Behaviour of Surface Defects in Wire Rod Rolling

Defects are often present in rolled products, such as wire rod. The market demand for wire rod without any defects has increased. In the final wire rod products, defects originating from steel making, casting, pre‐rolling of billets and during wire rod rolling can appear. In this work, artificial V‐shaped longitudinal surface cracks have been analysed experimentally and by means of FEM. The results indicate that the experiments and FEM calculations show the same tendency except in two cases, where instability due to fairly “round” false round bars disturbed the experiment. FE studies in combination with practical experiments are necessary in order to understand the behaviour of the material flows in the groove and to explain whether the crack will open up as a V‐shape or if it will be closed as an I‐shape.     

定径机在φ76自动轧管机组的应用

介绍了如何根据生产工艺需求对定径机进行设备改造和孔型优化设计，及定径机在φ76自动轧管机组的应用情况。     

线切割加工轧辊孔型模板提高精度的方法

详细论述了利用线切割机加轧辊孔型模板中易出现的几种影响加工精度的因素及消除方法，以达到提高模板精度。     

武山铜矿主井系统延深改造及效果浅析

武山铜矿主井延深时根据新的采、选工艺要求，在前期工程的基础上，对其箕斗提升系统进行改造，增设坑内破碎。针对该矿特粘的矿石性质和前期工程遗留问题，在具体设计和实施过程中采取特别措施保证系统通畅和安全并注意节省投资。同时对尚存在的问题也提出了新的思考。     

无线收、发信机的设计

主要讲述移动通信中收、发信机的工作原理、基本结构和组成.在给出收、发信机原理框图的同时,着重分析了锁相环路的设计.     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

用φ76 mm穿孔机组生产φ63mm毛管的设备改进

介绍了用Φ76mm穿孔机组生产Φ63mm毛管的设备概况及其改进。改进后，Φ76mm穿孔机组增加了产品范围为后面的冷技工序减少了拉拔道次，从而降低了Φ51mm以下冷拔管的生产成本。     

强折射轴对称流场的干涉再现方法

利用光学方法测量气体状态参数的关键在于确定气体折射率场的变化。光线通过稳定的非均匀折射率场时发生偏折，并且在强折射对称场中会产生交叉，使得条纹位移量的判读困难。本文首先分析了光线在轴对称折射率场中的偏折效应，在此基础上，给出了一种利用成像透镜对强折射轴对称场中折射率的干涉再现方法。该方法与其它方法相比较能够精确地确定折射率ｎ（ｒ）的值。     

红外图像序列小目标检测预处理技术

文中就如何复杂背景条件下低信噪比的小目标检测概率问题展开了讨论，提出了用空间高通滤的方法改善图像质量，达以抑制背景噪声，增强小目标的目的，并交坑通滤波和中值滤波做了一个简单的比较，随后采用分层投票表决法对目标进行检测，取得了良好效果。     

罗茨真空泵的溢流阀与旁通阀的组合

在简要地介绍了罗茨泵功能的基础上，通过溢流阀的改进设计，使溢流阀成为既能旁通又能溢流的组合阀，罗茨泵的功能将更加完备。