合成丁苯嵌段共聚物的影响因素

采用负离子溶液聚合方法制备了丁苯嵌段共聚物，研究了引发剂、活化剂、偶合剂、终止剂对聚合产物性能的影响。     

Experimental evidence of a relationship between monomer plasma residence time and carboxyl group retention in acrylic acid plasma polymers

Decreasing carboxyl retention in deposits from the glow region of an acrylic acid plasma was measured by X-ray photoelectron spectroscopy and chemical derivatisation as the collection distance from the monomer vapour inlet was increased. Volatilisation of plasma polymerised acrylic acid was detected after trifluoroethanol derivatisation; this is correlated with evaporation of low molecular weight components observed previously.     

十二酰胺丙基二甲基羟乙基氯化铵与十二烷基硫酸钠水溶液的表面吸附和胶束形成

利用十二酰胺丙基二甲胺和氯乙醇反应 ,合成了十二酰胺丙基二甲基羟乙基氯化铵 (DDHA)阳离子表面活性剂 ,将其与十二烷基硫酸钠 (SDS)以不同摩尔比进行混合 ,测定了混合系统的表面张力 ,计算了单一系统和混合系统的饱和吸附量、分子最小截面积 ,表面层和胶束中 DDHA的摩尔分率及分子间相互作用参数 ,目视观察了混合系统的浑浊情况。结果表明 :在降低γcmc和 cmc方面 ,DDHA SDS混合系统有协同效应 ,表面层和胶束的组成与二组分配比有关 ,但是非对称的 ,等物质的量混合物中 ,DDHA在胶束和表面层中具有较大的摩尔分数。DDHA与 SDS在实验测定的各混合系统中都不出现混浊     

CuMgAl类水滑石的制备和表征

用盐-碱制备法合成了CuMgAl三元类水滑石化合物。探讨了原料配比、合成方式、水热处理温度和时间对合成过程的影响,筛选出合成HTLcs的适宜条件,并对HTLcs结构的热稳定性进行初步研究。结果表明,制备HTLcs主要取决于pH值,同时由于Cu2+的姜-太勒效应,合成结构单一的CuMgAl类水滑石要求原料配比中n(Cu)∶n(Mg)不得超过1.0,CuMgAl-HTLcs热稳定性较差,300℃焙烧2h结构破坏,600℃开始烧结,在300~500℃之间,随焙烧温度提高所得复合氧化物比表面积增大,最高可达200 m2/g。     

Multi-site phase transfer catalyst assisted radical polymerisation of glycidyl methacrylate using potassium peroxydisulphate as initiator – a kinetic study

In this work, the kinetics and mechanism of free-radical polymerisation of glycidyl methacrylate (GMA) using potassium peroxydisulphate (PDS) as water soluble initiator in the presence of synthesized 1, 4-Bis (tributyl methyl ammonium) benzene dichloride (TBMABDC) as multi-site phase transfer catalyst (MPTC) was studied. The polymerisation reactions were carried out under inert and unstirred conditions at constant temperature of 60 ± 1°C in cyclohexane/water biphase media. The role of concentrations of monomer, initiator, catalyst and volume fraction of aqueous phase, solvent polarity and temperature on the rate of polymerisation (Rp) was ascertained. The order with respect to monomer and initiator was found to be unity. The order with respect to catalyst was found to be 0.51. The rate of polymerisation is independent of ionic strength and pH of the medium. However, an increase in the polarity of solvent has slightly increased the Rp value. Based on the results obtained, a suitable kinetic scheme has been proposed to account for the experimental observations and its significance discussed.     

苯并口恶嗪-环氧化合物-胺类催化剂体系开环聚合反应的研究

采用TLC，GPC，1H－NMR及IR等分析方法，对苯并恶嗪－环氧化合物－胺类催化剂体系的聚合反应进行了研究，表征了产物结构，并探讨了聚合反应机理，结果表明，苯并恶唪－环氧化合物体系在胺类催化剂如苄胺，咪唑的作用下，能发生开环聚合反应，生成低分子量的聚合物。     

甲基丙烯酸三氟乙酰氧乙酯的聚合

对甲基丙烯酸三氟乙酰氧乙酯(TFAOEMA)的阴离子聚合及原予转移自由基聚合进行了研究。常用的阴离于引发剂如丁基锂、1，1-二苯基已基锂等很难引发TFAOEMA的阴离子聚合，而碱性较弱的引发剂如三乙基铝却容易引发，且产率较高。以氯化亚铜、五甲基二乙基三胺、溴代丙酸乙酯为引发体系的TFAOEMA的本体原子转移自由基聚合符合活性聚合特征。但在四氢呋喃为溶剂的原子转移自由基聚合中却存在活性中心失活现象。以末端含卤素的聚甲基丙烯酸甲酯为大分子引发剂，引发TFAOEMA的原子转移自由基聚合，得到了含氟双嵌段聚合物。     

In-chain functionalization by alternating anionic copolymerization of styrene and 1-(4-dimethylaminophenyl)-1-phenylethylene

Anionic copolymerizations of styrene (M₁) with excess 1-(4-dimethyl-aminophenyl)-1-phenylethylene (M₂) were conducted in benzene at 25°C for 24h, using sec-butyllithium as initiator. Narrow molecular weight distribution copolymers with M?;_n = 16.1 × 10³ g/mol (M?_w/M?_n = 1.04) and 38.2 × 10³g/mol (M?_w/M?_n = 1.05), and 24 and 38 moles of M₂ per macromolecule, respectively, were characterized by size exclusion chromatography, ¹H NMR spectroscopy and DSC. The monomer reactivity ratio, r₁ = 5.6, was obtained from the copolymer composition at complete consumption of M₁, assuming that the rate constant k₂₂ =0,i.e. r₂ =0. The polymers exhibited T_g values of 128 and 119°C, respectively, which correspond to an estimated T_g = 217°C for the hypothetical homopolymer of M₂.     

Deposition mechanisms in langmuir-blodgett films

As part of a study of the possible application of polymerisable Langmuir-Blodgett (LB) films as ultra-fine-line e-beam resists, an investigation of the variation of film structure of 22-tricosenoic acid with differing deposition conditions has been made. Unexpected effects with significant implications for deposition speed and resist sensitivity have been observed, and the new techniques for film characterisation developed during the investigation have resulted in a revised model of deposition explaining the observed independence of the disorder causing optical scattering and the macroscopic features observed by polarised microscopy.     

Liquid–liquid extraction of a recombinant protein with reverse micelles

Recombinant cytochrome b₅ was extracted into the reversed micelle phase of an anionic surfactant (AOT) in octane and back-extracted to a final aqueous phase. The extraction of the protein was controlled by an electrostatic mechanism, since it was dependent on the global charge of the protein. This was directly demonstrated by experiments with native and mutant cytochromes obtained by site directed mutagenesis. The back-extraction of cytochrome b₅ to a fresh aqueous phase was decreased by factors that reduced the size of the water pool of the organic phase, such as high salt concentrations (1–2 mol dm^?3 NaCl) and low temperatures (4°C), probably because of an increase in a favourable interaction of this protein with the surfactant at closer distances.