Tuning effect of silicon substitution on magnetic and high frequency electromagnetic properties of R2Fe17 and their composites

In this work, we report the tuning effect of the Si substitution on the magnetic and high frequency electromagnetic properties of R₂Fe₁₇ compounds and their paraffin composites. It is found that the introduction of Si can remarkably improve the magnetic and electromagnetic properties of the R₂Fe₁₇ compounds, making the R₂Fe_17–xSi_x-paraffin composites excellent microwave absorption materials (MAMs). By introducing the Si element, their saturation magnetizations decrease slightly, while much higher Curie temperatures are obtained. Furthermore, better impedance match is reached due to the decrease of the high-frequency permittivity ε′ by about 40%–50%, which finally enhances the performance of the microwave absorption. The peak frequency (f_RL) of the reflection loss (RL) curve moves toward high frequency domain and the qualified bandwidth (QB, RL ≤ ?10 dB) increases remarkably. The maximum QB of 3.3 GHz (12.0–15.3 GHz) is obtained for the Sm_1.5Y_0.5Fe₁₅Si₂-paraffin composite (d = 1.0 mm) and the maximum RL of ?53.6 dB is achieved for Nd₂Fe₁₅Si₂-paraffin composite (d = 2.2 mm), both surpassing most of the reported MAMs. Additionally, a distinguished dielectric microwave absorption peak is observed, which further increases the QB in these composites.     

金属材料中的稀土元素

本文论述了俄罗斯对稀土元素在高强度钢、高温合金、铝合金、镁合金、粉末冶金和磁性材料中的应用及其发展。     

聚乙烯转光棚膜的加工及应用研究

本文对聚乙烯转光棚膜的加工和光转换剂的作用、配比关系及物理性能进行了讨论。     

Sm~（3＋），Eu~（3＋），Tb~（3＋）等离子在低熔点玻璃中的光谱性质及

Ｓｍ￣（３＋），Ｅｕ￣（３＋），Ｔｂ￣（３＋）等离子在低熔点玻璃中的光谱性质及可见荧光的研究姜妍彦，王承遇，王继红（大连轻工业学院１１６００１）ＳｔｕｄｙｏｎＳｐｅｃｔｒａＰｒｏｐｅｒｔｉｅｓａｎｄＶｉｓｉｂｌｅＦｌｕｏｒｅｓｃｅｎｃｅｏｆＳｍ￣（３...     

涂料用稀土催干剂中稀土金属含量分析研究

在一定条件下，以ＥＤＴＡ为络合剂，以二甲酚橙为指示剂，用络合滴定法测定了涂料用稀土催干剂中稀土金属的含量。     

三聚氰胺氰尿酸盐阻燃聚氨酯硬泡

将三聚氰胺氰尿酸盐(MCA)作为阻燃剂,采用一步全水发泡法,制备一系列硬质聚氨酯泡沫/三聚氰胺氰尿酸盐复合材料(RPUF/MCA),采用扫描电子显微镜(SEM)、热重分析(TG)、极限氧指数(LOI)、UL-94垂直燃烧、烟密度测试、傅立叶红外光谱(FT-IR)及拉曼光谱表征,研究了MCA对硬质聚氨酯泡沫(RPUF)泡孔结构、热稳定性、阻燃性及燃烧烟气密度的影响。研究表明,MCA能够显著提高RPUF/MCA的阻燃性能,30份的MCA使RPUF/MCA30达到UL-94 V-1级别,极限氧指数达到22.0%。热重测试结果表明,MCA的添加使成炭率降低;同时发现,MCA的添加降低了RPUF/MCA泡沫复合材料的初始热分解温度和复合材料的燃烧烟气密度,有效地提高了复合材料火灾安全性能。     

不锈钢加铁稀土离子硫氮碳共渗工艺的研究

对1Cr18Ni12Mo2Ti奥氏体不锈钢在稀土催渗条件下进行了加与未加辅助铁板的离子硫氮共渗对比试验.试验表明:稀土具有很强的催渗作用.在与辅助铁板的共同作用下,可使奥氏体不锈钢的氮化温度降低60℃,减小了零件的变形;在相同的共渗温度条件下,可使氮化层深度比离子硫氮碳共渗增加30%以上,比未加辅助铁板的稀土离子硫氮碳增加10%.且稀土元素可渗入钢表层,细化渗层组织,促进氮碳化合物弥散细小析出,提高渗层硬度.     

The Al–R–Mg (R=Gd, Dy, Ho) systems. Part I: experimental investigation

Key experiments were carried out on the three Al–R–Mg (R=Gd,Dy,Ho) systems and the results obtained used for the thermodynamic optimisation reported in a separate paper in this issue [Caccasmani G, De Negri S, Saccone A, Ferro R. Intermetallics this issue.]. The samples were characterized by differential thermal analysis (DTA), X-ray powder diffraction (XRD), light optical microscopy (LOM), scanning electron microscopy (SEM) and quantitative electron probe microanalysis (EPMA). The isothermal sections at 400 °C are all characterized by extended homogeneity regions at a constant rare earth content. The extension of the (Mg,Al)R solid solution, cP2-CsCl type, varies with the R atomic number. Ternary compounds (τ) of Al₂(R,Mg) stoichiometry (hexagonal Laves phases with MgNi₂-type structure) have been found to exist at 400 °C in all the systems. Their temperatures of formation were detected by DTA measurements.     

稀土La对3Cr2W8V热作模具钢组织和性能的影响

研究了在3Cr2W8V热作模具钢中分别加入3种不同含量稀土La后,对组织、强度、硬度、冲击韧度和塑性的影响,并在相同的热处理工艺条件下,与不添加稀土La的3Cr2W8V钢进行对比。研究结果表明:稀土La加入量在适当的范围内可使组织得到明显细化,强度、冲击韧度和塑性有显著提高而硬度无明显变化,当稀土La加入量为0.20%时,3Cr2W8V钢可获得最好的综合力学性能。     

电刷镀Fe-Re对20CrMnTi钢疲劳性能的影响

通过20CrMnTi钢经电刷镀Fe-Re、电刷镀Fe和离子硫碳氮共渗处理的对比试验,分析了其疲劳前后的硬度变化、疲劳断口形貌、疲劳源的位置和过渡层的强度等问题.结果表明,20CrMnTi钢经Fe-Re电刷镀可显著提高弯曲疲劳强度,比电刷镀Fe和离子硫碳氮共渗分别提高了9.9%和21.9%,增加了刷镀层的厚度,提高了过渡层强度,并使疲劳源位置向心部推移,从而有效地增强了20CrMnTi钢的疲劳强度和超负荷持久性.