Preparation and characterization of mullite whisker reinforced ceramics made from coal fly ash

Ceramics with mullite whiskers were prepared from coal fly ash and Al₂O₃ raw materials, with AlF₃ used as an additive. The phase structures and microstructures of the ceramics were identified via X-ray diffraction and scanning electron microscopy, respectively. The results show that pickling of coal fly ash is an effective method for enhancing the flexural strength of ceramics. Sintering temperature and AlF₃ addition were also key factors influencing the creation of ideal ceramics. The ceramic made from pickled coal fly ash, 6?wt% AlF₃, and sintered at 1200?°C, exhibited the highest flexural strength of 59.1?MPa, and had a bulk density of 1.32?g/cm³ and porosity of 26.8%. The results show that ceramic materials made under these conditions are ideal candidates for manufacturing ceramic proppants for the exploitation of unconventional oil and gas resources.     

Synthesis, Characterization, and Formation Process of Na-X Zeolite from Coal Fly Ash

Using the SiO₂ and Al₂O₃ components of the amorphous phase in coal fly ash (Fa), Fa was converted to Na-X zeolites in NaOH-NaAlO₂ solutions by stirring at 35°C for 72 hr and then aging at 85°C for a given period. The molar ratio SiO₂/Al₂O₃ of the starting materials was controlled from 2.0 to 13.2. The resulting materials were characterized by various means. Increasing the SiO₂/Al₂O₃ ratio of the starting material increased the degree of crystallinity of faujasite, exhibiting a maximum at SiO₂/Al₂O₃ = 8.0. The faujasite formed was identified as Na-X zeolite with Si/Al = 1.20. The amorphous phase in Fa was dissolved during the stirring to form a precursor of zeolite, such as amorphous aluminosilicate. The Na-X zeolite was formed by aging for 24 hr, and the degree of crystallinity of this material was increased with the increasing aging period. The cation exchange capacity and specific surface area were increased with the increasing degree of crystallinity of the Na-X zeolites.     

粉煤灰降失水水泥浆在天然气井固井中的研究与应用

长庆天然气田属于低压、低渗透气田,存在承压能力较低的地层,固井设计要求全井段封固,并且采用双级双凝施工工艺。但由于用于低密度水泥浆中的漂珠生产量降低,价格上升,研究应用替代产品是固井技术发展的方向。在一级领浆中研究应用了粉煤灰水泥浆体系,其性能和固井质量可完全满足固井要求。粉煤灰水泥浆体系价格低和固井质量优良,使其成为漂珠水泥浆体系的替代配方。     

Copper(II) removal from aqueous solutions by fly ash

The removal of Cu(II) by adsorption on fly ash has been found to be concentration, pH and temperature dependent. The kinetics of adsorption indicates the process to be diffusion controlled. The Langmuir constants have been calculated at different temperatures, and the adsorption has been found to be endothermic (ΔH = 15.652 kcal mol^?1). The maximum removal is observed at pH 8.0, and variation in adsorption with pH has been explained on the basis of surface ionisation and complexation.     

包钢粉煤灰的综合利用

叙述了国内粉煤灰的综合利用途径,介绍了包钢粉煤灰综合利用的现状以及适合包钢实际的利用途径,并提出了相应的综合利用对策.     

Characterization of sintered coal fly ashes

Çan, Çatala?z?, Seyitömer and Af?in-Elbistan thermal power plant fly ashes were used to investigate the sintering behavior of fly ashes. For this purpose, coal fly ash samples were sintered to form ceramic materials without the addition of any inorganic additives or organic binders. In sample preparation, 1.5 g of fly ash was mixed in a mortar with water. Fly ash samples were uniaxially pressed at 40 MPa to achieve a reasonable strength. The powder compacts were sintered in air. X-ray diffraction analysis revealed that quartz (SiO₂), mullite (Al₆Si₂O₁₃), anorthite (CaAl₂Si₂O₈), gehlenite (Ca₂Al₂SiO₇) and wollastonite (CaSiO₃) phases occurred in the sintered samples. Scanning electron microscopy investigations were conducted on the sintered coal fly ash samples to investigate the microstructural evolution of the samples. Different crystalline structures were observed in the sintered samples. The sintered samples were obtained having high density, low water adsorption and porosity values. Higher Al₂O₃ + SiO₂ contents caused to better properties in the sintered materials.     

粉煤灰少熟料水泥的研究

采用复合外加剂充分激发粉煤灰潜在活性，配制出早期强度较高的３２５＃少熟料水泥。本文介绍该水泥的配制原理与方法，分析了代替普通水泥配制建筑砂浆的可行性。     

Heat evolution of high-volume fly ash concrete

In this paper, the results of a laboratory investigation conducted with heat evolution of high-volume fly ash (HVFA) concrete are presented. Heat evolution of concrete was studied by measuring the temperature increase in concrete under adiabatic curing condition. Characteristic of heat evolution of fly ash concrete was found to be strongly dependent on the replacement level of fly ash and dosage of superplasticizer used to maintain workability. It was also found that using fly ash as cement replacement resulted in a reduction on the maximum temperature rise. Increasing the replacement level of fly ash caused lower temperature rise in concrete. Superplasticizer caused a delay in peak temperature rise time; this is taken as an indicator that high-dosage superplasticizer used in concrete caused retardation in hydration of cement. Concretes having similar ingredients showed similar peak temperature rise whether they are superplasticized or not.     

Influence of cage design on precision of tube-trap bioassay for attractants of the onion fly,Delia antiqua

Responses of onion flies,Delia antiqua, to known attractants were measured in the laboratory with a novel tube-trap bioassay. The relative numbers of flies caught in tube traps baited with enzymatic yeast hydrolysate, brewer's yeast, andn-dipropyl disulfide were similar to those obtained previously with cone traps in the field. Changing the shape of the bioassay cage from a cuboid to a cylinder decreased the experimental error obtained from analysis of variance, as did rotating the floor of the circular cage. This bioassay should be useful in evaluating attractants for other insects that orient along the substrate.Diptera: Anthomyiidae.Paper No. 11327 of the Michigan State University Agricultural Experiment Station. Received for publication June 8, 1984.     

降低锅炉飞灰可燃物的途径

介绍在发电厂锅炉运行过程中降低燃烧低挥发分高热值燃料飞灰含碳量的途径