Torsional statics of two-dimensionally functionally graded microtubes

A size-dependent governing equation is derived to investigate the torsional static behaviors of two-dimensionally functionally graded microtubes based on the modified couple stress theory. The shear modulus is assumed to vary along the tube’s length direction according to an exponential distribute function, and varies along the tube’s radius direction according to a power-law function. A generalized differential quadrature method is developed to determine the rotational angle and shear stresses. Some illustrative examples are given to investigate the effects of applied torques, the length scale parameter and various material compositions on the torsional angle and shear stresses.     

Effect of stoichiometry and Cu-substitution on the phase structure and hydrogen storage properties of Ml-Mg-Ni-based alloys

To improve the electrochemical properties of rare-earth–Mg–Ni-based hydrogen storage alloys, the effects of stoichiometry and Cu-substitution on the phase structure and thermodynamic properties of the ...     

Binary Ti–Fe system. Part I: Experimental investigation at high pressure

The present work illustrates the effect of quasi-hydrostatic pressure on the positions and widths of the homogeneity ranges of the intermetallic phases TiFe and TiFe₂ at high temperatures. The experiments were performed with Ti–Fe diffusion couples that were heat treated in a multi-anvil press at 2.5 GPa. The solubility limits of the phases were derived from the concentration profiles that were measured using electron probe microanalysis. It was found that the homogeneity ranges of TiFe and TiFe₂ extend to higher titanium concentrations, if the pressure is applied. The positions of the phase boundaries of the intermetallics on the iron-rich side are not affected by the pressure. The accuracy of the experimental data including the homogeneity ranges and temperatures was verified by comparing the homogeneity ranges of β-Ti(Fe), α/δ-Fe(Ti) and γ-Fe measured in this study with the homogeneity ranges taken from literature. The pressure was calibrated using the pressure-induced phase transitions of bismuth.     

三光子吸收效应对孤子对传输的影响

用分步傅里叶变换法求解含三光子吸收效应的光孤子NLS方程，研究了三光子吸收效应对孤子对在传输中相互作用的影响。研究发现，在特定条件下，三光子吸收效应能使孤子对无离合地平行传输。     

甲基叔戊基醚合成反应的热力学分析

利用戊烯与甲醇合成甲基叔戊基醚(TAME)反应的热力学平衡实验数据, 选择不同的混合活度模型,分别计算得到了该反应体系的平衡常数,并与理论计算得到的平衡常数相比较,筛选出了适合该反应体系的活度计算模型.     

Measurement of Gibbs energies of formation of CoF2 and MnF2 using a new composite dispersed solid electrolyte

Gibbs energies of formation of CoF₂ and MnF₂ have been measured in the temperature range from 700 to 1100 K using Al₂O₃-dispersed CaF₂ solid electrolyte and Ni+NiF₂ as the reference electrode. The dispersed solid electrolyte has higher conductivity than pure CaF₂ thus permitting accurate measurements at lower temperatures. However, to prevent reaction between Al₂O₃ in the solid electrolyte and NiF₂ (or CoF₂) at the electrode, the dispersed solid electrolyte was coated with pure CaF₂, thus creating a composite structure. The free energies of formation of CoF₂ and MnF₂ are (± 1700) J mol⁻¹; {fx37-1} The third law analysis gives the enthalpy of formation of solid CoF₂ as ΔH° (298·15 K) = −672·69 (± 0·1) kJ mol⁻¹, which compares with a value of −671·5 (± 4) kJ mol⁻¹ given in Janaf tables. For solid MnF₂, ΔH°(298·15 K) = − 854·97 (± 0·13) kJ mol⁻¹, which is significantly different from a value of −803·3 kJ mol⁻¹ given in the compilation by Barinet al.     

铁液洁净度对凝固热力学参数的影响

为了给高洁净钢连铸细晶技术提供相关理论依据，在高温钼丝炉中通过对电解纯铁加金属铝和硅脱氧，获得不同铁液洁净度的试样。利用差热分析法测定了试样在相同冷却速度下的过冷度。利用凝固过程热力学理论研究了铁液洁净度与过冷度、凝固热力学驱动力、形核功和临界晶核半径等的关系。结果表明：随着铁液洁净度的提高，铁液凝固时的过冷度增大，形核所需的凝固热力学驱动力变大，非均质形核功和临界晶核半径减小。     

Cumulant calculations of thermodynamic quantities for the Hubbard and the emery model

The calculations of the first paper suggesting phase separation in the Hubbard model [2] are performed under modern computer facilties for the one and three-band Hubbard model. High-temperature approximations for specific heat and static correlation functions are obtained. The latter show, at these high temperatures, no tendency to phase separate in the same way as in the cited paper because our spin parallel nearest-neighbor charge correlation function is negative for all doping values. The spin antiparallel correlation function has positive and negative values for different doping regimes.Extension of this work to higher levels of iterations and to other correlation functions is in progress.     

Measurements ofPVTx properties of refrigerant mixture HFC-32+HFC-125 in the gaseous phase

The experimental 156PVTx properties of an important binary refrigerant mixture, HFC-32 (difluoromethane)+HFC-125 (pentafluorethane), have been measured for three compositions, i.e., 50, 60, and 80 wt% HFC-32, by a constant-mass-method coupled with expansion procedure in an extensive range of temperaturesT from 320 to 440 K, of pressuresP from 1.8 to 5.3 M Pa, and of densities p from 50 to 124 kg · m^–3. The experimental uncertainties of the present measurements are estimated to be within ±7 mK in temperature, ±2 kPa in pressure, ±0.2% in density and ±0.02 wt% of HFC-32. The sample purities are 99.998 wt% for HFC-32 and 99.99 wt% for HFC-125. Seventy-eight second and third virial coeflicients for temperatures from 320 to 440 K have been determined by the present measurements.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994, Boulder, Colorado, U.S.A.     

吸附制冷循环的热力计算及热力学评价方法探讨

在化工吸附，吸附热力学及Polanyi吸附位势理论的基础上，介绍吸附制冷基本型循环，推演其参数坐标图，进而分析，给出其主要性能指标的热力计算，然后以热力学的逆卡诺循环和内可逆三热源循环模型为指针，对此制冷循环进行考察。并结合热力计算对其热力学完善性做出评价，从而给出了吸附制冷基本型循环合适的热力学评价方法。