Cyberbullying: Effect of emergency perception on the helping tendencies of bystanders

The effect of the emergency perception of bystanders of cyberbullying victims on helping behaviors is often neglected in research on cyberbullying. In this study, we explored the influence of this cognitive factor on cyber-bystanders’ helping tendencies as well as elucidated possible underlying processes. The results of two studies were reported. In Study 1, 150 undergraduates read a true case of a girl experiencing cyberbullying. The results indicated that when the participants perceived the victim’s situation to be more critical (i.e., higher emergency perception), their helping tendencies were stronger, partly through increased state empathy followed by feelings of responsibility to help. In Study 2, we randomly assigned 300 undergraduates to two groups. The low emergency group read the same cyberbullying case as Study 1, whereas the cyberbullying case read by the high emergency group contained additional emergency information of the victim. The results indicated that the high emergency group expressed stronger helping tendencies than did the low emergency group. This effect was caused by a stronger perception that the victim was in an emergency situation, which not only strengthened the participants’ helping tendencies directly but also indirectly through increasing their state empathy and feelings of responsibility to help.     

A distributed state estimation method for power systems incorporating linear and nonlinear models

High-voltage transmission networks are commonly equipped with phasor measurement units (PMU), and some of them are PMU observable. However, PMUs are seldom installed in distribution networks due to budget limitations. The state estimation equations of PMU observable areas are linear, while those of other areas remain nonlinear. This paper proposes a new distributed state estimation method for solving multi-area state estimation problems, in which linear models are used for high-voltage transmission network, while nonlinear models are adopted for other areas. In PMU observable area, we select coordinating variables as generalized cost functions which accurately represent the sensitivity between the linear SE objective function and boundary states. Consequently, SE results identical to a centralized estimator can be obtained without iterations at the coordination level. This paper presents the problem model and theoretical analysis of the proposed method, and shows its effectiveness by numerical tests.     

A design of a robust discrete-time controller

In this paper, we proposed a robust discrete-time controller. This control system, which is derived from the idea of the normalized plant, does not include plant parameters. Thus, we obtain a control system independent of plant parameters and that has the same structure as a conventional optimal servo control system. Simulation and experimental results show that the proposed method is fairly robust to plant parameter variations and external disturbances.     

Tuning effect of silicon substitution on magnetic and high frequency electromagnetic properties of R2Fe17 and their composites

In this work, we report the tuning effect of the Si substitution on the magnetic and high frequency electromagnetic properties of R₂Fe₁₇ compounds and their paraffin composites. It is found that the introduction of Si can remarkably improve the magnetic and electromagnetic properties of the R₂Fe₁₇ compounds, making the R₂Fe_17–xSi_x-paraffin composites excellent microwave absorption materials (MAMs). By introducing the Si element, their saturation magnetizations decrease slightly, while much higher Curie temperatures are obtained. Furthermore, better impedance match is reached due to the decrease of the high-frequency permittivity ε′ by about 40%–50%, which finally enhances the performance of the microwave absorption. The peak frequency (f_RL) of the reflection loss (RL) curve moves toward high frequency domain and the qualified bandwidth (QB, RL ≤ ?10 dB) increases remarkably. The maximum QB of 3.3 GHz (12.0–15.3 GHz) is obtained for the Sm_1.5Y_0.5Fe₁₅Si₂-paraffin composite (d = 1.0 mm) and the maximum RL of ?53.6 dB is achieved for Nd₂Fe₁₅Si₂-paraffin composite (d = 2.2 mm), both surpassing most of the reported MAMs. Additionally, a distinguished dielectric microwave absorption peak is observed, which further increases the QB in these composites.     

A note on the value function for constrained control problems

We consider the Mayer optimal control problem with dynamics given by a nonconvex differential inclusion, whose trajectories are constrained to a given set and we obtain a relation between the costate function that appears in the maximum principle and the value function. This relation extends the known conditions existing in the literature for unconstrained problems to those for problems under state constraints.     

具有完整性的状态反馈控制

本文基于矩阵方程解，提出了一种开环稳定系统反馈的设计方法，所设计的系统对任意传感器失效具有完整性。     

用于机器人轨迹定位纠正系统的回声状态神经网络研究

循环神经网络(RecurrentNeuralNetworks)是人工神经网络(ArtificialNeuralNetworks)中重要的分支,与前馈神经网络(ForwardNeuralNetworks)相比具有更好的时间序列学习能力。但长期以来其学习法一直不能脱离前馈神经网络而自成一体,回声状态神经网络(EchoStateNetworks(ESN))是打破这一局面的全新学习方法。其独特的结构,良好的短期记忆能力,方便的学习方法,不俗的非线性特性是以前循环神经网络所不可比的。本文在介绍了回声状态神经网络之后将其用于四轮机器人的位置测量系统中,有良好的表现。     

Florida DOT Project-Level Bridge Management Models

The Florida Department of Transportation (FDOT) is in the process of implementing Pontis, a Bridge Management System, to provide decision support to engineers in the headquarters and district offices as they make routine policy, programming, and budgeting decisions regarding the preservation and improvement of the state’s bridges. As part of this effort, an ongoing research program is underway to adapt the system to FDOT needs as well as to advance the state of the art in several areas important to the Department. Most of the research results are organized around a new project-level decision support framework that complements and builds on Pontis’ existing network-level analysis. Specific new models include accident risk and user cost due to roadway width and alignment deficiencies; user cost of load capacity and vertical clearance restrictions, and moveable bridge openings; project-level prediction models for bridge element condition and costs; and prediction of economics of scale and scoping possibilities. The new models are built into a highly graphical spreadsheet model for decision support use.     

DESIGN AND IMPLEMENTATION OF STATE OBSERVERS IN REACTIVE DISTILLATION

This study demonstrates that state observers can be developed and applied to infer the composition profiles of reactive distillation columns from noise-contaminated temperature measurements. The design and implementation of a Kalman filter (KF) and a Luenberger observer (LO) are carried out, and their performances are quantitatively assessed. The reliability, accuracy, and robustness of the two designs method are examined and compared quantitatively. The design and implementation of a Luenberger observer are simpler and easier to carry out than those of a Kalman filter. On the other hand, a Kalman filter is found to be more robust to a noisy measurements, erroneous initial estimates, and model uncertainties. A Luenberger observer could be used for composition estimation of reactive distillation when an ideal model of the system can reasonably approximate the real system; otherwise, a Kalman filter is recommended to be applied in more practical situations.