2000MPa预应力体系在快速路及东南半环海河大桥中的应用

主要针对快速路5km高架桥及东南半环海河大桥主桥2000MPa预应力体系的应用作重点介绍．2000MPa预应力体系在海河大桥主桥的应用开创了国内特大型桥梁结构的先河，该项目同时为市建委2000年重点攻关项目，在为天津市市政建设取得宝贵经验的同时向国内桥梁的设计提供一些思路。     

Apoptotic Effects of Anthocyanins from Vitis coignetiae Pulliat Are Enhanced by Augmented Enhancer of the Rudimentary Homolog (ERH) in Human Gastric Carcinoma MKN28 Cells

Evidence suggests that augmented expression of a certain gene can influence the efficacy of targeted and conventional chemotherapies. Here, we tested whether the high expression of enhancer of the rudimentary homolog (ERH), which serves as a prognostic factor in some cancers, can influence the efficacy of anthocyanins isolated from fruits of Vitis coignetiae Pulliat, Meoru in Korea (AIMs) on human gastric cancer cells. The anticancer efficacy of AIMs was augmented in ERH-transfected MKN28 cells (E-MKN28 cells). Molecularly, ERH augmented AIM-induced caspase-dependent apoptosis by activating caspase-3 and -9. The ERH-augmented apoptotic effect was related to mitochondrial depolarization and inhibition of antiapoptotic proteins, XIAP, and Bcl-2. In addition, reactive oxygen species (ROS) generation was augmented in AIMs-treated E-MKN28 cells compared to AIMs-treated naïve MKN28 cells. In conclusion, ERH augmented AIM-induced caspase-dependent mitochondrial-related apoptosis in MKN28 cells. A decrease in expression of Bcl-2 and subsequent excessive ROS generation would be the mechanism for ERH-augmented mitochondrial-related apoptosis in AIMs-treated MKN28 cells. A decrease in expression of XIAP would be another mechanism for ERH-augmented caspase-dependent apoptosis in AIMs-treated MKN28 cells.     

550 MPa级中厚板矫直过程中表面凹坑缺陷的成因与对策

针对550 MPa级高强中厚板在矫直过程中极易出现氧化铁皮压入凹坑缺陷的问题，根据现场矫直工艺，研究了在不同温度下进行热变形时试样表面和横截面的形貌，钢基体与氧化铁皮界面处平直度的变化规律。结果表明，热变形温度为450 ℃时，表面氧化铁皮开始出现裂纹，且随着变形温度的降低，裂纹的数量逐渐增加；此外，氧化铁皮与钢基体之间的界面长度随变形温度的降低而呈直线增加，表明氧化铁皮与钢基体界面平直度随着热变形温度的降低越发粗糙、易脱落而形成凹坑缺陷。为此，应适当提高终轧温度以确保矫直时钢板表面温度大于450 ℃，同时提高钢板的运行速率，防止氧化铁皮在低温变形发生破碎和脱落的同时降低氧化铁皮厚度，从而减小因氧化铁皮脱落而造成凹坑缺陷的发生几率。     

Fluorescent Brightener 28 Removal by Ozonation or Advanced Oxidation Processes (O3/H2O2)

The aim of this work is to study the reaction of ozone and combined ozone/hydrogen peroxide mixtures with the fluorescent brightener 28 in dilute aqueous solution using controlled experimental conditions. The kinetics were also evaluated under various experimental conditions. The main ozonation by-products have been identified by High Pressure Anionic Exchange Chromatography (HPAEC) and Gas Chromatography coupled with Mass Spectrometry (GC-MS) techniques and a reaction pathway is proposed. In order to confirm this mechanism, melamine and s-triazine have been treated under the same reaction conditions and their decomposition pathways were studied.     

Assessment of a redox alkaline/iron-chelate absorption process for the removal of dilute hydrogen sulfide in air emissions

The oxidative absorption of hydrogen sulfide (H₂S) into a solution of ferric chelate of trans-1,2- diaminocyclohexanetetraacetate (CDTA) was studied in a counter-current laboratory column randomly packed with 15 mm plastic Ralu rings. The present investigation takes concern about the Kraft pulping situation where dilute H₂S concentrations are omnipresent in large-volume gas effluents. A fractional two-level factorial approach was instigated to determine the significance of six operating variables, namely the solution's alkalinity (pH; 8.5-10.5), the liquid mass flow rate (L;1.73-), the solution's ionic strength (I_C;0.01-), the gas mass flow rate (G;0.19-), the inlet H₂S concentration (C_H2S,0;70-430 ppm) and the initial ferric CDTA concentration (C_Fe,0;100 -). Initially, a Plackett-Burman design matrix of seven duplicated experiments revealed that pH is the leading factor controlling the H₂S conversion rate while the ionic strength and ferric CDTA concentration effects remained negligible within the factorial domain. Surface response analysis based on 11 duplicated factorial experiments plus 10 central composite trials revealed that the H₂S conversion significantly increases with liquid flow rate but decreases with growing H₂S load up. Further examination about the influence of ferric CDTA on H₂S absorption rate was set up over a broader concentration range (C_Fe,0;0- at pH of 9.5 and 10.5. It showed good potential at as H₂S conversion increased by a significant 25% for both pH values in comparison to pure alkaline solutions containing no ferric CDTA.     

高强箍筋混凝土简支梁抗剪承载力试验研究

通过对14根500 MPa细晶粒钢筋、1根400 MPa及1根600 MPa钢筋做箍筋的混凝土简支梁在集中荷载作用下的试验,观测了不同混凝土强度、不同剪跨比、不同箍筋强度、不同配箍率、不同截面尺寸条件下试件的裂缝、挠度、承载力及破坏形态;并将实测值与有关公式的计算值进行了比较.试验结果表明,构件的斜截面承载力仍可按现行《混凝土结构设计规范》的相关公式进行计算,并有足够的安全储备.     

基于STM32的校园能耗监控系统的以太网接口设计

本文针对校园能耗监控系统,介绍了一种基于STM32单片机和以太网控制器的以太网接口设计方案,阐述了STM32微处理器及ENC28J60芯片的功能和特点,并给出了系统的硬件和软件设计方案.根据该以太网接口设计一个在Web服务器上控制照明的测试,通过测试证明,该设计能够在校园能耗监控系统中进行信息的高速、远程传输,完成以太网接入功能.     

配置500 MPa纵筋钢筋混凝土框架顶层端节点抗震性能试验研究

按照《混凝土结构设计规范》(GB 50010—2010)设计了6个配置500 MPa纵筋的钢筋混凝土框架顶层端节点,并进行了低周反复加载抗震性能试验,验证了规范规定的抗震措施对配置500 MPa钢筋的顶层端节点的有效性,分析了配置500 MPa级钢筋的顶层端节点的受力特点、节点区的破坏形态以及节点的综合抗震性能,并与受力条件基本相同的配置HRB335级纵筋节点的受力性能进行了对比,对采用不同延性指标评价配置不同强度钢筋节点的延性性能差异进行了讨论。     

Effect of nitrogen on corrosion behavior of 28Cr-7Ni duplex and microduplex stainless steels in air-saturated 3.5 wt% NaCl solution

The corrosion behavior of 28Cr-7Ni-O-0.34N duplex stainless steels in air-saturated 3.5-wt% NaCl solution at pH 2, 7, 10 and 27 °C was studied by the potentiodynamic method. Two types of microstructures were investigated: the as-forged duplex and microduplex (average austenite grain size 5-16 μm) structures. The austenite volume fractions of the tested steels were between 0.35 and 0.64. The nitrogen effect on corrosion behaviors of both duplex and microduplex stainless steels were the same. At pH 2, the corrosion potential increased when the nitrogen content increased, however, corrosion current density as well as corrosion rate decreased. At pH 7 and 10, the effect of nitrogen on corrosion potential and corrosion rate could not be observed. Corrosion potential at pH 10 was lower than at pH 7. Pitting potential increased when the nitrogen content in the tested steels increased at all tested pH. For the nitrogen effect on the passive current density, it seemed that only at pH 2, the average passive current densities reduced when the nitrogen content increased. Nitrogen may have participated in the passive film or has been involved in the reaction to build up passive film. The ammonium formation and nitrogen enrichment at the interface metal/passive film with adsorption mechanism were discussed. The dissolute nitrogen might have combined with the hydrogen ions in solution to form ammonium ions, resulting in increasing solution pH. The steel could then easily repassivate, hence the corrosion potential and pitting potential would increase. However, the ammonium formation mechanism could not explain the decrease of corrosion potential in basic solution. Nitrogen enrichment at the metal/passive film interface with adsorption mechanism seemed to be an applicable consideration in increasing pitting potential. However, this mechanism did not involve the ammonium ion formation. In general, for the duplex and microduplex stainless steels tested, nitrogen increased the general corrosion resistances in acid solution and pitting corrosion resistance at all solution pH. Metallographic observation in both tested duplex and microduplex steels after pitting corrosion at all tested pH revealed that, the corroded structure in the tested steels without nitrogen alloying was austenite, but those with nitrogen alloying was ferrite. Even though ferrite had a higher chromium content than austenite but higher dissolved nitrogen in austenite than in ferrite may have increased the pitting resistance equivalent number (PRE) of austenite to be higher than that of ferrite.     

KYN28-12型铠装金属式封闭开关柜实训与注意事项

介绍KYN28-12型铠装金属式封闭开关柜的实训内容,分析学员没按技术规范和标准进行捡查、操作和检修的原因,并提出在实训过程中的注意事项.