新型着色材料——速溶色浆粉的测试与应用

介绍了通过初级颜料的润湿、研磨与分散、稳定处理技术,使助剂和树脂均匀地包裹在颜料表面,并通过特殊工艺制得水性和油性色浆粉,并赋予了很好的速溶性和分散性。     

用注凝成型技术制备莫来石陶瓷坯体

用注凝成型技术，通过控制合成莫来石粉料的细度，调节好pH值在单体和交联剂的比例，制备出稳定性好的料浆和强度高的生坯。     

Thermoreversible Gelcasting: A Novel Ceramic Processing Technique

A new ceramic processing method, thermoreversible gelcasting (TRG), has been developed. The method uses a gelation process that can be reversed multiple times. Two Al₂O₃ systems have been explored with the use of a specific triblock copolymer to form a binding gel network. The mixture becomes a free-flowing liquid on heating above 60°C. However, on cooling below 60°C, the slurry instantaneously transforms to a physical gel. This process can be reversed easily (essentially with an infinite processing time window) while the solvent is present in the system, which is advantageous when trying to produce high-quality dense pieces if initial casting irregularities occur. Near-theoretically dense specimens have been produced with properties consistent with reported values of high-density Al₂O₃.     

砂岩气藏水基欠平衡钻井逆流自吸效应实验研究

采用水基钻井液欠平衡钻开砂岩气层时，欠平衡压差往往并不能完全抵消岩石的自吸毛细管力，从而产生逆流自吸效应。这种自吸效应可能对砂岩气藏水基欠平衡钻井的储层保护效果产生影响，但目前与之有关的实验研究还很缺乏。为此，设计了一套实验装置，模拟水基欠平衡条件，研究了砂岩基块孔隙逆流自吸规律及其影响因素。结果表明，水基欠平衡钻井过程的逆流自吸效应引起岩石气相渗透率降低，削弱欠平衡钻井的储层保护效果；欠平衡压差越小，逆流自吸作用越强，过小的欠压值不能起到欠平衡钻井保护储层的作用；随着逆流自吸时间延长、围压增加和黏土矿物膨胀，逆流自吸导致气相渗透率下降的程度加剧；逆流自吸引起的气相渗透率下降速率可以表示成时间的幂函数。     

New intramolecular effect observed for polyesters: An anomeric effect

A series of polyesters was prepared to evaluate hydrolytic stability as a function of cyclohexyl dibasic acid content. The three cyclohexyl dibasic acids: 1,2; 1,3; and 1,4 were formulated into polyesters with two glycols. The proportion of cis and trans isomers was evaluated via ¹H NMR. The hydrolytic stability of short chain polyesters was evaluated in an acetone/water mixture which solubilized the polyesters to mimic oligoester behavior within a thermosetting polyester coating environment. The rate of hydrolysis was monitored by acid titration and corroborated by GPC. Surprisingly, 1,2-cylohexyl diacid-based polyesters were robust, and 1,3-cyclohexyl diacid-based polyesters were the most susceptible to hydrolysis. Evidently, a 1,2-anchimeric effect for cyclohexyl dibasic acid polyesters was not an important consideration, while the 1,3-cyclohexyl ester interaction was. Consequently, an anomeric effect was proposed. Presented at the 81st Annual Meeting of the Federation of Societies for Coatings Technology, November 12–14, 2003, in Philadelphia, PA.     

水基传送带润滑剂综述

说明了水基传送带润滑剂的作用机理、性能要求,详细介绍了现有的水基传送带润滑剂的特点,并简单介绍了水基传送带润滑剂的发展前景和趋势。     

Varnish layer hardness of oriental beech (fagus orientalist L.) wood as affected by impregnation and bleaching

The impacts of impregnation and bleaching on the varnish layer hardness of Oriental beech (Fagus orientalist L.) wood were investigated. A number of bleaching combinations {[NaOH−H₂O₂], [NaOH−Ca(OH)₂−H₂O₂], [NaOH−MgSO₄−H₂O₂] [NaHSO₃−H₂C₂O₄], [NaSiO₃−H₂O₂], [KMnO₄+NaHSO₃+H₂O₃]} were applied at 18% concentration for bleaching to both impregnated and unimpregnated specimens of Oriental beech wood. Subsequently, water-based (WB) varnish was coated over the samples and the varnish layer hardness values were determined in accordance with ASTM D 4366-95. All of the chemicals used for bleaching reduced the surface hardness. However, after varnish coating, the hardness of most samples was similar to that of the varnish-coated natural (control) samples.     

Tailoring HASE rheology through polymer design: Effects of hydrophobe size, acid content, and molecular weight

Hydrophobically modified alkali-soluble emulsion (HASE) polymers are an important class of rheology modifiers for waterborne coatings applications. They are typically prepared as terpolymers by emulsion polymerization of ethyl acrylate (EA), methacrylic acid (MAA), and an associative macromonomer. The viscosity development and shear responses of HASE solutions depend on a number of factors. This article presents rheological data reflecting the impacts of three key variables: hydrophobe size, acid content, and molecular weight, on model HASE thickening and rheological performance. The relative contributions of hydrophobic association, chain expansion, and polymer chain length are discussed. In steady shear flow, all thickener solutions approached some constant low-shear viscosity at small deformation rates. At the same molar composition, larger hydrophobe size resulted in higher viscosity development and greater shear thinning behavior. The amount of acid monomer in HASE polymers can influence the balance between hydrophobic attraction and electrostatic repulsion forces. It was found that a minimum of 15 wt% MAA was required to effect dissolution and thickening of the model HASE polymers. Increasing the MAA level yielded higher zero-shear viscosity and storage modulus G’ with maximal values being obtained at 40% MAA. The molecular weight of the model thickeners was controlled by the amount of chain transfer agent (CTA) added during polymerization. When the CTA level was below 0.1 wt% based on total monomers, the polymer solutions displayed shear-thinning behavior. A small increase in CTA concentration beyond 0.1% resulted in a dramatic change to Newtonian flow, and the solution viscosity was nearly two orders of magnitude lower. The model thickeners were also tested in a vinyl acrylic architectural paint formulation. The effects of each individual factor on paint thickener efficiency, high-shear, and low-shear properties are discussed and compared with solution rheology for predictive relationships. Presented at the 81st Annual Meeting of the Federation of Societies for Coatings Technology, November 11–12, 2003, in Philadelphia, PA.     

高档水基油墨粘度影响因素的研究

为获得高固低粘的油墨配方体系,通过油墨的分散实验,探讨了分散树脂和乳液及其助剂对水基油墨体系粘度的影响规律,润湿分散剂对水基油墨粘度的影响,胺化剂对水基油墨粘度的影响机理。研究表明,乳液聚合物具有高固低粘特性,拼混使用不同的聚合物可获得理想粘度和应用性能;润湿分散剂能改变体系的表面张力和润湿性能,从而降低水基油墨体系的粘度;拼混使用不同的胺化剂可以获得粘度稳定的水基油墨体系。     

Self-emulsifiable soybean oil phosphate ester polyols for low-VOC corrosion resistant coatings

A series of soybean oil phosphate ester polyols (SOPEP) was prepared by reaction of fully epoxidized soybean oil with phosphoric acid and simultanoeous hydrolysis in the presence of a polar solvent. The polyols were characterized by determination of acid value, oxirane number, hydroxyl value, molecular weight (GPC), and FTIR spectra. These polyols with varying amounts of acid phosphate groups could be self-emulsified to form aqueous dispersions after neutralization with organic base. These aqueous dispersion showed varying degrees of stability and their appearance ranged from opaque dispersions to translucent to clear solutions. Waterborne coating compositions were prepared using these aqueous dispersions as principal components and their thermally cured film properties were studied. it was found that by careful selection and formulation, SOPEPs can be successfully used for low-VOC waterborne coating formulations. SOPEPs with 3.5% phosphate ester content showed visibly superior corrosion resistance properties.