Authenticity green coffee bean species and geographical origin using near-infrared spectroscopy combined with chemometrics

To prevent the adulteration of agricultural resources and provide a solution to enhance the green coffee bean supply chain, authentication using the near-infrared spectroscopy (NIRS) technique was investigated. Partial least square with discrimination analysis (PLS-DA) models combined with various preprocessing methods were built from NIR spectra of 153 Vietnamese green coffee samples. The model combined with the standard normal variate and the first order of derivative yielded excellent performance in predicting coffee species with the error cross-validation of 0.0261. PLS-DA model of mean centre and first-order derivative spectra also yielded good performance in verifying geographical indication of green coffee with the error of 0.0656. By contrast, the predicting abilities of post-harvest methods were poor. The overall results showed a high potential of the NIRS in online authentication practices.     

Rapid screening of DON contamination in whole wheat meals by Vis/NIR spectroscopy and computer vision coupling technology

This work intends to develop an online experimental system for screening of deoxynivalenol (DON) contamination in whole wheat meals by visible/near-infrared (Vis/NIR) spectroscopy and computer vision coupling technology. Spectral and image information of samples with various DON levels was collected at speed of 0.15 m s⁻¹ on a conveyor belt. The two-type data were then integrated and subjected to chemometric analysis. Discriminant analysis showed that samples could be classified by setting 1000 μg kg⁻¹ as the cut-off value. The best correct classified rate obtained in prediction was 93.55% based on fusion of spectral and image features, with reduced prediction uncertainty as compared to single feature. However, quantification of DON by quantitative analysis was not successful due to poor model performance. These results indicate that, although not accurate enough to provide conclusive result, this coupling technology could be adopted for rapid screening of DON contamination in cereals and feeds during processing.     

Scale Up from Small Oven-Drying Tests of Mineral Concentrate to Pilot-Scale Drying with a Heated Pad

While Fickian diffusion models are commonly used in other applications, there are few reports of them being applied to the batch drying of a mineral concentrate. Diffusion coefficients estimated from small-scale oven-drying tests were used to predict the drying behavior of a concentrate sample 1 m × 1 m in area and 50 cm deep, with a heated bottom pad. These pilot-scale tests included both daily turning of the sample and turning every three days. The excellent quantitative agreement between the predicted and observed pilot-scale behavior gives a high level of confidence in the model predictions and suggests that a Fickian diffusion model is adequate to predict the behavior of mineral concentrates at the low moisture contents used here.     

大气探测红外分光辐射计Ⅱ型模样

报道了大气探测红外分光辐射计Ⅱ型(ASIS-2)模样,它具有20个通道,可以从卫星探测大气温度廓线和水汽垂直分布.它与美国TIROS-N/NOAA气象卫星上的高分辨率红外辐射探测仪(HIRS)相比,在光学、电子学和机械等方面都作了改进.其仪器灵敏度优于HIRS-1仪器,而与HIRS-2接近.它具有可增加2个红外通道和多个可见光通道的潜力.     

MPID─TOF质谱的快速时间分辨微弱信号测试系统

把瞬态记录仪Ｂｉｏｍａｔｉｏｎ８ｌ００与微型计算机ＩＢＭ─ｐＣ／ＸＴ联接建成了一个高速数据采集系统，本文介绍了系统的硬件接口设计及软件设计。在超声分子束条件下，把它应用于环氧乙烷（Ｃ＿２Ｈ＿４Ｏ）的多光子电离与离解飞行时间（ＭＰＩＤ─ＴＯＦ）质谱的实验研究中，并给出了实验结果；本系统在微观基元化学反应动力学实验研究中广泛适用于对时间分辨微弱信号的探测。     

低渗透率地层渗透率的确定方法

结合大庆油田外围低渗透率地层的地质特点,根椐渗流理论和岩心分析资料,分析了地层渗透率与孔隙度、组成地层的各种矿物含量以及泥质含量之间的关系,建立了不同矿物组合地层的渗透率计算方程。用本方法计算的和岩心分析的渗透率进行了对比,二者之间具有较好的一致性。     

金属Be真空出气性能的测试

利用四极质谱计测试了国产金属铍材在 10 0℃～ 6 0 0℃不同温度下的真空出气成分及相对含量 ,实验得出铍的大量出气主要在温度 4 0 0℃～ 5 0 0℃之间 ,其放出气体的主要成分按放气量大小依次为H2 O ,CO2 ,N2 ,CO ,Ar和H2 ,利用限流小孔半定量的计算了铍材的出气量。     

北京谱仪漂移室读出电子学校准电路

本文介绍的电路可同时进行时间和电荷校准,它的校准量程大,精度高,稳定性好,可输出864路指数形校准信号,并可手动或程控。它的时间校准精度优于±250ps,电荷量校准精度优于±1％。     

Investigation of the structure and properties of modified Armenian minerals for polymer-based composites

The results of investigation of the modification of the Armenian minerals with fluorine-containing oligomers show that a modified product appears when the mineral fillers are treated with fluoroalkanes. The product preserves the structure of the fillers with a “grafted” fluoroalkane layer in which chlorine atoms locate mainly over their periphery. The composite materials based on heterochained polymers and the modified fillers possess a stronger wear resistance and a low friction coefficient.