箍筋末端135度弯钩二次就位法讨论

随着人们对建筑安全的日益重视 ,对建筑抗震要求的提高 ,国内外有关规范都对箍筋末端的设置作了明确规定 ,要求做成 135度弯钩。而在工程实践中 ,由于施工上的技术困难 ,很多工程都只设置成 90度弯钩。笔者提出的箍筋末端 135度弯钩二次就位法在基本不增加 90度弯钩施工难度与费用的基础上实现了 135度弯钩的施工 ,其法是可行的     

S135钻杆钢在钻井液中的氧腐蚀行为

基于系统的理论分析和现场腐蚀产物的XRD分析,揭示了S135钻杆钢在3%NaCl溶液中的氧腐蚀机理。为研究腐蚀因素与腐蚀速率的关系,通过室内高压釜动态模拟实验,分别研究了钻井液中含氧量、钻井液温度、钻井液流速和钻井液盐浓度对S135钻杆钢的氧腐蚀速率影响规律。实验研究结果表明(1)3%NaCl盐水钻井液对S135钻杆钢的腐蚀主要是氧去极化作用所致;(2)钻井液含氧量和钻井液流速的增加会加快钻杆钢的氧腐蚀速率,而钻井液温度和含盐量对钻杆钢的氧腐蚀速率具有双重作用。     

S—135钢板热轧工艺研究

S—135钢板是水电站用高强耐磨不锈钢板,既要求强度高、韧性好,又要求耐磨、耐蚀性强,生产难度较大。除我厂外,目前国内尚无其它厂家能够生产这种钢板。该钢板在加热轧制,冷却过程中要解决很多技术难点。我们通过采用特殊的控制轧制和控制冷却工艺,很好地解决了诸多技术难点,使S—135钢板的开发研制取得了成功。为电站用高强度耐磨不锈钢生产提供了宝贵的经验,也为控制轧制及控制冷却技术在中板生产行业的应用起到了积极的推动作用。     

关于CJJ/T135-2009标准中胶凝材料用量确定方法的对比讨论

文章讨论了《透水水泥混凝土路面技术规程》(CJJ/T135-2009)标准中配合比设计部分关于胶凝材料用量确定方法与其他两种胶凝材料用量确定方法的准确性、便捷性、应变性和可操作性.通过对实验结果的分析发现,CJJ/T135-2009中的胶凝材料用量确定方法误将水胶比理解成每立方米混凝土用水量与所有胶凝材料用量的体积之比,从而导致计算结果偏差.而采用实际测定浆体密度再确定胶凝材料用量的方法更符合工程应用的实际情况,且可操作性更强.     

S7-200在光纤成缆机上的应用

文中主要介绍用西门子S7-200PLC在光纤成缆机上成功地完成了对西门子S5-135UPLC的改造,最大限度地利用了S7-200的模板扩展功能,极大地节约了改造成本,达到了理想的控制效果.给出了控制方案和软、硬件设计框图,对于相关改造具有较高的应用和参考价值.     

A Brief Review on the Biology and Effects of Cellular and Circulating microRNAs on Cardiac Remodeling after Infarction

Despite advances in diagnostic, prognostic, and treatment modalities, myocardial infarction (MI) remains a leading cause of morbidity and mortality. Impaired cellular signaling after an MI causes maladaptive changes resulting in cardiac remodeling. MicroRNAs (miRNAs/miR) along with other molecular components have been investigated for their involvement in cellular signaling in the pathogenesis of various cardiac conditions like MI. miRNAs are small non-coding RNAs that negatively regulate gene expression. They bind to complementary mRNAs and regulate the rate of protein synthesis by altering the stability of their targeted mRNAs. A single miRNA can modulate several cellular signaling pathways by targeting hundreds of mRNAs. This review focuses on the biogenesis and beneficial effects of cellular and circulating (exosomal) miRNAs on cardiac remodeling after an MI. Particularly, miR-1, -133, 135, and -29 that play an essential role in cardiac remodeling after an MI are described in detail. The limitations that will need to be addressed in the future for the further development of miRNA-based therapeutics for cardiovascular conditions will also be discussed.     

Experimental study of the burner for FAA fire test: NexGen burner

The NexGen (Sonic) burner is the new burner developed by the Federal Aviation Administration, FAA, to replace old oil burners used for the required fire certification tests on power plant‐related materials, as it provides the capability to control both air and fuel flow rates. During a fire test, the burner is supposed to simulate a certain fire condition, so the flame properties should be robust and repeatable. The NexGen burner can achieve this due to the precise fuel and air controls. However, the current calibration criterion (ISO2685:1998 and AC20‐135) may not be good enough to ensure consistent flame properties. In the presented work, the sensitivity of the burner performance to air and fuel flow rate, as measured by the temperature and heat flux for calibration purposes, was studied. Additionally, the influence of the turbulator and the thermocouple size used for flame calibration was also studied. The impact of varying fuel/air ratio and thermocouple sizes was studied by conducting fire tests on aluminum samples, to show the inadequacies in the current calibration standards.     

温度对破损涂层S135钻杆钢在3.5% KCl溶液中电化学腐蚀行为的影响

基于理论分析和电化学测量技术研究了温度对破损涂层S135钻杆钢在3.5%(质量分数,下同)KCl溶液中电化学腐蚀行为的影响。结果表明:破损涂层钻杆钢的开路电位随温度升高而负移,在40~65℃温度区间,材料热力学状态发生显著变化;整个反应主要受阳极反应控制,腐蚀速率随温度升高先增大后减小,在65℃时达到最大;温度主要通过影响离子传递电荷过程来影响反应的腐蚀速率。     

射水抽气器异常情况的分析及解决

介绍了江苏天生港发电有限公司8、9号135MW机组射水抽气器工作特点,分析了其工作时发生的喷嘴堵塞、喷嘴磨损及逆止阀卡涩时的现象,提出了具有针对性的预防措施,从而保证射水抽气器安全运行。     

高效阴离子交换色谱-脉冲安培法测定W135群和Y群脑膜炎球菌多糖中半乳糖和葡萄糖含量

目的采用高效阴离子交换色谱-脉冲安培法(High-performance anion-exchange chromatography with pulsedamperometric detection,HPAEC-PAD)测定W135群和Y群脑膜炎球菌荚膜多糖中半乳糖和葡萄糖的含量,并对该方法进行验证及初步应用。方法多糖蛋白结合物原液的混合液经HCl水解处理后,进样CarboPac PA10柱,以氢氧化钠-醋酸钠梯度流洗,脉冲积分安培检测器检测。筛选样品的水解条件;对HPAEC-PAD法进行专属性、精密性及准确性验证,并进行初步应用。结果确定的样品水解条件为以2 mol/L HCl于85℃处理1 h。载体蛋白破伤风类毒素对检测结果无干扰;重复性、日内精密性和不同操作者之间精密性试验结果的RSD均小于5%;准确性试验中葡萄糖和半乳糖的回收率在90%～110%之间。HPAEC-PAD法测定多糖蛋白结合物原液的多糖含量与传统间苯二酚比色法测定结果相当;成品疫苗中的W135群和Y群多糖含量测定结果符合《A、C、W135、Y群脑膜炎球菌结合疫苗制造及检定规程草案》的规定(均≥4μg/剂)。结论 HPAEC-PAD法专属性、精密性和准确性良好,可用于A、C、W135、Y群脑膜炎球菌结合疫苗中W135群和Y群多糖含量的测定。