全文获取类型
收费全文 | 109篇 |
免费 | 16篇 |
国内免费 | 14篇 |
专业分类
电工技术 | 4篇 |
综合类 | 9篇 |
化学工业 | 8篇 |
金属工艺 | 18篇 |
机械仪表 | 7篇 |
建筑科学 | 7篇 |
矿业工程 | 6篇 |
能源动力 | 5篇 |
水利工程 | 4篇 |
石油天然气 | 3篇 |
无线电 | 21篇 |
一般工业技术 | 10篇 |
冶金工业 | 6篇 |
原子能技术 | 10篇 |
自动化技术 | 21篇 |
出版年
2024年 | 1篇 |
2023年 | 2篇 |
2022年 | 2篇 |
2021年 | 5篇 |
2020年 | 2篇 |
2019年 | 6篇 |
2018年 | 2篇 |
2017年 | 5篇 |
2016年 | 4篇 |
2015年 | 3篇 |
2014年 | 7篇 |
2013年 | 7篇 |
2012年 | 9篇 |
2011年 | 10篇 |
2010年 | 15篇 |
2009年 | 9篇 |
2008年 | 7篇 |
2007年 | 10篇 |
2006年 | 5篇 |
2005年 | 7篇 |
2004年 | 2篇 |
2003年 | 3篇 |
2002年 | 3篇 |
2001年 | 4篇 |
2000年 | 3篇 |
1999年 | 2篇 |
1998年 | 2篇 |
1996年 | 1篇 |
1989年 | 1篇 |
排序方式: 共有139条查询结果,搜索用时 0 毫秒
1.
乏燃料后处理强酸、强氧化性、强放射性的工作环境,对后处理溶解器选材、加工工艺提出了严苛要求。本论文研究了自主设计Zr-1.0Ti-0.35Nb合金在670 ~ 750 ℃温度范围、三种不同应变速率0.01、0.1和1 s-1条件下的热压缩变形行为,分析了热压缩过程中该合金的微观组织特征,并基于峰值应力构建了其热变形本构模型。结果表明,应变速率和变形温度对Zr-1.0Ti-0.35Nb合金热变形过程具有显著影响,流变应力随应变速率增加而增大,随变形温度的增加而减小,达到峰值应力后流变曲线呈现明显动态再结晶特征;提高变形温度有助于发生动态再结晶和晶粒长大;基于Arrhenius本构方程计算得到Zr-1.0Ti-0.35Nb合金的热变形激活能为225.8 kJ/mol,硬化指数为5.62,说明合金元素Ti使锆合金的热变形激活能升高;实验值与预测值之间的相关系数为0.97,平均相对误差为6.15%,证实此本构方程预测Zr-1.0Ti-0.35Nb合金流变应力的准确性,能够为新型锆合金热加工工艺优化提供理论指导。 相似文献
2.
3.
具有高介电常数的栅绝缘层材料存在某种极化及耦合作用,使得ZnO-TFTs具有高的界面费米能级钉扎效应、大的电容耦合效应和低的载流子迁移率.为了解决这些问题,本文提出了一种使用SiO2修饰的Bi1.5Zn1.0Nb1.5O7作为栅绝缘层的ZnO-TFTs结构,分析了SiO2修饰对栅绝缘层和ZnO-TFTs性能的影响.结果表明,使用SiO2修饰后,栅绝缘层和ZnO-TFTs的性能得到显著提高,使得ZnO-TFTs在下一代显示领域中具有非常广泛的应用前景.栅绝缘层的漏电流密度从4.5×10-5A/cm2降低到7.7×10-7A/cm2,粗糙度从4.52nm降低到3.74nm,ZnO-TFTs的亚阈值摆幅从10V/dec降低到2.81V/dec,界面态密度从8×1013cm-2降低到9×1012cm-2,迁移率从0.001cm2/(V·s)升高到0.159cm2/(V·s). 相似文献
4.
《Journal of Nuclear Science and Technology》2013,50(7):471-475
The sputtering yield of Mo honeycomb walls was compared with the yield of fiat walls in a d.c. Ar glow discharge. Under the experimental condition where the mean energy is approximately 1 keV and the angle of incidence of primary ions strongly distributed around normal, the yield is reduced by a factor of 20 to 30. Before and after the bombardment, the surface topography of the honeycomb targets was observed by a scanning electron microscope. 相似文献
5.
分别用钠硼氘、钠硼氚还原人参皂甙Rh1的活性形式20(S)-protopanaxadiol(aPPD)的氧化前体aPPD=O,制备氘、氚标记的aPPD。标记物经板层析(TLC)、质谱(MS)、核磁共振(NMR)分析鉴定,结果与标准品的测量数据一致;氚标记的aPPD放化纯度为98%,放射性比活度为7.64×1011Bq/g。将3H-aPPD作用于人肺腺癌A549细胞,检测不同时间细胞浆及细胞核中氚的活度,结果提示aPPD在A549细胞浆、核内均于24 h达到最高浓度,表明aPPD作为一个与甾体类激素结构相类似的药物,可以进入细胞甚至细胞核发挥药理作用 相似文献
6.
Measurement of soft x-ray emission from a low-energy plasma focus operated with nitrogen within the pressure range of 0.1–1.0 mbar is presented. The x-rays are detected by using an assembly of Quantrad Si PIN-diodes with differential filtering and with a multipinhole camera. In the 1.0–1.3 keV and 1.0–1.5 keV windows, the x-ray yield in 4 geometry is 1.03 J and 14.0 J, respectively, at a filling pressure of 0.25 mbar and the corresponding efficiencies are 0.04% and 1.22%. The total x-ray emission in 4 geometry is estimated at 21.8 J, which corresponds to the system efficiency of about 1.9%. The soft x-ray emission is found dominantly as a result of electron beam activity on the anode tip, which is confirmed by the images recorded by a pinhole camera. 相似文献
7.
印制板行业水污染中铜的困扰 总被引:1,自引:0,他引:1
叙述印制板行业目前执行的水污染物排放的国家和地方标准,在污水处理中如何解决铜含量达到国家二级标准(1.0mg/L)和一级标准(0.5mg/L)的困扰,叙述铜对人体和动植物的毒害情况,世界各国污水排放铜的标准,提出了改变这种状况的建议。 相似文献
8.
采用溶胶一凝胶法在Pt/Ti/SiO2/Si衬底上制备了钛酸锶钡/铋锌铌多层复合薄膜样品.研究了不同退火温度下多层复合薄膜的结构、微观形貌及介电性能.结果表明:在退火温度高于700℃时,所得复合薄膜中会出现立方焦绿石结构的铋锌铌和钙钛矿结构的钛酸锶钡.750℃退火处理得到的多层复合薄膜,表面致密,无裂纹,其相对介电常数... 相似文献
9.
10.
A key advantage of working with structured grids (e.g., images) is the ability to directly tap into the powerful machinery of linear algebra. This is not much so for unstructured grids where intermediate bookkeeping data structures stand in the way. On modern high performance computing hardware, the conventional wisdom behind these intermediate structures is further challenged by costly memory access, and more importantly by prohibitive memory resources on environments such as graphics hardware. In this paper, we bypass this problem by introducing a sparse matrix representation for unstructured grids which not only reduces the memory storage requirements but also cuts down on the bulk of data movement from global storage to the compute units. In order to take full advantage of the proposed representation, we augment ordinary matrix multiplication by means of action maps, local maps which encode the desired interaction between grid vertices. In this way, geometric computations and topological modifications translate into concise linear algebra operations. In our algorithmic formulation, we capitalize on the nature of sparse matrix‐vector multiplication which allows avoiding explicit transpose computation and storage. Furthermore, we develop an efficient vectorization to the demanding assembly process of standard graph and finite element matrices. 相似文献