The effect of ion exchange conditions, such as Si/Al ratio, precursor copper salt, pH and concentration of the solution, on the catalytic activity in SCR of NO by propane and on the electronic state of copper ions in Cu-ZSM-5 has been studied. The NO conversion in NO SCR by C3H8 has been found to reach a maximum value at Cu/Al ratio about 0.37–0.4 and remain constant at higher Cu/Al.
ESR and UV–vis DR spectroscopy have been used to elucidate stabilization conditions of copper ions in Cu-ZSM-5 zeolites as isolated Cu2+ ions, chain copper oxide structures and square-plain oxide clusters. The ability of copper ions for reduction and reoxidation in the chain structures may be responsible for the catalytic activity of Cu-ZSM-5. These transformations of copper ions are accompanied by the observation of intervalence transitions Cu2+–Cu+ and CTLM of the chain structures in the UV–vis spectra. 相似文献
A model has been proposed to explain the failure of the original BMS10-39 epoxy paint on upper vertical surfaces in B-52 fuel tanks. The model involves interaction of the paint with DIEGME, a fuel system ice inhibitor (FSII) in jet fuel, that is distilled from the liquid fuel. In this communication, distillation experiments used to support the model are refined to better match the mass transfer of vapor from fuel in a B-52 fuel tank at close to room temperature. The interaction of these lower temperature distillates with the paint affirms the earlier model. On the basis of these experiments it is proposed that paint failure may be controlled or eliminated by reducing the level of DIEGME in the fuel. Proposed changes in military jet fuel composition are detailed. 相似文献
The dehydroalkylation of toluene with ethane to the isomeric ethyltoluenes was studied on 0.4Pt/H-ZSM-5 at varying contact
times (1/WHSV). At a high contact time of 1.0 h, toluene disproportionation and hydrogenolysis reactions dominate, resulting
in low selectivity to the desired ethyltoluenes via the alkylation reaction. However, at a low contact time of 0.12 h side
reactions are eliminated, resulting in maximum selectivities to the kinetically favored ethyltoluenes and hydrogen. Results
at high selectivities to ethyltoluenes provide significant insight into reaction pathways. 相似文献
Advanced sol–gel methods using a secondary solvent addition into (Pb, La)(Zr, Ti)O3 (PLZT) sol–gel solution and a methanol pre-treatment of sapphire substrates are demonstrated. For the secondary solvent addition, the additive affected the crystallinity and electro-optic (EO) property of PLZT films and only methanol addition can improve them. In addition, the methanol pre-treatment is also appeared to be effective to improve film characteristics.
Through these optimizations, epitaxially grown PLZT thin films on r-cut sapphire are obtained and a high Pockels coefficient which is comparable to those of bulk PLZTs is achieved. It is believed that these PLZT thin films are applicable for integrated EO devices and open the door for the future data communication systems. 相似文献
ZnO-based varistor samples were prepared by the direct mixing of the constituent phases (DMCP) and sintering at 1100 °C for 2 h. The influence of the starting powder mixture's composition – the amounts of the pre-reacted varistor compounds and their composition – and its preparation, either with or without mechano-chemical activation (MCA), on the microstructure, phase composition and electrical characteristics of the varistor samples was studied. It showed that MCA improved the density and microstructural homogeneity of the varistor samples. MCA strongly affected the grain growth: it enhanced the nucleation of inversion boundaries (IBs) in the ZnO grains and the IBs-induced grain-growth mechanism resulted in uniform grain growth and hence a microstructure with smaller ZnO grains and a narrower grain size distribution. The final phase composition of the samples prepared by the DMCP method mainly depended on the presence of varistor dopants that can prevent the formation of the pyrochlore phase, especially Cr2O3, while MCA can affect it mostly by providing a homogeneous distribution of those dopants. The DMCP varistor samples prepared with MCA had much better current–voltage characteristics than the samples of the same composition prepared from unactivated powders. 相似文献
Various compositions of gas sensing films were prepared by the combinatorial deposition of SnO2, ZnO, and WO3 sol solutions and their gas sensing behaviors were investigated. The film composition could be manipulated conveniently via the alternate dropping of different oxide sol solutions. From the correlation between film compositions and gas sensitivities, the selective detection of C2H5OH and CH3COCH3 in the presence of CO, C3H8, H2, and NO2 could be attained. In addition, the discrimination between C2H5OH and CH3COCH3, which is a challenging issue due to their similar chemical nature, becomes possible. This research demonstrates the precise design of the sensor-material composition for the selective gas detection via the combinatorial approach. 相似文献
The density functional theory (DFT/B3LYP) calculations were applied to investigate the interaction of a Pt6 particle with the ZSM-5 zeolite framework. The electronic structure of the metal particle is strongly affected by the interaction with basic framework oxygens and acid sites of the zeolite support. Adsorption on basic sites (Eads = 6 kcal/mol) favors the formation of the electron enriched metal cluster. Interaction of the platinum cluster with the acid site characterized by stabilization energy of 47 kcal/mol results in oxidation of the metal particle and suppression of Brønsted acidity of the support. The hypothesis is put forward that the oxidized platinum particle can function as an active site for the alkane isomerisation on platinum supported high silica zeolites. 相似文献