多测井曲线的综合处理合成

测井曲线是地质分层的基础，但在利用单一测井曲线解决复杂地质问题时也存在多解性和局限性。为克服多解性，人们采用多种测井曲线进行地质分层，提高了分层的精度。本文在此基础上提出把多条曲线分别赋予不同的加权因子，然后进行归一化处理，形成一条标准综合参数测井曲线。此综合参数曲线突出了所选的多条测井曲线的公共信息，减少或削弱了单一测井曲线中的偶然误差，提高了综合后测井资料的可信度。该方法可应用于地质分层、岩性分析、含油气预测等诸多领域。应用时要注意，并非所选择的测井曲线种类越多越好，而是要选择那些最能反映地层单元特征信息的测井曲线。     

Effect of the degree of crosslinking on penetrant transport in polystyrene

The effect of the degree of crosslinking of glassy polymers on the transport mechanism of penetrants was investigated using a series of divinyl benzene (DVB)-crosslinked polystyrenes of nominal crosslinking ratio X from 0.001 38 to 0.060 mol DVB/mol styrene. The number average molecular weight between crosslinks, $\text{M}\text{?}{}_{\mathrm{<mtext>c</mtext>}}$, was determined from equilibrium swelling experiments in cyclohexane. Dynamic swelling experiments with cyclohexane at 30°C showed that the mechanism of penetrant transport was anomalous. An overshoot in the penetrant uptake was observed, characteristic of macromolecular relaxations and of changing solubility of the cyclohexane in the continuously swelling polystyrene. Photographs of various samples during the swelling process showed that solvent crazing occurred predominantly in loosely crosslinked samples.     

聚酰亚胺渗透汽化膜的研究(Ⅰ)膜的制备和结构对动态吸附特性的影响

以2种二酐，3种二胺为单体，两步法制备了6种不同结构的聚酰亚胺均质膜，通过红外光谱和元素分析证实了其重复单元的分子结构，测定了这几种膜的物理性质和对水蒸气的动态吸附性能，并计算出其反常扩散指数dw。实验表明，随着聚合物二胺单元分子结构的变化，按MDA、ODA、PDA的顺序，密度逐渐变大，链间距逐渐减小，链堆砌变得紧密，水蒸气在膜中的吸附和扩散也变慢，并出现从正常扩散到反常扩散的过渡现象。     

无源微波遥感用于地震预报的实验研究

对无源微波遥感用于地震预报在理论研究的基础上对不同岩性不同结构的岩石试件进行了加载实验，测量了岩石试件的微波辐射随载荷的变化．实验得出：岩石试件的微波辐射能量随岩石应力状态变化而显著变化；而且，不同的波段变化的幅度不同；同一波段不同极化方式的波随应力变化的变化量也不同；微波辐射能量的变化能够被卫星微波遥感探测器探测到．实验还发现，岩石试件临破裂前出现明显的微波辐射异常．     

Phase-change thermal energy storage using spherical capsules: performance of a test plant

The aim of this paper is the study of an industrial process of energy storage usable for air conditioning or refrigeration, investigating a test plant which is a tank with a reduced size, filled with randomly dispersed commercial nodules, placed in a refrigeration loop. The nodules are spherical capsules in which phase change materials (PCM) are encapsulated. This test plant permits the study at length of the behaviour of the tank with, in particular, the charge mode taking into account the undercooling and the discharge mode. A simulation program that considers aspects of both the surrounding heat transfer fluid and the phase-change material packed inside the nodules is developed here in the cases of the charge and the discharge processes. The simulation results are then compared with experimental observations.     

Processing and microstructure of investment casting turbine blade NITAC in-situ composites

Directional solidification was used to produce turbine blades by the Bridgman method. NITAC alloys with various carbon contents were investigated; the optimum range was found to be 0.40 to 0.48%. Within this range, except for the blade locking piece edges, the blade structure consisted predominantly of aligned eutectics. The in- situ eutectics were aligned tantalum fibers embedded in a γ- phase matrix. The blades were produced using an alloy displacement rate of 1.86 x 10 ^{- 6} m/s. Measurements of fiber spacings along the blade height indicated that the rate of displacement of the solidification front exhibited some variations. These variations were closely associated with dimensional changes in the turbine blade cross sections.     

过烧YAG陶瓷晶界的分析

采用固相反应法用不同的烧结速率在1850℃烧结合成过烧钇铝石榴石（YAG）陶瓷，YAG陶瓷晶界形貌随烧结速率的变化而不同。高纯的毋Al2O3和Y2O3原料粉体经高能球磨在1400℃空气中煅烧，生成主相为YAG相的多相粉体化合物。真空烧结YAG陶瓷时烧结速率800℃／h并在1850℃真空烧结4h会使陶瓷中晶粒长大不充分，晶粒与晶粒之间仍保留明显的面接触，陶瓷内部残存大量直径约1μm的气孔，尺寸与可见光波长接近，对透过率的影响大，陶瓷成半透明；在以100~C／h升至1850℃真空烧结4h的YAG多晶陶瓷半透明化，陶瓷晶粒粗大，晶界宽化且保留熔融态凝固，用TEM及EDS确认晶界处存在毋α-Al2O3和钙钛型YAP共晶相。     

分形结构中粒子扩散过程随机模拟

为分析孔隙分形维数和分形结构形式对粒子扩散特性的影响,通过生成分形结构模拟粒子在分形结构中的随机行走,探索分形介质中粒子扩散的运动规律.数值模拟结果显示,粒子在分形结构中的扩散行为受到起点位置、主通道和次通道形状及分形维数等因素的影响.     

Proximity-Induced Fully Ferromagnetic Order with Eightfold Magnetic Anisotropy in Heavy Transition Metal Oxide CaRuO3

Ferromagnetic materials with a strong spin-orbit coupling (SOC) have attracted much attention in recent years because of their exotic properties and potential applications in energy-efficient spintronics. However, such materials are scarce in nature. Here, a proximity-induced paramagnetic to ferromagnetic transition for the heavy transition metal oxide CaRuO₃ in (001)-(LaMnO₃/CaRuO₃) superlattices is reported. Anomalous Hall effect is observed in the temperature range up to 180 K. Maximal anomalous Hall conductivity and anomalous Hall angle are as large as ∼15 Ω⁻¹ cm⁻¹ and ∼0.93%, respectively, by one to two orders of magnitude larger than those of the typical 3d ferromagnetic oxides such as La_0.67Sr_0.33MnO₃. Density functional theory calculations indicate the existence of avoid band crossings in the electronic band structure of the ferromagnetic CRO layer, which enhances Berry curvature thus strong anomalous Hall effects. Further evidences from polarized neutron reflectometry show that the CaRuO₃ layers are in a fully ferromagnetic state (∼0.8 μ_B/Ru), in sharp contrast to the proximity-induced canted antiferromagnetic state in 5d oxides SrIrO₃ and CaIrO₃ (∼0.1 μ_B/Ir). More than that, the magnetic anisotropy of the (001)-(LaMnO₃/CaRuO₃) superlattices is eightfold symmetric, showing potential applications in the technology of multistate data storage.     

Phase relations in the Barium Titanate—Titanium Oxide System

Phase relations in the BaTiO₃—TiO₂ system were studied at temperatures above 1300°C in air. Quenching experiments were performed with high-purity reagents, and a new equilibrium phase diagram was constructed. Results include redetermination of the liquidus boundaries, the eutectic temperature, the melting or decomposition temperatures of the stable compounds in the system, the cubic—hexagonal transition in BaTiO₃, and the solid solubility of TiO₂ in BaTiO₃.