垦71井区三维VSP资料波场分离方法应用研究

三维VSP资料是多偏移距VSP资料，资料中多种类型的波叠合在一起形成复杂波场。从复杂波场中分离出单一的保幅反射波波场是三维VSP波场分离的重要工作。常规二维VSP波场处理方法单一，难以适用于复杂的三维波场处理。针对三维VSP资料的波场特点，以分离上行反射P波为例，将单一波场分离方法加以适当组合，对垦71井区三维VSP实际资料进行了应用研究。结果表明，波场分离处理中叠加消去法和中值滤波相结合以及F—K滤波和中值滤波相结合的方法克服了单一方法的缺陷，波场处理后获得了波组特征明显、波场清晰单一的上行反射P波保幅波场，取得了较好的波场分离效果。     

High char‐yielding poly[acrylonitrile‐co‐(itaconic acid)‐co‐(methyl acrylate)]: synthesis and properties

Polyacrylonitrile terpolymers of various compositions consisting of acrylonitrile (AN), itaconic acid (IA) and methyl acrylate (MA) were synthesized by solution polymerization in dimethylsulfoxide. Increase in concentration of either IA or MA retarded the overall polymerization rate and the polymer molecular weight. The system consisting of AN + MA and varying IA concentration was more prone to retardation in comparison with the system composed of AN + IA with variable MA concentration. The retardation factors were quantified. Minor quantities of MA boost the reactivity of IA in the terpolymer system. The terpolymer was richer in MA vis‐à‐vis the feed. The thermal characteristics of the terpolymer were examined as a function of its composition. In contrast to the copolymer of AN and IA requiring 1–1.5 mol% IA, the terpolymer required an IA content of approximately 2.5 mol% for optimum thermal stability. The polymer with 90 mol% AN, 2.5 mol% IA and 7.5 mol% MA exhibited reasonably good char‐forming characteristics and thermal stability. The overall crystallinity and crystallite size of the polymers were found to decrease on incorporation of the comonomers. The ‘aromatization index’ of the copolymer increased with the temperature of pyrolysis through re‐organization of the tetrahydropyridine ladder structure. Copyright © 2005 Society of Chemical Industry     

制作矢量轮廓字库

本文介绍了一种如何从常见的点阵字库制作矢量轮廓字库的算法。算法采用了预处理、轮廓跟踪和轮廓逼近这三个主要步骤来制作每一个矢量文字，然后采用一种２字节的索引结构加以存储。     

树脂热解炭制备碳化硅晶须

用自制的配合醛树脂热解和炭源，用ＳＩＯ２超细汾作原，根据碳热还原原理，利用常规加热和微波加热两种方式，分别制备了直径在纳米级的ＳｉＣ晶须，Ｘ射线衍射、透射电检测结果表明：制备工艺和条件对ＳｉＣ晶须的性质有较大的影响。     

煤粉性状对残炭颗粒微结构及其燃烧特性的影响

本文研究了不同粒主工的烟煤和无烟煤经高温气流燃烧后残炭颗粒的形态及孔隙结构，对其燃烧方式和燃尽特性进行了讨论，并比较了两种煤的差别。结果表明，由镜质组形成的残炭表面和内部同时燃烧，并比较了两种煤的差别。结果表明，由镜质组形成的球残炭表面和内部时燃烧，容易燃尽；由惰性组形成的不规则残炭以外部反应为主，较难燃尽，同无烟煤相比，烟煤残炭孔隙多，燃烧剧列，且孔穴内部燃烧所占比重更大。     

Directions for improving manual fire suppression using a physically based computer simulation

The Swedish Fire Research Board and the U.S. Federal Emergency Management Agency are sponsoring a project to further the understanding of the basic mechanisms involved, as well as to support the development of standards for and to seek ways of improving the performance of portable fire suppression systems used by fire departments.This paper describes a physically based computer model developed to simulate one aspect of the problem: the manual suppression of postflashover fires. This includes: (1) an overview of the physical basis behind the model; (2) a comparison of model predictions with available experimental data, and (3) an analysis of fire suppression effectiveness using the model.The analysis concludes that, when direct access and extinguishment of the burning fuel is not possible, improved fire control occurs with water sprays having a Rosin-Rammler distribution of droplet sizes with volume-median-drop diameters in the 0.15 to 0.35 mm range. This agrees with available experimental data. It is also shown that fire fighting venting and standoff distance requirements may lead to more severe fires requiring more water for control; although venting and water spray induced air/gas flow also serve to channel hot steam and gases away from the fire fighter adding to his safety. The analysis also shows that allowing higher gas and surface temperatures at fire control through improved fire fighter protective clothing and equipment design reduces water flow rate requirements. Additional experimental work is recommended before all these conclusions are considered definitive. Reference: L. M. Pietrzak and G. A. Johanson, Directions for Improving Manual Fire Suppression Using a Physically Based Computer Simulation,Fire Technology, Vol. 22, No. 3, August, 1986, p. 184.     

Corrosion of Fe-10Al-Cr alloys by coal char

Corrosion of iron-base alloys at 982°C (1800°F) by coal char is observed and the phase morphologies are discussed. No sulfidation was observed at 50 hr exposure. After 100 hr internal aluminum-rich sulfides were observed along with thick outer scales of iron oxide. The species causing the hightemperature-induced corrosion are probably sulfides and sulfates, present in most coal chars. Possible mechanisms for the corrosion are also discussed.Department of Materials Science and Mineral Engineering.     

Chemoattraction between fry of Arctic char [Salvelinus alpinus (L.)] studied in a Y-maze fluviarium

Attraction of fry of Arctic char [Salvelinus alpinus (L.)] to water conditioned by conspecifics of the same age was studied in a Y-maze fluviarium. Two types of experiments were run. In up-swimming tests (1), starting from the common leg of the Y-maze, a single fish was given the choice of entering one of the two upstream arms. In gradient tests (2), the momentary positions of a single char were time-lapse photographed in a test yard of this common shank. Strong attraction to conditioned water was observed in both types of tests.     

用热重技术研究煤焦的燃烧特性

本文评述了热重技术在煤焦燃烧特性研究方面的发展，分析了不同研究者提出的反应性概念、动力学处理方法及研究结果，指出了煤焦燃烧领域的研究方向。     

煤焦水蒸气气化特性及动力学研究

运用等温热重法，对三种不同的煤焦，在反应温度900℃～1200℃之间进行水蒸气气化实验。分别考察了常压下反应温度、水蒸气分压和煤种对反应的影响；并且对不同煤焦的反应进行动力学计算，求取动力学参数，研究发现，煤焦水蒸气的反应与煤焦—CO2的反应相比速率要快得多，并且随反应温度升高，反应速率急剧增大。