基于整体性视角的社区更新：框架、模式与案例 — —以佛山桂华邨社区为例

现行的政府单一主导、政府与开发 商合作的社区更新模式与业主的自主更新需 求产生了矛盾。针对现有研究对社区更新的 系统性缺乏关注的问题，本文从整体视角出 发，通过构建“参与主体—程序设计—法规 政策—资金调配”四维框架，分析现行社区 更新模式与业主自主更新需求产生冲突的内 在机制。在优化现有模式的基础上，提出三 种适应业主自主更新需求的理论模式。桂华 邨业主自主更新失败的实践案例证明了本文 所提出的四维框架的重要性。最后，从政府 视角对我国社区更新机制提出优化建议。     

Forging furnace with thermochemical waste-heat recuperation by natural gas reforming: Fuel saving and heat balance

This paper considers thermochemical recuperation (TCR) of waste-heat using natural gas reforming by steam and combustion products. Combustion products contain steam (H₂O), carbon dioxide (CO₂), and ballast nitrogen (N₂). Because endothermic chemical reactions take place, methane steam-dry reforming creates new synthetic fuel that contains valuable combustion components: hydrogen (H₂), carbon monoxide (CO), and unreformed methane (CH₄). There are several advantages to performing TCR in the industrial furnaces: high energy efficiency, high regeneration rate (rate of waste-heat recovery), and low emission of greenhouse gases (CO₂, NO_x). As will be shown, the use of TCR is significantly increasing the efficiency of industrial furnaces – it has been observed that TCR is capable of reducing fuel consumption by nearly 25%. Additionally, increased energy efficiency has a beneficial effect on the environment as it leads to a reduction in greenhouse gas emissions.     

Capture of Organic Vapors Using Adsorption and Electrothermal Regeneration

Activated-carbon-fiber cloth (ACFC) is an alternative adsorbent to granular activated carbon (GAC) for removing and recovering organic vapors from gas streams. Electrothermal desorption (ED) of ACFC provides rapid regeneration while requiring less energy compared to traditional regeneration techniques used with GAC. This paper provides proof-of-concept results from a bench-scale ACFC adsorption system. The automated system captured 1,000 ppmv of hazardous air pollutants/volatile organic compounds (HAPs/VOCs) from air streams and demonstrated the use of ED, using ac voltage, to recover the HAP/VOC as a pure liquid. The desorbed HAP/VOC condensed onto the inner walls of the adsorber and was collected at the bottom of the vessel, without the use of ancillary cooling. Seventy percent of the HAP/VOC was collected per cycle as condensate, with the balance being retained in the regenerated adsorber or recycled to the second adsorber. ED with in-vessel condensation results in minimal N2 consumption and short regeneration cycle times allowing the process to be cost competitive with conventional GAC-based adsorption processes. This technology extends the application of carbon adsorption systems to situations that were previously economically and physically impractical.     

炼油达标污水回用处理试验研究

采用曝气生物滤池、多介质过滤、超滤、反渗透工艺,对炼油达标外排污水进行回用处理中试试验。结果表明,曝气生物滤池对油、COD和浊度去除效果良好,超滤、反渗透膜化学清洗周期达到 2个月以上,脱盐率稳定在98％以上,产水品质达到回用要求。     

污水汽提系统的化学除臭清洗

文章简要介绍了化学除臭清洗剂JX-518的组成,并对采用该清洗剂对污水汽提系统进行化学除臭清洗的清洗过程及注意事项进行了详细介绍。实践证明,清洗后系统残液中硫化物及氨氮可降至很低,取得了很好的清洗效果。     

水溶液全循环法尿素装置中压分解"三种工艺"的比较

以生产数据结合理论计算的方法系统地比较、分析了水溶液全循环法尿素装置中中压分解“三种工艺”的热能利用、甲铵分解率、总氨蒸出率、水平衡量、一分加热器生产能力等方面的情况，提出应用和配置预分离-预蒸馏工艺的方法，评论该工艺在水溶液全循环法中的地位和作用。     

Oxidative regeneration of sulfided sorbent by H2S without emission of SO2

Much SO₂, another perilous air pollutant, was emitted during the oxidative regeneration of sulfided sorbent by H₂S. In order to prevent emission of SO₂, we carried out oxidative regeneration with the physical mixture of CaO and sulfided sorbent and investigated the effect of regeneration temperature and oxygen concentration on the reactivity of CaO with S0₂. The effluent gases were analyzed by G.C. and the properties of sorbent were characterized by XRD. SEM, TG/DTA and EPMA. Deterioration of reactivity of CaO with S0₂ resulted in increment of emission of SO₁₂ due to the structural changes of CaO above 750°C and that at 850°C was more severe. Furthermore EPMA and XRD analysis revealed that product layer diffusion through the solid product, CaSO₄, was the rate limiting step for CaO sulfidation. The reaction of CaO w:.th SO₂ was first order approximately and that was accelerated by high O₂ concentration.     

Comparison of Lactic Acid Productivities at High Substrate Conversions in a Continuous Two-stage Fermenter With Cell Recycle Using Different Kinetic Models

The steady-state performance of a two-stage recycle fermenter with two different types (I and II) of configurations for staging was investigated numerically for the continuous production of lactic acid. In Type I the bleed broth withdrawn from the first stage is supplied to the second fermenter, and in Type II both filtrate and bleed broth from the first stage are introduced to the second stage. Using four different kinetic models taken from the literature, the effects of operating parameters on the overall lactic acid productivities and the overall substrate conversions are examined. At moderate conversions, productivities for Type I operation are found to be higher than those for Type II and for the single-stage system. In the case of high conversions close to complete consumption, Type II operation is more efficient than the Type I and single-stage systems. For 99% conversion and 40 kg m^-3 substrate feed concentration, productivities for Type II are predicted to be 14-74% higher compared to those for the single-stage system at the same bleed ratios.     

Protoplast from <Emphasis Type="Italic">β</Emphasis>-carotene-producing fungus <Emphasis Type="Italic">Blakeslea trispora</Emphasis>: Preparation,regeneration and validation

The effects of key parameters on the preparation and regeneration of protoplast from the β-carotene-producing fungus Blakeslea trispora were discussed in this paper, including the combination of various enzymes, mycelial age, digesting time and temperature, pH value, osmotic stabilizers, pretreatment, culture medium and culture method. Under the condition of mixed enzymes in osmotic stabilizer (0.6 M NaCl) combined with 2% lysozyme, 3% cellulase and 3% snailase, the highest protoplast yield, as high as 7.48×106 protoplasts/mL, was obtained when mycelial age was 60 h at pH 5.0–6.0 with digesting for 14–16 h at 28 °C. After purification of the obtained protoplasts, they were regenerated in PDA regenerative medium using bilayer plate culture method. To validate the usability of the protoplasts, a novel plasmid with green fluorescent protein (GFP) was used in transformation for easy visual observation. The results showed that the protoplasts prepared by the optimized method were active and applicable in further gene manipulation experiments. This work was presented at 13 ^th YABEC symposium held at Seoul, Korea, October 20–22, 2007.     

啤酒废酵母干燥工艺设计的研究

该文设计了一套适用于年产量5万吨以上啤酒厂废酵母干燥的生产工艺，提出了设计要点，并对干燥工艺进行了适用性分析。