Effect of Moving Speed of Charged Metallic Spherical Electrode on Electrostatic Discharge

In this investigation, the nature of the electrostatic discharge (ESD) that occurs when a charged object moves toward a stationary grounded object is experimentally clarified. The spark lengths, discharge currents, and induced voltages in a magnetic probe were measured when a charged metallic spherical electrode connected to a 422 pF capacitor approached a stationary grounded object, which was the current target, for different moving speeds of the charged metallic spherical electrode in a range of 1 mm/s to 100 mm/s. The charge voltages of the capacitor were +6.5 kV and +10 kV. Based on the results, the average gap length shortened with the speed of the spherical electrode. The average peak values of the discharge current and the induced voltage were likely to increase with the speed of the spherical electrode. The average rise times of the discharge current and the induced voltage were likely to drop with the speed of the spherical electrode. The relation between the spark length and the discharge current due to the ESD can be explained qualitatively by using an equation derived from the spark resistance formula proposed by Rompe and Weizel.     

超声波强化原油破乳电脱盐技术的工业实践

报道了采用超声波强化原油破乳电脱盐技术的开发与工业应用.经过实验室开发确定的超声波强化原油破乳电脱盐专利技术--超声波-电场联合破乳脱盐组合技术采用顺逆流方式.该技术于2003年9月在齐鲁分公司完成工业应用试验后,超声波强化原油破乳设备直接投入生产运行,在不加入化学破乳剂的情况下,可使胜利混输原油(平均盐浓度为50 mg/L,平均水质量分数为0.5%～1.0%)脱后盐浓度低于3 mg/L,水质量分数小于0.3%.     

MPTA型原油脱金属剂的工业应用

在对高金属含量原油进行初步评价的基础上，利用SH—Ⅰ型电脱盐试验仪对自主开发的MPTA型原油脱金属剂进行了原油脱金属的实验室研究。结果表明，当MPTA型脱金属剂加入量为250μg／g时，钙的脱除率可达97．4％，并且对其它金属元素，如镍、铁、钠、锰、铝和钒也有明显的脱除效果。该剂在山东恒源石油化工股份有限公司重交沥青车间500kt／a的电脱盐装置上进行原油脱金属工业试验的结果表明，经过二级电脱盐处理后，钙的脱除率达到99．1％，钠的脱除率为94．6％，铁的脱除率为82．9％，并可在一定程度上降低原油中镍和铜的含量。使用MPTA型原油脱金属剂显著降低了一、二级电脱盐装置的电场电流，有利于炼油厂的节能降耗。     

硅微机械梳齿静电谐振器的建模与分析

基于参数化的计算机辅助设计（CAD）软件，对硅微机械梳齿静电谐振器进行了实体建模，以有限元分析软件为工具，进行了谐振器的模态分析，静态分析和谐响应分析，初步揭示了谐振器的静、动态特性，有助于改善设计效率和质量，展示了计算机辅助工程（CAE）技术在微机电系统（MEMS）研究中的重要作用。     

ZRS-6.72-3型电收尘器技术改造

ZRS-6．72—3型电收尘器原设计用于13．8kt／a锌冶炼烟气收尘制酸工艺中，因电收尘器使用时间长，电源控制柜故障率高和沸腾炉扩大更新，对电收尘器同步进行配套技术改造。改造为CRS-8．24—3型电收尘器后，又陆续使用了HL-Ⅲ型恒流源控制电柜，投产后的电收尘器具有收尘效率高、电场运行稳定等特点。     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

现代通信产品静电防护技术导则

本导则提出了电子通信设备机房内静电荷的产生根源及静电放电对其设备正常运行的影响机理，提出机房内环境装修的静电防护措施及静电防护操作等，从而达到有效地控制静电荷的，确保电子通信设备安全可靠运行。本导则适用于以集成电路为核心的现代通信设备机房的设计和管理。     

聚电解质溶液分子热力学模型

<正>链状聚电解质由于是长链大分子又有很高的电荷密度,其溶液即使在极低的浓度下仍具有很强的负偏差,与Debye-Huckel理论预测的结果相去甚远。工程上使用的Manning模型认为聚离子的电荷密度有一临界值,当超过临界值时,反离子即凝聚在聚离子表面使其实际电荷密度降至临界值。Nagvekar等在该模型的基础上引入NRTL方程,以计及短程相互作用的贡献。Manning等的方法虽然有一定的物理意义,但临界值的确定缺乏可靠的根据。     

离子静电水处理技术在循环冷却水中的应用

简要介绍了离子静电水处理技术杀菌、灭藻、防垢阻垢的机理，及在循环冷却水系统中的应用情况。