Corrosion of hot-dip-galvanised steel and zinc alloy-coated steel in ammonia and ammonium chloride

There are many potential causes of corrosion in animal buildings. Animals exhale large quantities of moisture into the air creating high relative humidity in the building if the moisture is not properly vented. High humidity increases the potential for condensation. In addition, ammonia may be found in large quantities in animal buildings. Ammonia is released from manure and urine. In addition, ammonium chloride is used as a nitrogen source in fertilisers. In this study, the atmospheric corrosion of hot-dip-galvanised steel and zinc alloy-coated steel such as zinc–aluminium and zinc–aluminium–magnesium has been studied in atmospheres containing different levels of ammonia. Investigations have also been conducted at different levels of ammonium chloride. The results are discussed in view of the mechanisms of corrosion of zinc and zinc alloy-coated steel in ammonia and ammonium chloride-containing environments.     

Cu基络合物催化甲醇液相氧化羰化反应

针对甲醇液相氧化羰基化法合成碳酸二甲酯(DMC)工艺,开发了新型Cu基络合催化剂(CuB rnLm)。对CuB rnLm催化剂的活性及其稳定性进行了研究。实验结果表明,采用该催化剂,甲醇转化率和DMC选择性较高;元素价态和物质结构分析表明,CuB rnLm催化剂循环使用5次后仍保持较好的稳定性。采用正交设计和中心响应曲面法设计实验,并使用S tatistica软件进行统计分析,寻求出反应的主要影响因素,并得到优化的工艺条件:反应温度100~110℃、反应压力3.0~3.5M Pa、反应时间4~6h、CuB rnLm催化剂质量浓度(以甲醇的体积计)0.15~0.20g/mL。在此工艺条件下,甲醇转化率可达23%以上,DMC的选择性为96%~98%。     

分子筛绿色化合成技术的开发

对现有分子筛合成废液中氨氮及还原性物质的来源进行分析，确定降低排放废水中氨氮浓度及COD的方案。对现有ZRP-5分子筛制备流程进行优化，增加母液及赶胺水回用工序；建立母液浓缩装置，将钛硅分子筛及Β分子筛的合成母液及重排母液应用于ZSM-5分子筛的合成，实现废液的梯级利用。上述措施既解决了因分子筛生产废液的排放造成的环境污染，亦因废物资源化降低了ZSM-5分子筛的生产成本。     

Processing of Yttria-Alumina Coated Silicon Nitride Slips by Slip Casting

Si₃N₄powders coated with 6 wt% Y₂O₃and 4 wt% Al₂O₃were prepared by coprecipitation. The resulting powders were dispersed in water at different pH values and with addition of various amounts of ammonium polyacrylate (NH₄PA) to produce 32 vol% slips. The influence of the amount of NH₄PA solution added and pH on the rheological properties of 32 vol% coated Si₃N₄slips were studied. In addition, the sintered density of cast samples was determined and related to the degree of slip dispersion. The adsorption of the NH₄PA on the coated particle surface was rather high and the surface became saturated near 0.86 mg/m²at pH 9.2. High NH₄PA concentrations (1.7–3 wt%) were necessary to obtain well dispersed 32 vol% coated Si₃N₄slips at pH 9.2. The best stabilization was obtained with the addition of 2.3 wt% NH₄PA; in this condition, the viscosity reached a minimum value of 35 mPa.s at 100 s^–1. The slip viscosity increased with increasing pH from 9.2 to 10.2. Slips with low viscosities gave a more dense packing of cast samples and consequently higher sintered density values.     

有机锡催化、无中和水洗合成DOP

以有机锡(Fascat4102)作催化剂,苯酐和辛醇(2-乙基己醇)酯化反应生成邻苯二甲酸二辛酯(DOP),其最佳工艺条件为:酯化温度215～225℃,催化剂加入量2.0‰,过量醇含量17%,脱醇真空为20KPa(绝压),脱醇温度为155℃,活性炭加入量为1‰,省却中和水洗和汽提工序,产品质量可以达到优级品.     

十二酰胺丙基二甲基羟乙基氯化铵与十二烷基硫酸钠水溶液的表面吸附和胶束形成

利用十二酰胺丙基二甲胺和氯乙醇反应 ,合成了十二酰胺丙基二甲基羟乙基氯化铵 (DDHA)阳离子表面活性剂 ,将其与十二烷基硫酸钠 (SDS)以不同摩尔比进行混合 ,测定了混合系统的表面张力 ,计算了单一系统和混合系统的饱和吸附量、分子最小截面积 ,表面层和胶束中 DDHA的摩尔分率及分子间相互作用参数 ,目视观察了混合系统的浑浊情况。结果表明 :在降低γcmc和 cmc方面 ,DDHA SDS混合系统有协同效应 ,表面层和胶束的组成与二组分配比有关 ,但是非对称的 ,等物质的量混合物中 ,DDHA在胶束和表面层中具有较大的摩尔分数。DDHA与 SDS在实验测定的各混合系统中都不出现混浊     

Improvement of the deflocculating power of polyacrylates in ceramic slips by small additions of quaternary ammonium salts

In this work, we examine the effect of small additions of cationic quaternary ammonium salts (QAS) of different molecular weight on the rheology of an industrial ceramic suspension deflocculated with sodium polyacrylate and sodium metasilicate. The observed shear thinning behaviors obey the typical power law of fluid rheology. In order to characterize the rheological behavior of these slurries, three new parameters are introduced: a low shear rate consistency index and two transient viscosities, distant from the equilibrium, after increasing and decreasing the shear rates. These parameters vary with polyacrylate molecular weight and on additions of small quantities of QAS, which we found to be useful for decreasing the slurry viscosity.     

氯化铁催化合成富马酸二甲酯

氯化铁可代替硫酸催化酯化反应，探讨了氯化铁催化合成富马酸二甲酯的条件，操作简便，反应温和，无腐蚀，减少了污染与产品纯化。     

尿素醇解合成碳酸酯类化合物技术进展

综述了用尿素醇解合成碳酸酯类化合物的技术进展 ,重点介绍尿素醇解合成碳酸二甲酯研究现状以及与其它工艺路线的比较 ,另外也介绍了尿素醇解合成长碳链脂肪族和芳香族类碳酸酯的研究进展。     

含氮杂环季铵盐缓蚀剂在CO2-3%NaCl溶液体系中的电化学行为

为控制CO2腐蚀，合成了含氮杂环季铵盐缓蚀剂9912-1，通过电化学实验，研究了该缓蚀剂在CO2-3％NaCl-H2O体系中对碳钢于25℃和90℃下的缓蚀行为。实验结果与挂片失重法测试的结果基本一致。低温下缓蚀效果优于高温下的缓蚀效果。而且该缓蚀剂与硫脲有很好的协同效应。Tafel曲线表明，该缓蚀过程是以控制阴极腐蚀为主，并对其缓蚀机理进行了初步探讨。