Formulation of sage essential oil (Salvia officinalis,L.) monoterpenes into chitosan hydrogels and permeation study with GC-MS analysis

This study deals with the formulation of natural drugs into hydrogels. For the first time, compounds from the sage essential oil were formulated into chitosan hydrogels. A sample preparation procedure for hydrophobic volatile analytes present in a hydrophilic water matrix along with an analytical method based on the gas chromatography coupled with the mass spectrometry (GC-MS) was developed and applied for the evaluation of the identity and quantity of essential oil components in the hydrogels and saline samples. The experimental results revealed that the chitosan hydrogels are suitable for the formulation of sage essential oil. The monoterpene release can be effectively controlled by both chitosan and caffeine concentration in the hydrogels. Permeation experiment, based on a hydrogel with the optimized composition [3.5% (w/w) sage essential oil, 2.0% (w/w) caffeine, 2.5% (w/w) chitosan and 0.1% (w/w) Tween-80] in donor compartment, saline solution in acceptor compartment, and semi-permeable cellophane membrane, demonstrated the useful permeation selectivity. Here, (according to lipophilicity) an enhanced permeation of the bicyclic monoterpenes with antiflogistic and antiseptic properties (eucalyptol, camphor and borneol) and, at the same time, suppressed permeation of toxic thujone (not exceeding its permitted applicable concentration) was observed. These properties highlight the pharmaceutical importance of the developed chitosan hydrogel formulating sage essential oil in the dermal applications.     

Combination of heat treatment and chitosan coating to improve postharvest quality of wolfberry (Lycium barbarum)

The synergistic application of hot water dip at 42 °C for 30 min and 1% chitosan coating on differentiation in postharvest quality traits, microstructure as well as microbiological evolution of wolfberry fruits was investigated. Fresh wolfberry fruits were stored at 2 ± 0.5 °C and 90% relative humidity (RH) for 28 days. Results indicated the combination of prestorage heat treatment and chitosan coating maintained higher levels of ascorbic acid, total phenolic contents and antioxidant capacity as well as lower decay, compared with untreated wolfberry fruits. The possible mechanism was that the heat treatment almost sealed open stomata to limit the sites of pathogen penetration into fruits independently, followed by the biofilm formed by chitosan which controlled secondary infections as well as slowed changes in fruit respiration and metabolic activity in wolfberries. The synergistically treated fruit also exhibited a higher acceptability obtained by sensory analysis after cold storage. In this sense, the integrated application of heat treatment and chitosan coating could be regarded as an effective strategy to extend storage life and maintain the postharvest quality of wolfberry fruits.     

Effect of modified atmosphere packaging on the shelf-life of coated, whole and sliced mushrooms

Whole and sliced fresh mushrooms (Agaricus bisporus) were packaged with PVC wrap or two polyolefins (PD-941 and PD-961) films after coating with CaCl₂ and chitosan. Package gas composition, color, weight loss and maturity were measured during storage at 12 °C and 80%RH. For PD-961, the highest in-package concentration occurred during the first day of storage regardless of treatments, while wrap and PD-941 showed varying degrees in-package concentration with different processes and coatings. The whiteness of whole mushrooms varied significantly with the type of coating, but not with the type of films. The extent of darkening was greater in coated whole mushrooms than in sliced ones. Weight loss occurred in all packages and varied from 3 (g/100 g) to about 7 (g/100 g) after 6 days of storage. Due to a lower permeability, PD-961 packages had the lowest weight loss. The type of packaging films significantly affected the maturity index, where PD-961 most effectively lowered maturity index for both whole and sliced mushrooms, thus extending the shelf-life. The type of coating did not appear to affect maturity index except for the wrap package where chitosan coating markedly lowered the maturity index of sliced mushrooms.     

Electrospinning of collagen-chitosan complex

The collagen-chitosan complex nanofibers have been prepared for the first time by electrospinning. The mixed HFP/TFA (the volume ratio of 90/10) was found to be the appropriate solvent for electrospinning. The concentration of the spinning solution and the ratio of chitosan/collagen were varied and adjusted to get smooth nanofibers. It was found that the diameter of the spun fibers became thick with the concentration of the solution increasing and became fine with the ratio of the chitosan/collagen increasing. We have characterised the molecular interactions in collagen-chitosan complex by Fourier transform infrared spectroscopy. The spun fibers are designed to mimic the native extracellular matrix for tissue engineering and to develop functional biomaterials.     

Simultaneous removal of copper and zinc ions by low cost natural snail shell/hydroxyapatite/chitosan composite

In this work, the snail shell/hydroxyapatite/chitosan composite was prepared as adsorbent. The adsorption potential of the composite was studied for simultaneous sorption behavior of Zn(Ⅱ) and Cu(Ⅱ) ions in a batch system. Chitosan and hydroxyapatite(HAP) were extracted from shrimp shell and bone ash,respectively, so this is a low cost natural composite. To prepare the composite, chitosan was dissolved in acetic acid, then HAP and snail shell powders were added to the chitosan solution. The morphology and characterization of the composite was studied by SEM and EDX analysis. Atomic adsorption was used to measure the amount of the ions. Experimental parameters were optimized with Design Expert Software and five parameters such as the concentration of ions, p H, adsorbent amount and contact time were studied at room temperature. Optimized value for the parameters of Zn(Ⅱ) and Cu(Ⅱ) concentrations, p H, adsorbent dose, and contact time were 3.01 mg·L~(-1), 5.5, 0.02 g and 95 min, respectively. The adsorption isotherms for Zn(Ⅱ) and Cu(Ⅱ) showed Langmuir and Tempkin, respectively. Kinetic and equilibrium studies showed the experimental data of Zn(Ⅱ) and Cu(Ⅱ) ions were best described by the pseudo-second-order model. Studies on thermodynamic show the adsorption process were physical and spontaneous.     

壳聚糖与DNA作用的共振光散射特征及微量DNA的光散射测定

通过光谱法研究壳聚糖和核酸的作用 ,结果表明通过共振光散射法用壳聚糖检测微量的 DNA方法可靠、准确且简单。     

Synthesis, characterization and properties of chitosan modified with poly(ethylene glycol)-polydimethylsiloxane amphiphilic block copolymers

Synthesis of poly(ethylene glycol)-polydimethylsiloxane amphiphilic block copolymers is discussed herein. Siloxane prepolymer was first prepared via acid-catalyzed ring-opening polymerization of octamethylcyclotetrasiloxane (D₄) to form polydimethylsiloxane (PDMS) prepolymers. It was subsequently functionalized with hydroxy functional groups at both terminals. The hydroxy-terminated PDMS can readily react with acid-terminated poly(ethylene glycol) (PEG diacid) to give PEG-PDMS block copolymers without using any solvent. The PEG diacid was prepared from hydroxy-terminated PEG through the ring-opening reaction of succinic anhydride. Their chemical structures and molecular weights were characterized using ¹H NMR, FTIR and GPC, and thermal properties were determined by DSC. The PEG-PDMS copolymer was incorporated into chitosan in order that PDMS provided surface modification and PEG provided good water swelling properties to chitosan. Critical surface energy and swelling behavior of the modified chitosan as a function of the copolymer compositions and contents were investigated.     

壳聚糖固定化酶和细胞研究新进展

分析评价了壳聚糖作为固定化酶和细胞载体的特性,概述了壳聚糖凝胶固定化酶和细胞的形态及制备方法,着重介绍了近年来壳聚糖固定化酶和细胞的改进方法,并指出今后壳聚糖固定化酶和细胞的发展方向。     

Universal yield stress function for biocompatible chitosan based-electrorheological fluid: Effect of particle concentration

Electrorheological (ER) response of biocompatible particles suspended in an insulating silicone oil, was investigated under several different applied external electric field strengths. Chitosan, a biodegradable polysaccharide, was used as anhydrous ER materials. The effect of particle volume concentration on their ER response was examined by focusing on the measurement for rheological and electrical properties. The yield stress of chitosan suspended in silicone oil system as a function of applied electric field strength showed different value of slopes for different particle concentrations, however, all data points collapse onto a universal scaling function.     

靶向壳聚糖基因载体与水溶性量子点的自组装

将透明质酸(HA)接枝到四种不同分子量的壳聚糖(CS)上,获得了靶向壳聚糖基因载体。将CS及接枝CS分别与水溶性量子点(QDs)自组装,研究发现,相对于纯QDs,CS/QDs复合物及接枝CS/QDs复合物的荧光强度均明显增强,荧光发射峰位发生红移。复合物呈核/壳结构,QDs被包裹在核内。和CS/QDs复合物相比,接枝CS/QDs复合物的尺寸更小,分布更为均一。