全文获取类型
收费全文 | 39626篇 |
免费 | 2820篇 |
国内免费 | 1630篇 |
专业分类
电工技术 | 3024篇 |
综合类 | 3864篇 |
化学工业 | 3786篇 |
金属工艺 | 1943篇 |
机械仪表 | 4062篇 |
建筑科学 | 5961篇 |
矿业工程 | 2597篇 |
能源动力 | 2575篇 |
轻工业 | 1670篇 |
水利工程 | 1575篇 |
石油天然气 | 2771篇 |
武器工业 | 215篇 |
无线电 | 2001篇 |
一般工业技术 | 3045篇 |
冶金工业 | 1779篇 |
原子能技术 | 396篇 |
自动化技术 | 2812篇 |
出版年
2024年 | 100篇 |
2023年 | 331篇 |
2022年 | 674篇 |
2021年 | 804篇 |
2020年 | 840篇 |
2019年 | 639篇 |
2018年 | 661篇 |
2017年 | 812篇 |
2016年 | 1029篇 |
2015年 | 1231篇 |
2014年 | 2303篇 |
2013年 | 1936篇 |
2012年 | 2764篇 |
2011年 | 3120篇 |
2010年 | 2361篇 |
2009年 | 2510篇 |
2008年 | 2184篇 |
2007年 | 2894篇 |
2006年 | 2673篇 |
2005年 | 2336篇 |
2004年 | 2041篇 |
2003年 | 1828篇 |
2002年 | 1517篇 |
2001年 | 1226篇 |
2000年 | 1038篇 |
1999年 | 832篇 |
1998年 | 626篇 |
1997年 | 574篇 |
1996年 | 488篇 |
1995年 | 436篇 |
1994年 | 302篇 |
1993年 | 205篇 |
1992年 | 156篇 |
1991年 | 122篇 |
1990年 | 90篇 |
1989年 | 89篇 |
1988年 | 58篇 |
1987年 | 62篇 |
1986年 | 27篇 |
1985年 | 13篇 |
1984年 | 31篇 |
1983年 | 26篇 |
1982年 | 22篇 |
1981年 | 11篇 |
1980年 | 14篇 |
1979年 | 10篇 |
1978年 | 3篇 |
1977年 | 6篇 |
1975年 | 3篇 |
1951年 | 3篇 |
排序方式: 共有10000条查询结果,搜索用时 281 毫秒
1.
《International Journal of Hydrogen Energy》2022,47(54):23006-23018
Hook and claw pumps are used for recirculation of excess hydrogen in fuel cells. Optimization of the pump design is essential. Computational Fluid Dynamic (CFD) is an effective method for performance optimization. However, it is difficult to conduct CFD simulation because of the sharp cusp of the rotor profile. Cut cell Cartesian mesh could be the solution to handle this complex and moving geometries. The aim of this paper is to evaluate ANSYS Forte for hook and claw pumps. Firstly, the conservation accuracy of the cut cell cartesian mesh is verified using an adiabatic piston cylinder case. Then, simulation results of hook and claw type pump are compared with experimental data. Finally, simulation results of air and hydrogen are compared. The results show that the CFD simulation of hook and claw pumps using cut cell cartesian mesh could provide an efficient and effective approach for the optimization of the system. 相似文献
2.
3.
茯砖茶发酵、干燥过程中,烘房内温湿度稳定性和能源系统低能耗是保证茯砖茶品质与成本的重要因素。本文采用TRNSYS仿真与实验研究相结合的方法,对咸阳某茯砖茶厂实际使用的空气源热泵系统进行建模,通过研究各季节典型代表月烘房温湿度的波动情况,确定该空气源热泵系统在全年的运行状态是否满足工艺要求,在此基础上,对比了该系统在全年可运行季节代表月与该生产厂房早期使用的燃气锅炉系统的能耗仿真结果,对空气源热泵系统的节能与环保特性进行研究。结果表明:由于夏季送风质量流量过大且室外空气含湿量较高,7月烘房温湿度不满足工艺要求。热泵系统在1、4、10月的总标煤消耗量的平均值是锅炉系统的44.42%,平均CO2、SO2、NOx排放量分别为锅炉系统的34.13%、44.1%、40.60%。在茯砖茶发酵、干燥的过程中,相比于燃气锅炉系统,空气源热泵系统具有更好的节能与环保特性。 相似文献
4.
5.
《International Journal of Hydrogen Energy》2022,47(19):10747-10761
To obtain the mixing enhancement mechanism of H2–Water combined jets in supersonic crossflows in a combustor with expanded section for rotating detonation ramjet, the flow field shape and spray structure were studied by experimental and numerical methods. The Eulerian–Lagrangian method was used to investigate the diffusion mechanism and H2–Water interaction law of combined jets with different sequences. At the same time, high-speed photography and the schlieren technique were used to capture the flow field. The effects of jet pressure drop, orifice diameter, orifice spacing, incoming Mach number, and other parameters on the penetration depth of water jets were studied. The results of experiment and simulation show that using H2–Water combined jets, the penetration depth of the jet spray can be greatly increased and the jet mixing effect can be significantly improved, which will contribute to the engine's ignition and stable combustion. In the case of pre-water/post-H2, the penetration depth of the hydrogen jet is greater. In the case of pre-H2/post-water, the hydrogen jet raises the water spray mainly by protecting the integrity of the water column. 相似文献
6.
为研究钢管套筒灌浆连接轴向受拉破坏过程及破坏机理,试验中设计了16组48个钢管套筒灌浆连接试件,试件采用钢板代替圆钢管,并进行静载试验。分析了灌浆料裂缝扩展过程、荷载-相对位移曲线,并对抗剪键高距比、灌浆料厚度、侧向力等因素对破坏过程及承载力的影响进行分析。结果表明:对于不设置抗剪键的套筒灌浆连接试件,斜裂缝随机产生,裂缝分布不均匀;对于设置抗剪键的套筒灌浆连接试件,裂缝首先出现在底部抗剪键位置处,与水平方向夹角约为30°,随后在中部和上部抗剪键位置处分别出现斜裂缝。由于每个抗剪键上荷载分担并不均匀,与抗剪键接触的灌浆料逐渐达到极限压应力,达到极限状态时,承载力全部由抗剪键间的机械咬合力承担,在连接承载力中,可忽略摩擦力和胶结力作用。随着抗剪键高距比h/s增大,各试件初始剪切刚度相差不大,承载力增大,但增幅逐渐减小,建议抗剪键高距比0.06g/s>0.3,同时需要满足灌浆料灌注的施工要求。 相似文献
7.
8.
The existing analytical average bit error rate (ABER) expression of conventional generalised spatial modulation (CGSM) does not agree well with the Monte Carlo simulation results in the low signal‐to‐noise ratio (SNR) region. Hence, the first contribution of this paper is to derive a new and easy way to evaluate analytical ABER expression that improves the validation of the simulation results at low SNRs. Secondly, a novel system termed CGSM with enhanced spectral efficiency (CGSM‐ESE) is presented. This system is realised by applying a rotation angle to one of the two active transmit antennas. As a result, the overall spectral efficiency is increased by 1 bit/s/Hz when compared with the equivalent CGSM system. In order to validate the simulation results of CGSM‐ESE, the third contribution is to derive an analytical ABER expression. Finally, to improve the ABER performance of CGSM‐ESE, three link adaptation algorithms are developed. By assuming full knowledge of the channel at the receiver, the proposed algorithms select a subset of channel gain vector (CGV) pairs based on the Euclidean distance between all CGV pairs, CGV splitting, CGV amplitudes, or a combination of these. 相似文献
9.
The Vehicle Routing Problem with Simultaneous Pickup and Delivery (VRPSPD) is an extension to the classical Vehicle Routing Problem (VRP), where customers may both receive and send goods simultaneously. The Vehicle Routing Problem with Mixed Pickup and Delivery (VRPMPD) differs from the VRPSPD in that the customers may have either pickup or delivery demand. However, the solution approaches proposed for the VRPSPD can be directly applied to the VRPMPD. In this study, an adaptive local search solution approach is developed for both the VRPSPD and the VRPMPD, which hybridizes a Simulated Annealing inspired algorithm with Variable Neighborhood Descent. The algorithm uses an adaptive threshold function that makes the algorithm self-tuning. The proposed approach is tested on well-known VRPSPD and VRPMPD benchmark instances derived from the literature. The computational results indicate that the proposed algorithm is effective in solving the problems in reasonable computation time. 相似文献
10.
Weiguo Cao Wenjuan Li Liang Zhang Jianfa Chen Shuo Yu Zhuanghong Zhou Yun Zhang Xiaobo Shen Yingxin Tan 《International Journal of Hydrogen Energy》2021,46(52):26693-26707
The explosion venting duct can effectively reduce the hazard degree of a gas explosion and conduct the venting energy to the safe area. To investigate the flame quantitative propagation law of explosion venting with a duct, the effects of hydrogen fraction and explosion venting duct length on jet flame propagation characteristics of premixed H2-air mixtures were analyzed through experiment and simulation. The experiment results under initial conditions of room temperature and 1 atm show that when hydrogen fraction was high enough, part of the unburned hydrogen was mixed with air again to reach an ignitable concentration, resulting in the secondary combustion was easier produced and the duration of the secondary flame increased. With the increase of venting duct length, the flame front distance and propagation velocity increased. Meanwhile, the spatial distribution of pressure field and temperature field, and the propagation process and mechanism of the flame venting with a duct were analyzed using FLUENT software. The variation of the pressure wave and the pressure reflection oscillation law in the explosion venting duct was captured. Therefore, in the industrial explosion venting design with a duct, the hazard caused by the coupling of venting pressure and venting flame under different fractions should be considered comprehensively. 相似文献