轻质滤料滤池的试验与研究

轻质滤料滤池是以比水密度略小的滤料为滤床的滤池，通过以净水厂的原水和污水处理厂的二级处理出水为过滤试验对象，所取得的结果表明：下向流轻质滤料滤池对浊度和悬浮固体（SS）的去除率分别可以达到80％和45％，而滤床的水头损失不超过15cm。因此轻质滤料滤池可以以预过滤的形式配置在过滤处理的净水和污水的处理工艺中。     

Rate of ammonia oxidation in a synthetic saline wastewater by a nitrifying mixed‐culture

Most of the kinetic studies on nitrification have been performed in diluted salts medium. In this work, the ammonia oxidation rate (AOR) was determined by respirometry at different ammonia (0.01 and 33.5 mg N‐NH₃ L^?1), nitrite (0–450 mg N‐NO₂^? L^?1) and nitrate (0 and 275 mg N‐NO₃^? L^?1) concentrations in a saline medium at 30 °C and pH 7.5. Sodium azide was used to uncouple the ammonia and nitrite oxidation, so as to measure independently the AOR. It was determined that ammonia causes substrate inhibition and that nitrite and nitrate exhibit product inhibition upon the AOR. The effects of ammonia, nitrite and nitrate were represented by the Andrews equation (maximal ammonia oxidation rate, r_AOMAX, = 43.2 [mg N‐NH₃ (g VSS_AO h)^?1]; half saturation constant, K_SAO, = 0.11 mg N‐NH₃ L^?1; inhibition constant K_IAO, = 7.65 mg N‐NH₃ L^?1), by the non‐competitive inhibition model (inhibition constant, K_INI, = 176 mg N‐NO₂^? L^?1) and by the partially competitive inhibition model (inhibition constant, K_INA, = 3.3 mg N‐NO₃^? L^?1; α factor = 0.24), respectively. The r_AOMAX value is smaller, and the K_SAO value larger, than the values reported in diluted salts medium; the K_IAO value is comparable to those reported. Process simulations with the kinetic model in batch nitrifying reactors showed that the inhibitory effects of nitrite and nitrate are significant for initial ammonia concentrations larger than 100 mg N‐NH₄⁺ L^?1. Copyright © 2005 Society of Chemical Industry     

Photo-Fenton removal of water-soluble polymers

This paper presents the results of experiments carried out in a laboratory-scale photochemical reactor on the photodegradation of different polymers in aqueous solutions by the photo-Fenton process. Solutions of three polymers, polyethyleneglicol (PEG), polyacrylamide (PAM), and polyvinylpyrrolidone (PVP), were tested under different conditions. The reaction progress was evaluated by sampling and analyzing the total organic carbon concentration in solution (TOC) along the reaction time. The behavior of the different polymers is discussed, based on the evolution of the TOC–time curves. Under specific reaction conditions, the formation and coalescence of solid particles was visually observed. Solids formation occurred simultaneously to a sharp decrease in the TOC of the liquid phase. This may be favorable for the treatment of industrial wastewater containing polymers, since the photodegradation process can be coupled with solid separation systems, which may reduce the treatment cost.     

Elimination of organic matter present in wastewaters from the cork industry by membrane filtration

BACKGROUND: The first stage of the cork industrial process generates great volumes of wastewater with moderate to high organic pollutant content that must be purified using different procedures, such as filtration by membranes. RESULTS: The tangential filtration of these wastewaters was studied using two different laboratory equipments. In the first one, three ultrafiltration (UF) membranes were tested, with molecular weight cut‐off (MWCO) 100 kDa and 30 kDa, and two operating modes were used: total recycling of permeate and retentate streams, and in continuous mode, without recycling both streams. In the total recycling UF experiments, the influence of the operating variables on the permeate flux was first established. The effectiveness of the different membranes was determined by evaluating the rejection coefficients for several parameters that measure the global pollutant content of the effluent. The values found for these rejection coefficients were in the following order: ellagic acid and color > absorbance at 254 nm > tannic content > COD (chemical oxygen demand). In the continuous mode experiments, the fouling mechanism for each membrane was established by fitting the experimental data to various filtration fouling models given in the literature. The operating mode in the second equipment was batch concentration, and additional experiments were carried out with an UF membrane (2 kDa), and with a NF membrane (with MWCO in the range 150–300 Da). CONCLUSIONS: The three operating modes tested provided different rejection levels of organic matter; among them, the most effective procedure tested was batch concentration mode using a NF membrane. Copyright © 2007 Society of Chemical Industry     

Impact of the addition of an enzyme pool on an activated sludge system treating dairy wastewater under fat shock loads

BACKGROUND: The application of lipase‐rich enzyme pools (such as the crude solid enzymatic preparation (SEP) obtained from Penicillium restrictum solid‐state fermentation of agro‐industrial wastes) to activated sludge systems may be an effective strategy for preventing various operational problems. The continuous addition of SEP to the treatment system can become cost‐prohibitive when in situ production and/or storage are factored in. The application of SEP to high‐fat wastewater treatment would only be justified as an emergency measure, such as a sudden increase in the fat content of the bioreactor influent. Therefore, the primary objective of this work was to investigate the efficiency of a crude SEP during fat shock loads, simulated through the periodic addition of dairy industry waste containing high fat concentrations to the feed stock of an activated sludge system, operated in continuous mode. RESULTS: The test bioreactor exhibited a higher average chemical oxygen demand (COD) removal efficiency than the control bioreactor (83% for control and 90% for test) and the fat accumulation in the biological flocs of the test bioreactor was 3.2 times lower than that in the control bioreactor. Turbidity was also lower in the effluent of the test bioreactor (123 and 66 FTU in control and test, respectively) and it had a shorter recovery time between shock loads, especially when the interval between loads was shorter than one month (biweekly and weekly shock loads). CONCLUSION: The addition of SEP during fat overloads in the reactor feed maintained efficient COD removal in the test bioreactor for 270 days without any operational problems. Copyright © 2008 Society of Chemical Industry     

炼油厂废水的最小化

石油炼厂作为用水大户，在水资源逐渐短缺、环境污染日益严重的情况下，实施废水最小化改造具有重要的现实意义。笔者以石油炼厂整个水分配系统年度费用最小为目标函数，提出采用回用、再生回用和再生循环3种措施减少新鲜水用量和废水排放量。利用超结构建模求解所得优化的水分配系统不但要满足各用水过程的需求，而且使排放的废水达标。给出的实例证明，所提出的方法更全面地考虑了废水最小化的机会，且所得结果可行、有效。     

铅锌选矿厂废水回用研究

简述了铅锌选厂废水回用小型试验及工业试验情况，在基本上不改变工艺结构基础上改变药剂制度达到废水回用的目的，使选矿废水回用率达到80％，实现尾矿库废水零排放。     

对选矿废水综合利用的探讨

通过对金堆城钼业公司选矿废水再用于选矿作业的选矿试验，证明选矿废水循环利用是可行的，既提高了选矿浓度，又减少了对环境的污染，经济和社会效益显著。     

火电厂实施废水零排放的可行性探讨

对合肥发电厂的用排水现状进行了介绍，并提出了实施废水零排放的可行性方案。     

用高梯度磁场净化轧钢废水

通过用高梯度磁场处理热轧厂废水的试验,得到了在试验条件下浊度(水中不溶物的含量)和铁的去除率,确定了最佳净化条件.在此条件下,能够有效去除废水中的不溶物和铁,经过处理的水质达到了工艺循环水的水质标准.