Effect of stoichiometry and Cu-substitution on the phase structure and hydrogen storage properties of Ml-Mg-Ni-based alloys

To improve the electrochemical properties of rare-earth–Mg–Ni-based hydrogen storage alloys, the effects of stoichiometry and Cu-substitution on the phase structure and thermodynamic properties of the ...     

RF磁控溅射制备钛酸锶钡BST纳米薄膜

钛酸锶钡(BST)薄膜作为一种高K介质材料在微电子和微机电系统等领域具有广阔的应用前景,人们已对BST薄膜的制备工艺技术和介电性能进行了大量的研究。BST纳米薄膜的制备工艺直接影响和决定着薄膜的介电性能(介电常数、漏电流密度、介电强度等)。对RF磁控反应溅射制备BST纳米薄膜的工艺技术进行了综述。从溅射靶的制备、溅射工艺参数的优化、热处理、薄膜组分的控制,及制备工艺对介电性能的影响等方面,对现有研究成果进行了较全面的总结。     

SHS of shape memory CuZnAl alloys

Aiming at preparation of shape memory alloys (SMAs), we explored the SHS of Cu_{1 − x} Zn_{1 − y} Al_{1 − z} alloys (0.29 < x < 0.30, 0.74 < y < 0.75, and 0.83 < z < 0.96). The most pronounced shape memory effect was exhibited by the alloys of the following compositions (wt %): (1) Cu(70.6)Zn(25.4)Al(4.0), (2) Cu(70.1)Zn(25.9)Al(4.0), and (3) Cu(69.9)Zn(26.1)Al(4.0). The effect of process parameters on the synthesis of CuZnAl alloys was studied by XRD, optical microscopy, and scanning electron microscopy (SEM). The grain size of CuZnAl was found to depend on the relative amount of the primary CuZn and AlZn phases. Changes in the transformation temperature and heat of transformation are discussed in terms of ignition intensity and compaction. Mechanism of the process depends on the level of the temperature attained relative to the melting point of components. At the melting point of AlZn, the process is controlled by the solid-state diffusion of AlZn into a product layer. The ignition temperature for this system depends on the temperature of the austenite-martensite transformation in CuZnAl alloys. The composition and structure of the products was found to markedly depend on process parameters. The SHS technique has been successfully used to prepare a variety of SMAs.      

X射线三轴晶衍射法测量半绝缘GaAs单晶的化学配比

采用X射线三轴晶衍射法,根据As间隙原子对作为过量As在GaAs单晶材料中存在的主要形式的模型,可以无损、高精度测量半绝缘GaAs单晶的化学配比.并探讨了引起晶格变化的原因及其与熔体组分的关系,对于制备高质量GaAs单晶及其光电器件具有重要的意义.     

Internal drift effects on the diffusion of Ag in CdTe

Anomalous diffusion profiles of Ag in single crystalline CdTe were observed using the radiotracer ¹¹¹Ag. The diffusion anneals were performed at 800 K under Cd or Te vapor and in vacuum with low Ag concentrations. The measured Ag profiles directly reflect the distribution of the self-interstitials and vacancies of the Cd sublattice and are the result of chemical self-diffusion which describes the variation of the deviation from stoichiometry of the binary crystal as a function of depth and time. It turned out that the spread of the Ag dopant essentially is determined by the drift of the charged defects within the electric field caused by the distribution of the extrinsic and intrinsic defects.     

The Effect of Organic Diluent on the Extraction of Eu(III) by HEH[EHP]

ABSTRACT

Because there are fewer tools available to probe the interactions therein, the effect of the fundamental chemistry of the organic diluent on solvent extraction equilibria has been under-characterized relative to the aqueous. As a result, diluents for solvent extraction are often selected for an application not for their utility as a medium for reaction, but for other (often equally) important reasons (like low flammability). To begin to improve this imbalance in the science, twenty different diluents have been used in a study of the extraction of radiotracer ^152/154Eu³⁺ from dilute nitric acid solutions using the extractant 2-ethylhexylphosphonic acid mono-2-ethylhexyl ester (HEH[EHP]). To increase the utility of the study and to honor the memory of Professor Jan Rydberg, this investigation was conducted by a cadre of comparatively inexperienced separation scientists (who are as a result no longer inexperienced separation scientists) as a radioanalytical chemistry and solvent extraction educational exercise. Slope analysis was used to determine the apparent stoichiometry of the extracted metal complex. The results discussed in the following indicate that, while the pH dependence exhibits the expected three H⁺ exchanged per metal ion extracted, the extractant dependence suggests that the number of protonated extractant molecules in the extracted complex changes with the organic diluent. The experimentally observed “extractant dependency” ranges from 2.5 to 3.0 dimer equivalent molecules per extracted metal ion. Ironically, in the diluents exhibiting the highest apparent M:(HA)₃ stoichiometry, HEH[EHP] extracts Eu³⁺ less efficiently. Europium luminescence spectroscopy was used to probe for changes in the first coordination sphere of the complex in different diluents. A model and conceptual framework for understanding these observations is described.     

Loss of Curing Agent During Thin Film (Droplet) Curing of Thermoset Material

Recently, it has been reported by our group and others^1.2 that loss of curing agent is encountered during the curing of small droplets or thin films of amine cured epoxies. In our earlier study³ results were reported on loss of curing agent in small droplets used in conducting the rnicrobond, single fiber test for determination of interfacial shear strength (ISS). It was reported that use of a volatile curing agent (meta-phenylene diamine (m-PDA) with DGEBA resin) resulted in increasing amounts of curing agent being lost (as measured by T₈ of the cured droplets) with decreasing droplet size during the processing procedure. Droplets smaller than 150 micrometers were seen to lose up to 40% of the curing agent leading to alteration of the mechanical properties of the droplet and, therefore, causing measured values of ISS to be exceedingly low. Use of a less volatile curing agent (Jeffamine 700, a polyether diamine, Texaco Specialty Chemicals) in combination with DGEBA resin produced results which indicated that loss of curing agent was not occuring. This study was undertaken to show the relationships between film (or droplet) size and the amount of curing agent lost (during the processing) for three different aminecured epoxy systems.     

Quantitative mass spectrometry to investigate epidermal growth factor receptor phosphorylation dynamics

Identifying proteins of signaling networks has received much attention, because an array of biological processes are entirely dependent on protein cross-talk and protein-protein interactions. Protein posttranslational modifications (PTM) add an additional layer of complexity, resulting in complex signaling networks. Of particular interest to our working group are the signaling networks of epidermal growth factor (EGF) receptor, a transmembrane receptor tyrosine kinase involved in various cellular processes, including cell proliferation, differentiation, and survival. Ligand binding to the N-terminal residue of the extracellular domain of EGF receptor induces conformational changes, dimerization, and (auto)-phosphorylation of intracellular tyrosine residues. In addition, activated EGF receptor may positively affect survival pathways, and thus determines the pathways for tumor growth and progression. Notably, in many human malignancies exaggerated EGF receptor activities are commonly observed. An understanding of the mechanism that results in aberrant phosphorylation of EGF receptor tyrosine residues and derived signaling cascades is crucial for an understanding of molecular mechanisms in cancer development. Here, we summarize recent labeling methods and discuss the difficulties in quantitative MS-based phosphorylation assays to probe for receptor tyrosine kinase (RTK) activity. We also review recent advances in sample preparation to investigate membrane-bound RTKs, MS-based detection of phosphopeptides, and the diligent use of different quantitative methods for protein labeling.     

气相色谱结合化学计量在核桃油、菜籽油掺伪混合物含量判别分析中的应用

目的：识别核桃油中同时掺入多种其他植物油的多元掺伪。方法：采用气相色谱技术分析核桃油、菜籽油掺伪混合物中脂肪酸含量,结合化学计量方法对气相色谱数据进行建模,并对不同比例核桃油、菜籽油混合物进行判别分析。结果：主成分分析法（PCA）能快速鉴别出纯核桃油和掺伪核桃油,并在一定程度上反映样本的掺伪比例;Bayes判别分析将83.33%的样品归入正确的分类;偏最小二乘判别分析法（PLS-DA）的判别准确率达87.50%;基于BP神经网络模型的判别分析,其训练集的正确率为84.21%,测试集的正确率为80.00%;基于遗传算法优化支持向量机（SVM-ga）的判别分析,其训练集和测试集的正确率均为100%。结论：多种分析模型均能不同程度地识别核桃油、菜籽油掺伪比例,其中SVM-ga模型的预测精度最佳。     

Influence of fuel composition on chemiluminescence emission in premixed flames of CH4/CO2/H2/CO blends

The growing concern about pollutant emissions and depletion of fossil fuels has been a strong motivator for the development of cleaner and more efficient combustion strategies, such as the gasification of coal, biomass or waste, which have increased the interest in using a new type of fuels, mainly composed of CH₄, H₂, CO and CO₂.These new fuels, commonly called syngas, display a wide range of compositions, which affects their combustion characteristics and, in some cases, are more prone to instabilities or flashback. Since flame properties have been demonstrated to be strongly related to equivalence ratio, a precise measurement of the flame stoichiometry is a key pre-requisite for combustion optimization and prevention of unstable regimes. In particular, chemiluminescence emission from flames has been largely tested for stoichiometry monitoring for methane flames, but its use in syngas flames has been far less studied. Consequently, the main goal of this work is analyzing the effect of fuel composition on the chemiluminescence vs. equivalence ratio curves for different fuel blends, as a first approach for a wide range of syngas compositions. The experimental results revealed that the ratio OH*/CH*, which had been widely demonstrated to be the best option for methane, may not be suitable for monitoring with certain fuels, such as those with a high percent of hydrogen. Alternatively, other signals, in particular the ratio OH*/CO₂*, appear as viable stoichiometry indicators in those cases.The analysis was also completed by numerical predictions with CHEMKIN. The comparisons of calculations with different flame models and experimental data reveals differences in the chemiluminescence vs. equivalence ratio curves for the different combustion regimes, depending on the range of the equivalence ratio ranges and fuel compositions. This finding, which confirms previous observations for a much narrower range of fuels, could have important practical consequences for the application of the technique in real combustors.