加强电站无功管理

加强电站无功管理，不但能改善供电质量，满足电网的要求，提高单位的经济效益，而且使设备的安全运行得到了保障。     

Joint scheduling and power control supporting multicasting in wireless ad hoc networks

This paper addresses the problem of power control in a multihop wireless network supporting multicast traffic. We face the problem of forwarding packet traffic to multicast group members while meeting constraints on the signal-to-interference-plus-noise ratio (SINR) at the intended receivers. First, we present a distributed algorithm which, given the set of multicast senders and their corresponding receivers, provides an optimal solution when it exists, which minimizes the total transmit power. When no optimal solution can be found for the given set of multicast senders and receivers, we introduce a distributed, joint scheduling and power control algorithm which eliminates the weak connections and tries to maximize the number of successful multicast transmissions. The algorithm allows the other senders to solve the power control problem and minimize the total transmit power. We show that our distributed algorithm converges to the optimal solution when it exists, and performs close to centralized, heuristic algorithms that have been proposed to address the joint scheduling and power control problem.     

Analysis of spontaneous electrochemical oscillations by energy distribution technique

Analysis of non-stationary electrochemical oscillations emerges utilization of the techniques allowing an observation of time evolution of their parameters such as instantaneous frequency, amplitude or frequency band. An algorithm of extraction of these parameters can be based on one of linear or quadratic time-frequency representations of oscillations record. In this paper, the authors present representatives of such transformations (Choi-Williams and Cone-shaped) originating from one of the most popular joint time-frequency energy distribution—Wigner-Ville distribution. Short introduction to the mathematics of the topic discussed is provided, then the authors present an example of application in the analysis of current oscillations of copper dissolution process.     

Failure analysis of aluminum cable steel reinforced (ACSR) conductor of the transmission line crossing the Paraná River

The failure of the conductor of the 460 kV overhead transmission line located along the crossing of the Paraná River was investigated. As a result of this failure, a blackout took place in the southern states of Brazil in January of 2002, reaching approximately 67 million inhabitants. Investigation of the external aluminium layer of the ACSR conductor near the fracture showed typical static deformation marks and dynamic fretting wear tangential marks, both associated with the presence of Al₂O₃ debris. Additionally, encrusted silicon particles were observed on the external surface of the strands. The internal Al layer showed elliptical deformation marks also associated with Al₂O₃ debris. Both Al₂O₃ and Si particles are efficient abrasive material, which associated with slight relative motion of metallic surfaces (clamp/strand and strand/strand) can promote fretting wear. Two types of fracture surface of the Al strands were identified: 45° and quasi-normal surfaces, the former being the predominant type. Delamination and particle detachment were the mechanisms of superficial degradation observed on the Al strands, indicating that the rupture of the strands occurred under a gross slip fretting regime induced by sub-conductor oscillation. Inspection of the internal surface of as-cast Al–10%Si spacer clamps revealed different stages of intense circumferential wear caused by the preferential cracking and particle detachment of the eutectic constituent of the as-cast microstructure. This intense wear reduces the clamping contact pressure, which allows higher displacement amplitude and leads to the critical fretting regime. Finally, a few suggestions are discussed to minimise the occurrence of future failures.     

提高集聚纺纱效率的可行性研究

本文主要讨论了精梳工序和普梳工序对集聚纺纱线质量和加工效率影响的测试结果。     

钻机柴油机的动向和190系列柴油机的发展

本文概括介绍了国内外钻机柴油机发展的水平及动向,比较了国内钻机柴油机与国外钻机柴油机在发展上的差距。重点介绍了作为国产钻机主要动力的190系列柴油机的发展状况及最新技术在该机型上的应用。     

环锭细纱机减少成纱毛羽的对策

通过对环锭细纱机成纱毛羽的成因分析 ,提出减少成纱毛羽的措施。     

关于变压器二次额定电压的计算

推导了变压器二次负载电压的计算公式,建议由此公式代替以往原理书中惯用的近似公式。利用此公式绘制和分析了不同功率因数额定负载时的相量轨迹图。     

浅谈21世纪新建电厂热控系统的规划设计

为了适应电力工业发展和国家新兴产业政策的需要,本文扼要介绍了21世纪新建电厂在热控系统的规划设计方面应做的改进和注意的问题.并在此基础上阐述了一些个人的观点和看法供管理、设计和技术人员参考.