HCMOS器件γ辐射损伤电路分析

本文对最基本的HCMOS器件(反相器和与非门)作了γ辐射损伤实验。通过器件性能变化,分析了γ辐射对电路的作用。     

Effect of pretreatments and freezing rate on the firmness of potato tissue after a freeze–thaw cycle

The texture of potato tissue after a freeze–thaw process using different freezing rates and different pretreatments was analysed, in order to select the best strategy for optimum preservation of the textural characteristics of pre‐frozen potato. Ten blanching conditions were tested and a two‐step blanching process with calcium chloride (0.07 g mL^?1) proved the most effective in protecting the tissue after a freeze–thaw process (maximum load force around 10–55% of the raw tissue, depending on potato batch, for air‐blast freezing and 20–60% for immersion freezing). Vacuum impregnation at 100 and 400 mbar, even when followed by different pre‐drying treatments to remove excess water, was very detrimental to resistance to a freeze–thaw process (maximum load force below 10% of the raw tissue for air‐blast freezing and below 20% for immersion freezing). Microstructure analysis confirmed better tissue integrity retention with ethyleneglycol immersion freezing instead of air‐freezing. Differences were found between batches with a 6‐month difference in storage time, indicating that the fresher batch was more suitable for freezing.     

UO_2(HCOO)_2·H_2O在290K-10K的红外光谱及~(235)U-~(238)U同位素位移的研究

本文通过测定甲酸铀酰[UO_2(HCOO)_2·H_2O]在290K-10K的红外光谱,确定了该化合物铀酰基团(O-U-O)v_(as)振动峰位,研究了温度对峰宽、峰位的影响,并采用差减及峰内标法估算了甲酸铀酰在290K-10K的同位素位移值。测得290K,77K及10K时~(238)U的v_(as)值分别为931.90cm~(-1),930.82cm~(-1)和930.74cm~(-1),~(235)U-~(238)U同位素位移△v分别为0.63cm~(-1),0.67±0.18cm~(-1)和0.71±0.21cm~(-1),位移值与理论计算值接近。     

Electrocopolymerization of aniline and ortho-phenylenediamine via facile negative shift of polyaniline redox peaks

Oxidative electropolymerization of aniline (Ani) in phosphoric acid (H₃PO₄) on composite 2B pencil graphite was accomplished using selected inorganic salts as supporting electrolytes. These salts determined the degree of conductivity of polyaniline (PAni) formed. The conductivity was in the order of CaCl₂ > KCl > ZnCl₂ > ZnSO₄ > Ca₃(PO₄)₂. The three pairs of redox peaks in the voltammogram of PAni formed in the presence of 0.06 M Ca₃(PO₄)₂ and 0.2 M ZnSO₄ have shifted 300 mV to the negative potential. The shifting of peaks is strongly influenced by type of anions' presence in the salts. However, the nature of the available cations had no significant effect. The negative shifts of redox peaks were exploited to facilitate the electrocopolymerization of Ani and ortho-phenylenediamine (oPD). The formation of the poly(Ani-co-oPD) was confirmed by the FTIR spectra.     

改良MEA脱碳技术在小氮厂变换气脱碳中的应用

介绍了改良MEA脱碳技术的基本原理、工艺特点以及在工业中的应用情况，实践表明，改良MEA提高了溶液的吸收能力，降低了再生热耗，解决了MEA易降解损耗等问题。     

Unified reliability estimation and management of NoC based chip multiprocessors

We present a new architecture level unified reliability evaluation methodology for chip multiprocessors (CMPs). The proposed reliability estimation (REST) is based on a Monte Carlo algorithm. What distinguishes REST from the previous work is that both the computational and communication components are considered in a unified manner to compute the reliability of the CMP. We utilize REST tool to develop a new dynamic reliability management (DRM) scheme to address time-dependent dielectric breakdown and negative-bias temperature instability aging mechanisms in network-on-chip (NoC) based CMPs. Designed as a control loop, the proposed DRM scheme uses an effective neural network based reliability estimation module. The neural-network predictor is trained using the REST tool. We investigate how system’s lifetime changes when the NoC as the communication unit of the CMP is considered or not during the reliability evaluation process and find that differences can be as high as 60%. Full-system based simulations using a customized GEM5 simulator show that reliability can be improved by up to 52% using the proposed DRM scheme in a best-effort scenario with 2–9% performance penalty (using a user set target lifetime of 7 years) over the case when no DRM is employed.     

宽温耐硫变换催化剂制备工艺研究

利用催化剂活性评价、催化剂活性组分含量测定、Ｘ—光衍射等手段，研究了共浸法制备宽温耐硫变换催化剂制备工艺过程中载体氧化铝的吸水率、浸渍条件、煅烧温度等对催化剂性能的影响。     

M序列的对称性变换及对称群

n级M序列是由n级非线性回馈移位寄存器产生的周期为2n的二元序列,也称为de Bruijn序列。该文将讨论M序列的对称性变换,提出了一类新的对称性变换——"与/或"逻辑对称性变换,并研究了基于对称性变换的对称群。     

紫外分光光度法测定双酚 AF

碱性条件下,双酚 AF 紫外光谱的吸收峰会发生红移,从225 nm 移至248 nm,据此建立了简单、灵敏、快捷、选择性较好的测定双酚 AF 可见分光光度法,并研究了氨水用量、反应时间、反应温度对吸光度的影响。结果表明：双酚 AF 的最大吸收波长为248 nm,线性范围是0.6～7．2 mg／L,相关系数 r 为0.9998,为检测食品塑料包装中双酚 AF 的残留提供了新的实验方法。