全文获取类型
收费全文 | 52891篇 |
免费 | 5687篇 |
国内免费 | 4092篇 |
专业分类
电工技术 | 7048篇 |
综合类 | 5281篇 |
化学工业 | 7833篇 |
金属工艺 | 2211篇 |
机械仪表 | 1930篇 |
建筑科学 | 5840篇 |
矿业工程 | 2654篇 |
能源动力 | 1691篇 |
轻工业 | 5669篇 |
水利工程 | 2809篇 |
石油天然气 | 2427篇 |
武器工业 | 419篇 |
无线电 | 2872篇 |
一般工业技术 | 4644篇 |
冶金工业 | 1488篇 |
原子能技术 | 758篇 |
自动化技术 | 7096篇 |
出版年
2024年 | 313篇 |
2023年 | 1015篇 |
2022年 | 1440篇 |
2021年 | 1785篇 |
2020年 | 1954篇 |
2019年 | 1835篇 |
2018年 | 1700篇 |
2017年 | 1917篇 |
2016年 | 2115篇 |
2015年 | 2194篇 |
2014年 | 3150篇 |
2013年 | 3537篇 |
2012年 | 3740篇 |
2011年 | 3984篇 |
2010年 | 2926篇 |
2009年 | 3211篇 |
2008年 | 2951篇 |
2007年 | 3380篇 |
2006年 | 3053篇 |
2005年 | 2597篇 |
2004年 | 2221篇 |
2003年 | 1841篇 |
2002年 | 1524篇 |
2001年 | 1291篇 |
2000年 | 1171篇 |
1999年 | 1058篇 |
1998年 | 833篇 |
1997年 | 727篇 |
1996年 | 606篇 |
1995年 | 503篇 |
1994年 | 433篇 |
1993年 | 370篇 |
1992年 | 336篇 |
1991年 | 211篇 |
1990年 | 141篇 |
1989年 | 129篇 |
1988年 | 88篇 |
1987年 | 67篇 |
1986年 | 47篇 |
1985年 | 31篇 |
1984年 | 51篇 |
1983年 | 38篇 |
1982年 | 39篇 |
1981年 | 14篇 |
1980年 | 21篇 |
1979年 | 20篇 |
1978年 | 11篇 |
1977年 | 7篇 |
1955年 | 4篇 |
1951年 | 11篇 |
排序方式: 共有10000条查询结果,搜索用时 0 毫秒
1.
Nazir Kizzie‐Hayford Doris Jaros Yvonne Schneider Harald Rohm 《International Journal of Food Science & Technology》2015,50(2):381-388
A standard method for the extraction of tiger nut milk has been introduced. It has been shown that, although milling duration improves the yield of tiger nut milk solids and its nutrient composition, there is a quantifiable loss of nutrient in the pressing residue during milk extraction. Milling duration improved the colloidal stability of the milk against creaming during 16 h of storage. A higher milling intensity resulted in the aggregation of biological polymers which resulted in colloidal destabilisation. Milling improved the lightness and stability and reduced browning rate of the tiger nut milk during storage. This report is important for the production of tiger nut milk of consistent and comparable characteristics. Milling has been introduced as a processing method for the qualitative and quantitative modulation of the properties of tiger nut milk. It is recommended to develop further strategies to improve the colloidal stability of tiger nut milk as a beverage. 相似文献
2.
Goat milk has specific chemical composition and physical properties. The purpose of this study was to investigate the change of milk quality and emulsion stability during 60 d frozen storage. Milk sample was taken from three Ettawah Crossedbred goats that were divided into three groups. Samples were frozen and stored for 0, 30 and 60 days. At the end of each storage periode, milk sample was thawed in the refrigerator and analyzed for total number of bacteria, chemical (acidity, pH, free fatty acids), physical (alcohol test, clot on boiling test) quality, and emulsion stability. The microbiological and chemical data were analyzed statistically using one way ANOVA, whereas physical quality and emulsion stabilty were expressed qualitatively. There were no change in the total bacteria, acidity, pH and free fatty acid (FFA) of milk during storage, whereas the assessment by 70% alcohol showed positive since 0 d. Emulsions stability changed after 30 d of storage. While, the clot on boiling (COB) test of milk was positive at 60 d of storage. Recommendation is frozen storage of goat milk should not longer than 30 d. 相似文献
3.
Anis Zeglaoui Anouar Houmia Maher Mejai Radhouane Aloui 《International Journal of Adaptive Control and Signal Processing》2021,35(9):1842-1859
In compressive sampling theory, the least absolute shrinkage and selection operator (LASSO) is a representative problem. Nevertheless, the non-differentiable constraint impedes the use of Lagrange programming neural networks (LPNNs). We present in this article the -LPNN model, a novel algorithm that tackles the LASSO minimization together with the underlying theory support. First, we design a sequence of smooth constrained optimization problems, by introducing a convenient differentiable approximation to the non-differentiable -norm constraint. Next, we prove that the optimal solutions of the regularized intermediate problems converge to the optimal sparse signal for the LASSO. Then, for every regularized problem from the sequence, the -LPNN dynamic model is derived, and the asymptotic stability of its equilibrium state is established as well. Finally, numerical simulations are carried out to compare the performance of the proposed -LPNN algorithm with both the LASSO-LPNN model and a standard digital method. 相似文献
4.
Hashim A.
Hashim 《国际强度与非线性控制杂志
》2020,30(10):3848-3870
》2020,30(10):3848-3870
This paper introduces two novel nonlinear stochastic attitude estimators developed on the Special Orthogonal Group with the tracking error of the normalized Euclidean distance meeting predefined transient and steady‐state characteristics. The tracking error is confined to initially start within a predetermined large set such that the transient performance is guaranteed to obey dynamically reducing boundaries and decrease smoothly and asymptotically to the origin in probability from almost any initial condition. The proposed estimators produce accurate attitude estimates with remarkable convergence properties using measurements obtained from low‐cost inertial measurement units. The estimators proposed in continuous form are complemented by their discrete versions for the implementation purposes. The simulation results illustrate the effectiveness and robustness of the proposed estimators against uncertain measurements and large initialization error, whether in continuous or discrete form. 相似文献
5.
克拉玛依油田七区的标准测井资料是指使用标准电极系视电阻率测井、自然电位测井和井径测井,以相同的1:500深度比例尺及相同的横向比例进行测井作业所取得的资料.这种资料本来并不具备定量解释储层孔隙度和含油饱和度的能力,但这种资料占该区测井资料总量的比率高达34%.利用标准电极系视电阻率资料和岩心分析资料建立了视电阻率-岩性图版,利用自然电位减小系数α和岩心孔隙度分析资料φ建立了α-φ图版,根据综合测井资料求出标准测井视电阻率校正系数,进而确定了饱和度计算方程的参数.与相应的综合测井资料计算结果相对比,用该方法得到的孔隙度平均绝对误差及相对误差分别为1.85%和11.88%;含油饱和度平均绝对误差及相对误差分别为9.08%和24.75%.将该方法有选择地应用到该区砾岩储层精细描述研究中,弥补了缺乏综合测井资料无法进行测井储层评价及参数研究的缺陷. 相似文献
6.
吐哈油田部分区块地层压力系数小于0.9,常规水基压井液对储层伤害大,若使用油基压井液成本高,环境污染严重。通过实验优选出了一种低密度水基微泡沫压井液。该压井液具有密度低、泡沫强度高、稳定性好、携砂能力强等优点。现场应用表明,低密度微泡沫压井液稳定时间大于48 h,密度在0.70~0.99 g/cm3之间可调,抗油污染能力强,抗油大于8%,抗温在100℃以上,岩心污染后渗透率恢复值大于80%;并且施工方便,成本低,具有储层保护能力,使用微泡沫压井液的井表皮系数在0.20~2.34之间。 相似文献
7.
8.
The miscibility and phase behavior of ternary blends containing dimethylpolycarbonate (DMPC), tetramethylpolycarbonate (TMPC) and poly[styrene‐co‐(methyl methacrylate)] copolymer (SMMA) have been explored. Ternary blends containing polystyrene (PS) instead of SMMA were also examined. Blends of DMPC with SMMA copolymers (or PS) did not form miscible blends regardless of methyl methacrylate (MMA) content in copolymers. However, DMPC blends with SMMA (or PS) blends become miscible by adding TMPC. The miscible region of ternary blends is compared with the previously determined miscibility region of binary blends having the same chemical components and compositions. The region where the ternary blends are miscible is much narrower than that of binary blends. Based on lattice fluid theory, the observed phase behavior of ternary blends was analyzed. Even though the term representing the Gibbs free energy change of mixing for certain ternary blends had a negative value, blends were immiscible. It was revealed that a negative value of the Gibbs free energy change of mixing was not a sufficient condition for miscible ternary blends because of the asymmetry in the binary interactions involved in ternary blends. Copyright © 2004 Society of Chemical Industry 相似文献
9.
A series of new alternating aromatic poly(ester‐imide)s were prepared by the polycondensation of the preformed imide ring‐containing diacids, 2,2′‐bis(4‐trimellitimidophenoxy)biphenyl (2a) and 2,2′‐bis(4‐trimellitimidophenoxy)‐1,1′‐binaphthyl (2b) with various aromatic dihydroxy compounds in the presence of pyridine and lithium chloride. A model compound (3) was also prepared by the reaction of 2b with phenol, its synthesis permitting an optimization of polymerization conditions. Poly(ester‐imides) were fully characterized by FTIR, UV‐vis and NMR spectroscopy. Both biphenylene‐ and binaphthylene‐based poly(ester‐imide)s exhibited excellent solubility in common organic solvents such as tetrahydrofuran, m‐cresol, pyridine and dichloromethane. However, binaphthylene‐based poly(ester‐imide)s were more soluble than those of biphenylene‐based polymers in highly polar organic solvents, including N‐methyl‐2‐pyrrolidone, N,N‐dimethylacetamide, N,N‐dimethylformamide and dimethyl sulfoxide. From differential scanning calorimetry thermograms, the polymers showed glass‐transition temperatures between 261 and 315 °C. Thermal behaviour of the polymers obtained was characterized by thermogravimetric analysis, and the 10 % weight loss temperatures of the poly(ester‐imide)s was in the range 449–491 °C in nitrogen. Furthermore, crystallinity of the polymers was estimated by means of wide‐angle X‐ray diffraction. The resultant poly(ester‐imide)s exhibited nearly an amorphous nature, except poly(ester‐imide)s derived from hydroquinone and 4,4′‐dihydroxybiphenyl. In general, polymers containing binaphthyl units showed higher thermal stability but lower crystallinity than polymers containing biphenyl units. Copyright © 2005 Society of Chemical Industry 相似文献
10.
Starting from plysical laws a four-dimensional nonlinear model for mecano-hydraulic servomechanisms is deduced. The stability of its equilibria is analysed using a theorem of Lyapunov and Malkin to handle the critical case due to the presence of zero in the spectrum of the matrix of the linear part around equilibria. Stability diagrams are drawn and simulation results are presented through phase diagrams. 相似文献