Study on the relationship between the particle size distribution and the effectiveness of the K‐powder fire extinguishing agent

The relationship between the particle size distribution and the extinguishing effectiveness of the new K‐powder fire extinguishing agent has been studied experimentally, to explore the reason of the great extinguishing efficiency exhibited by the new K‐powder fire extinguishing agent on Class B fire (liquid fuel fire). The results of the experiment showed that the extinguishing effectiveness increased along with the decrease of the particle size distribution. In addition, a sharp discontinuity appeared around the limiting size, about 40 μm. The powder with the particle size below 40 μm exhibited highly effective extinguishing with the minimum effective extinguishing concentration C_xr = 23 g·m^?3, while the powder with the particle size above 40 μm exhibited little fire extinguishing efficiency. Compared with other fire extinguishing agents produced by different substances, the new K‐powder fire extinguishing has the bigger limiting size. That means, in the same particle size distribution, the new K‐powder fire extinguishing agent contains more highly effective powder than others contain, and is more effective.     

大直径平底负压容器优化设计

通过对大直径平底负压容器平底板的设计计算,平底板计算厚度很厚。通过分析,提出了对平底板采取加强措施,从而减薄平底板计算厚度的方法。该容器在实际生产过程中性能可靠、稳定,对类似设备设计具有借鉴意义。     

Reducing treatment zone diameter in orthokeratology and its effect on peripheral ocular refraction

PurposeTo determine whether orthokeratology (OK) induced treatment zone (TZ) diameter can be reduced by altering OK lens design, and if so the impact of modifying TZ diameter on relative peripheral refraction (RPR).Methods16 subjects (mean age 23.4 ± 1.5 years; 8 female) completed the study. Standard (Control) OK lens design (PJ, Capricornia, Australia) or a modified version (Test) where the back optic zone diameter was reduced, and back optic zone asphericity and intermediate lens curves were altered, were worn overnight only for 7-nights in a randomised double masked order, with a minimum 1-week wash out (no lens wear) between lens designs. Full correction of refractive error was targeted. Refraction; best corrected visual acuity (BCVA); RPR (Shin-Nippon NVision-k 5001) along the horizontal and vertical meridians; and corneal topography (Medmont E300) were measured before starting lens wear and in the morning after lens removal after the seventh night of lens wear for both lens designs. TZ diameter and decentration was calculated from corneal topography.ResultsAfter 7-nights of wear both lens designs created -2.00D refraction effect with no significant difference in refractive effect or change to BCVA between the designs. The Test design created a significantly smaller horizontal (4.78 ± 0.37 vs 5.70 ± 0.37 mm, p < 0.001) and vertical (5.09 ± 0.51 vs 5.92 ± 0.51 mm p < 0.001) TZ diameter. The TZ was decentered inferior temporal with no significant difference between designs. There was no significant difference between the lens designs in RPR along the horizontal and vertical meridians at any measurement period.ConclusionsOK induced TZ diameter can be reliably reduced by altering OK lens design without detrimentally effecting lens centration or refractive effect. Reducing TZ diameter did not alter RPR, though measurement artifacts could be responsible for masking an effect. Longitudinal studies are needed to assess whether smaller TZ OK lens designs increase efficacy for slowing progression of myopia.     

浅析火力发电厂汽水系统中内径管与外径管的设计选择

按照管道加工工艺的不同,管道可分为内径控制管和外径控制管。通过热轧工艺生产的外径控制无缝钢管,可满足火力发电厂汽水系统中绝大部分管道的使用要求。对于超(超)临界机组的主蒸汽和高温再热蒸汽管道采用的P91/P92材质的大口径厚壁无缝钢管,由于对材料性能和加工工艺有特殊要求,因此宜采用内径控制管。     

积极降压对脑小血管病防治策略的影响

2017年,美国心脏病学会和美国心脏协会提出将高血压诊断标准降为130/80 mm Hg (1 mm Hg=0. 133 kPa),这与其他指南有所不同。降压治疗的核心目标在于靶器官的保护,近年来降压治疗与脑小血管病预防的相关问题日益受到临床重视。目前研究结果表明,降压治疗对腔隙性卒中患者的二级预防以及白质病变进展的预防可能有一定积极意义,但确切的降压目标值并未确定。血压与临床结局可能呈现J型关系,血压过低或过高可能均有害,而取得最大获益的降压目标有待进一步探索。     

简体接管边缘应力区局部减薄处应力特征

参考《压力容器定期检验规则》第40条,采用有限元方法计算了筒体接管边缘应力区局部减薄处的应力分布,得到了局部减薄处凹坑的尺寸与位置对应力的影响趋势,讨论了应力集中系数随尺寸变化的规律,为筒体接管边缘应力区局部减薄处的强度评定提供了一定的计算依据。     

一种估算单桩经济直径的方法

在滩海油田开发过程中,经常需要设立立管桩,在环境荷载的作用下,立管桩顶部会发生位移,较大的位移对立管及栈桥的安全很不利,因此需要合理确定单桩的直径。埕岛油田在确定单桩直径时引入了经济直径的概念,文章对经济直径的原理进行了分析,给出了桩顶位移和桩径经济指数计算公式,并举例进行了计算,得出了桩径与桩顶位移及桩径经济指数的关系曲线, 进而求得经济桩径的取值范围。文章还对该方法的优缺点进行了分析。     

Efficient Parallel Algorithms for Some Graph Theory Problems

In this paper,a sequential algorithm computing the aww vertex pair distance matrix D and the path matrix Pis given.On a PRAM EREW model with p,1≤p≤n^2,processors,a parallel version of the sequential algorithm is shown.This method can also be used to get a parallel algorithm to compute transitive closure array A^* of an undirected graph.The time complexity of the parallel algorithm is O(n^3/p).If D,P and A^* are known,it is shown that the problems to find all connected components,to compute the diameter of an undirected graph,to determine the center of a directed graph and to search for a directed cycle with the minimum(maximum)length in a directed graph can all be solved in O(n^2/p logp)time.     

螺旋焊管在线自动测径装置

螺旋焊管在线测径是生产高标准焊管的重要检测装置，可以实时监控钢管管径。选用CCD传感器与计算机连接，组成钢管测径装置，能够较好地达到对钢管管径实时监控的目的。     

中小型渔船制冷技术的研究进展

远洋渔船带有制冷装置，而100吨以下的中小型渔船因其柴油机的限制，无法安装压缩机式制冷机。出海作业时，均需携带冰块做渔产保鲜。本文介绍压缩式渔船制冷的现状，回收渔船尾气余热的吸收式制冷系统，吸附制冷的冷冻水系统，吸附式制冰系统等实验装置。其中吸附式制冷系统具有良好的开发价值。