EMD与KOH溶液的相互影响

利用滴定分析、热失重分析以及XRD方法研究了EMD和KOH溶液混合后的变化。结果表明:碱与MnO2可以相互作用并导致体系温度的升高,碱浓度的下降,EMD中形成Mn3O4以及MnO2中结合水的损失。相互作用的结果与所加KOH溶液的浓度、EMD中的水含量、二者用量的比例关系以及体系的温度有关。     

Development of correlation between potassium hydroxide number and conductivity of concentrated natural rubber latex

Increase in the ion concentration in the medium was found to increase conductivity and potassium hydroxide number (KOH No) in natural rubber latex (NRL). Addition of long chain fatty acids can increase the ion concentration in the medium and stability of NRL. A series of concentrated natural rubber latex samples from three different areas with different soils and climatic conditions were tested for the parameters such as KOH No and conductivity. They have been measured over a period of 62 days, upon addition of soap to natural rubber latex concentrate. The result showed that there was a strong positive linear correlation between conductivity and KOH No. The regression equation to express the relationship between the variables has also been found. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

金属离子对车载制氢机制氢效率的影响

针对向车载制氢机加水带入的金属离子导致制氢效率偏低的问题,在制氢测试系统实验台上研究加入含不同Zn2+、Fe3+和Cu2+质量浓度的溶液对制氢效率的影响.在电解电流为30 A,初始温度为19.7℃,压力恒为0.1 MPa条件下,电解2 L质量分数为30%的KOH溶液与其对应加入50 mL含不同金属离子质量浓度溶液做比较.试验结果表明：随着电解的进行,加入溶液所含的金属离子质量浓度越高,KOH溶液的电解电压越高,制氢速率越低,制氢效率越低.     

The effect of isopropyl alcohol concentration on the etching process of Si-substrates in KOH solutions

In this paper the process of silicon anisotropic etching in KOH solutions containing isopropyl alcohol in a wide concentration range is extensively studied. Though the alcohol does not take part in the etching process itself, it strongly affects the etching results. Both etch rates and the roughness of etched surfaces depend on the alcohol concentration in the etching solution, which is connected with the adsorption phenomena on the etched surface. The surface coverage with alcohol depends on the level of saturation of the etching solution and crystallographic orientation of an etched surface. It was observed that the best morphology of (1 1 0) surface was achieved just below saturation level with IPA whereas the (1 0 0) surfaces were improving above the saturation. A model, which explains these phenomena, was proposed. Based on this model, a simple way of selection of the composition of KOH solutions with alcohol additives, assuring optimization of etching results was suggested. The method is restricted to surface tension measurements and allows one to avoid elaborated etching experiments.     

KOH‐assisted microwave post‐treatment of activated carbon for efficient symmetrical double‐layer capacitors

It is important to tune the surface and pore structures of carbon materials for their application in capacitors. Herein, a novel microwave‐based approach is demonstrated to significantly increase the capacity of a supercapacitor. After activated carbon (AC) with KOH was treated by microwave heating only for 8 min, its symmetrical double‐layer capacitor increased from 68.6 to 107.9 F/g at current density of 0.2 A/g with 2 M KOH aqueous solution. The excellent capacity retention of 96% was obtained even after 4000 galvanostatic charge/discharge cycles at current density of 5 A/g. This microwave approach is much more efficient than the conventional heating process to tune the electrochemical properties of AC. Copyright © 2016 John Wiley & Sons, Ltd.     

Preparation of activated carbon with low ash content and high specific surface area from coal in the presence of KOH

An activated carbon with ash content less than ]0% and specific surface area more than 1600 m^2/g was prepared from cool and the effect of K-containing compounds in preparation of cool-based activated carbon was investigated in detail in this paper. KOH was used in co-carbonization with coal, changes in graphitic crystallites in chars derived from carbonization of coal with and without KOH were analyzed by X-ray diffraction (XRD) technique, activation rates of chars with different contents of K-containing compounds were deduced, and resulting activated carbons were characterized by nitrogen adsorption isotherms at 77 K and iodine numbers. The results showed that the addition of KOH to the coal before carbonization can realize the intensive removal of inorganic matters from chars under mild conditions, especially the efficient removal of dispersive quartz, an extremely difficult separated mineral component in other processes else. Apart from this, KOH demonstrates a favorable effect in control over cool carbonization with the goal to form nongraphitizable isotropic carbon precursor, which is a necessary prerequisite for the formation and development of micro pores. However, the K-containing compounds such as K2CO3 and K20 remaining in chars after carbonization catalyze the reaction between carbon and steam in activation, which leads to the formation of macro pores. In the end an innovative method, in which KOH is added to coal before carbonization and K-containing compounds are removed by acid washing after carbonization, was proposed for the synthesis of quality coal-based activated carbon.     

以氢氧化钾替代氢氧化钠解决漏氯吸收装置碱液冬季结晶技术

针对保定中法供水有限公司原漏氯吸收装置中的中和碱液氢氧化钠,在空气中会吸收二氧化碳生成部分碳酸钠,形成大量结晶物,阻塞管道及泵腔,严重影响漏氯吸收装置运行的问题,找到了氢氧化钠的替代物氢氯化钾。实验结果表明,氢氯化钾在低温时能够有较高的溶解度,在空气中吸收二氧化碳之后生成的新物质,在低温和强碱环境中仍能拥有较高的溶解度,同时仍呈碱性并保持对氯的足够吸收能力。     

KOH/甲醇溶液中Pb电极上电化学还原CO2

化学转化CO2为更有价值的物质对于缓解大气中的温室气体极为重要.以Pb片为工作电极,石墨电极为对电极,银-氯化银电极为参比电极,研究了0.1 mol(L(1 KOH/甲醇电解液中电化学还原CO2的行为.结果表明,在所考察的范围内,常压下CO和甲酸生成的法拉第效率在258 K时最大,分别为9.62%和78.74%,常温加压条件下,CO2压力为1.2 MPa时CO和甲酸生成的法拉第效率最大,分别为13.93%和24.00%.进一步进行电极反应的动力学研究,得CO2电化学还原生成CO和甲酸的反应级数分别为0.573和0.671.     

宝钢沥青焦制备超级活性炭的研究

宝钢沥青焦具有灰分低、碳含量较高的特点,以宝钢沥青焦为原料,采用KOH活化法制备超级活性炭,并对其吸附性能进行测定。结果表明,该活性炭吸附性能优异,当活性炭碱碳比为4∶1和5∶1,活化温度为800℃时,碘、亚甲蓝、苯吸附值分别达到2 340mg/g～2 480mg/g、445mg/g～455mg/g、1 430mg/g～1 440mg/g,BET比表面积可达2 890m2/g～3 150m2/g,主要性能指标达到日本Marxsorb活性炭水平。试验表明,在制备超级活性炭的过程中,碱碳比是重要的影响因素,其次是温度。     

KOH活化丝瓜络制备高比表面积活性炭

为了探讨以丝瓜络为原料制备高比表面积活性炭的最佳条件,通过设计正交实验,研究了碱炭比、活化温度、活化时间和升温速率等因素对KOH活化丝瓜络制备活性炭性能的影响。结果表明：KOH活化丝瓜络制备活性炭的最佳条件为：碱炭比为4、活化温度800 ℃,活化时间30 min,升温速率10 ℃/ min。在此条件下制备的活性炭为多孔、非晶型的无定形碳,具有高的比表面积（3545 m2/g）和强的吸附性能,其碘值和亚甲基蓝值分别达到2926 mg/g和528.58 mg/g;为丝瓜络的高值化利用提供了一条有价值的途径。