Genetic diversity by AFLP analysis within Jatropha curcas L. populations in the State of São Paulo,Brazil

The genetic diversity of 5 populations of Jatropha curcas L. (Euphorbiaceae), a species cultivated in tropical countries and used in biodiesel production, was analyzed by amplified fragment length polymorphism (AFLP). Plants from distinct populations found in the State of São Paulo, Brazil, had their genetic diversity characterized by using three primer combinations. The number of polymorphic bands obtained reached 184 and the base pair length of bands ranged from 75 to 350, with average PIC values of 0.418. Accessions from the Aguas de Santa Barbara population presented the highest percentage of polymorphic loci (89.76%), followed by the populations of Catanduva (84.24%), Jales (80.98%), Jurucê (78.80%) and Taquaritinga (70.65%). Plants collected from the populations of Taquaritinga and Jales presented the smallest and highest genetic diversities, respectively, measured by using both Nei's genetic variability index (h = 0.2242 and 0.2973) and Shannon's index (I = 0.3359 and 0.4319). The results obtained indicated that 73.1% of genetic variability corresponds to intrapopulational variation and 26.8% to variation among populations. The clustering dendrogram using Jacquard showed four clusters. Three clusters with low genetic diversity grouped most of individuals collected in distinct regions (63.3% JU, 47.0% JA and 82.5% TA) and the fourth with the higher genetic diversity was composed with basically individuals collected in CA and AS, but it also had samples collected in JU, JA and TA, where it is possible to select individuals to be included in breeding programs.     

土壤中石油污染物的脱附过程

文章中主要采用有机溶剂萃取法（OSE）对高浓度石油污染土壤进行修复，经过精馏操作，有效回收原油，建立脱附等温曲线，研究了石油污染物在土壤-有机溶剂两相间的迁移规律。     

油气集输站场生活污水土地处理技术

通过对土地处理系统的介绍，结合油气站场污水的特点，分析了不同土地处理技术在实际中的设置情况和方式，给出一般的面积计算方法和结果，总结了土地处理的技术特点和应用前景。     

哈得4联合站技术改造

位于塔克拉玛干大沙漠腹地的哈得4油田,2004年成为全国最大的沙漠油田,2005年产量达到200×104t。在对联合站存在问题逐一分析的基础上,提出了技术改造的措施。现场采集的运行数据表明技术改造效果明显,增强了流程可靠性,提高了自动化水平,降低了能耗。     

带隔板底水油藏油井临界产量计算公式

本给出了带隔板底水油藏油井的监界产量计算公式，它适用于所有带隔板底水油藏的油井。     

地面油管漏失定量测试方法探讨

对油管漏失进行定量测试的方法确定具体漏失位置。方法运用双频道回声探仪探测动液面的原理和工作方法，根据油管漏失形成的死油坏在测试曲线上出现特殊波位置判断油管漏失位置。结果：经过７０多井次的现场试验，该方法具有较高的准确性和可靠性。结论：利用特殊波可以有效监测油管漏失，并具有推广使用价值。     

自旋式脱接器在临盘油田的应用

为保障临盘采油厂的大泵井正常生产 ,购进了自旋式脱接器。这种脱接器由上体和下体两部分组成 ,上体包括轨道管和轨道套 ;下体包括接头、挡圈、弹簧、滑套和中心杆。自旋式脱接器可在任意位置和角度对接和脱开 ,对接和脱开时只需下放和上提抽油杆柱即可完成。当泵砂卡时 ,左旋抽油杆柱即可脱开 ,解决了砂卡井脱接器不能脱开的难题。该脱接器可重复对接12 0次以上 ,耐疲劳寿命 7× 10 7次以上     

铝冷轧制油应用和生产工艺研究

通过对铝材冷轧工艺的分析。研究，以退火工艺中的斑痕为重点，提出采用加氢处理，异构化精制的石蜡基航空煤油组分为基础油，采用不同复合添加剂生产的通用铝冷轧制油完全可以满足客户要求。     

The impacts of a GTL plant on Brazil's oil products supply and refinery expansion

This paper assesses the impacts of a GTL plant on the expansion of Brazil's oil refining segment. The GTL plant (50,000 bpd) was sized to start up operations in 2015, producing diesel and naphtha through the indirect route (FT-synthesis). This plant will consume the non-associated natural gas production from the recent discoveries at the Santos Basin (around 419 Bm³), and the associated gas production from the Campos Basin. Both basins are located in the Southeast of Brazil, the most populated, rich and industrialized region of the country. Two different criteria for refinery expansion were simulated in order to meet oil product demand scenarios. Findings show that depending on the refinery expansion criteria considered GTL will play a fundamental hole to meet the oil product demand forecast to Brazil in the next 10 years.     

Influence of a lipid phase on steam jet agglomeration of maltodextrin powders

The contribution of an oil phase to the agglomeration mechanisms of food powders was evaluated. Maltodextrin (DE 10), palm oil stearin and two palm oil oleins (up to 25% dry mass) were used as food models. Granulation runs were carried out in a pilot plant steam jet agglomerator. The powders containing oleins were more cohesive than those with stearin and the presence of oil changed the agglomeration mechanisms. The size increase mechanism of pure maltodextrin powder was controlled by surface plasticization and agglomerates with suitable instant properties were obtained. Small amount of oil degenerated drastically the rate of dispersion in water of the powders and their agglomerates but the average size and the mechanical resistance of the agglomerates increased when the oil content of the powders increased. SEM micrographs of agglomerates indicated that higher lipid content in the powders produced compact granules, favoring sinkability but hindering their disintegration. Agglomeration enhanced considerably the flowability of the particles containing oil. The dispersion behavior of the powders with higher lipid content could be correlated with the Hausner Number. A pre-agglomeration step favored the blend of the more cohesive powders producing larger and more resistant agglomerates.