物线形混凝土双曲拱坝,最大坝高108.0 m,采用坝顶5孔开敞式溢洪道泄洪,挑流消能。为提前发挥水电站效益,在拱坝尚未完全封拱的情况下,通过计算分析,得出了水库可以下闸蓄水的结论。     

Signal Integrity: Fault Modeling and Testing in High-Speed SoCs

As we approach 100 nm technology the interconnect issues are becoming one of the main concerns in the testing of gigahertz system-on-chips. Voltage distortion (noise) and delay violations (skew) contribute to the signal integrity loss and ultimately functional error, performance degradation and reliability problems. In this paper, we first define a model for integrity faults on the high-speed interconnects. Then, we present a BIST-based test methodology that includes two special cells to detect and measure noise and skew occurring on the interconnects of the gigahertz system-on-chips. Using an inexpensive test architecture the integrity information accumulated by these special cells can be scanned out for final test and reliability analysis.     

沙牌RCC拱坝坝肩稳定三维地质模型试验研究

通过三维地质力学模型试验，研究了沙牌RCC拱坝坝体和坝肩的变形规律、破坏机理，综合评价了坝肩的超载安全度，为工程设计提供依据。     

隔河岩重力拱坝拱座深层处理平面有限元分析

清江隔河岩重力拱坝坝基地质条件复杂，软弱夹层，断裂构造多，岩溶发育，两岸拱座存在局部滑动问题。     

Gravity pipe flow of polymeric bulk solids in pneumatic conveying system

Various physical parameters of gravity pipes such as gravity pipe diameter, the inclination of the gravity pipe, the cone angle, temperature of the discharged material and the rate of air counter flow into the gravity pipe were studied. The results obtained from the pipe diameter and cone angle experiments showed that the mass flow rate was proportional to (D-1.4d)^2.5 and also to θ^-0.5. The results from the pipe inclination experiment showed the existence of an angle of inclination for maximum flow, which was also reported by Wieghardt [Uber einige versuche an stromungen in sand. Ingenieur Archived 20, 109-115]. The air flow experiment also showed that the mass flow rate was inversely proportional to the air counter-flow rate, and strongly influenced by the material properties. Results from the temperature experiment showed that the temperature of the material had slight effect on the mass flow rate for the temperature range that was used in the experiment. Flow visualization images showed formation of solid plugs in the pipe that played a part in influencing the behaviour and mass flow rate of solids in the system.     

公路桥涵台背设计的理论方法探讨

介绍了近年来国内外研究人员对桥涵台背的设计研究方法，结合桥涵与台背结构组合的设计原则，从搭板的型式、坡度、长度、厚度、配筋等方面提出了搭板设计的方法。     

Bilateral polynomial matrix equations in two indeterminates

Two special cases of the bilateral 2-D polynomial matrix equationDU +VN=C whenC=I andC=I with being a -stable 2-D polynomial, which are related respectively to deadbeat and asymptotic control problems of 2-D systems, are first considered. By generalizing the concepts of factor coprimeness, zero coprimeness and zero skew primeness in the 2-D polynomial ring to the ring of causal -stable 2-D rational functions, a constructive solution of these two problems mentioned is proposed. Based on these results, we derive a solvability condition for the bilateral equiation whereC is a general 2-D polynomial matrix. The general solutions are investigated as well.     

Toward A Mechanistic Understanding of Re-Infiltration in Naturally Fractured Reservoirs with Surfactant-Aided Gravity Drainage Process

Surfactant-aided gravity drainage is an improved oil recovery technique for water-invaded zone in fractured carbonate reservoirs, which are mostly oil-wet or mixed-wet rocks. The re-infiltration mechanism in water-invaded zone has a considerable effect on oil vertical movement in gravity drainage processes. In this work, a mechanistic understanding of re-infiltration in surfactant-aided gravity drainage, in comparison to oil–water gravity drainage is presented using an experimentally and numerically validated model. A column model is constructed from three matrix blocks. These blocks are separated from each other by horizontal fractures. A storage tank is considered on top of the model to store depleted oil from matrix blocks. The stacked-blocks model for re-infiltration is validated and verified to simulate water and chemical flooding using a mesh independency study and experimental flooding data in a composite core experiment. Using this model, several analyses are performed to investigate effects of rock and fluid properties, rock saturation functions, wettability alteration, surfactant adsorption, and capillary continuity on re-infiltration.     

机械振动对Sn-Sb合金β相的影响

初步探讨了机械振动对Sn-Sb合金β相在基体中分布的影响,重点讨论了在不同振击力作用下对Sn-Sb11合金中β相(SnSb)偏析和细化的影响效果.试验表明,在不同振击力作用下,合金晶粒以及组织明显得到改善,而且随着振击力的增大,组织均匀化程度的改善效果呈明显上升趋势.分析结果表明,这是由于强烈的振动对金属液体的搅拌以及促使合金液晶粒(或晶团)的游离作用的缘故.