Ozonation of CI Reactive Black 5 using rotating packed bed and stirred tank reactor

This study investigates the ozonation of CI Reactive Black 5 (RB5) by using the rotating packed bed (RPB) and completely stirred tank reactor (CSTR) as ozone contactors. The RPB, which provides high gravitational force by adjusting the rotational speed, was employed as a novel ozone contactor. The same ozone dosage was separately introduced into either the RPB or the CSTR for the investigation, while the experimental solution was continuously circulated within the apparatus consisting of the RPB and CSTR. The decolorization and mineralization efficiencies of RB5 in the course of ozonation are compared for these two methods. Moreover, the dissolved and off‐gas ozone concentrations were simultaneously monitored for the further analysis. As a result, the ozone mass transfer rate per unit volume of the RPB was significantly higher because of its higher mass transfer coefficient and gas–liquid concentration driving force. Furthermore, ozonation kinetics was found to be independent of the gravitational magnitude of an ozone gas–liquid contactor. Therefore, the results suggest employing RPBs as ozone‐contacting devices with the advantage of volume reduction. The experimental results, which can be used for further modeling of the ozonation process in the RPB, also show the requirement of correct design for the RPB. Consequently, the present study is useful for the understanding of practical application of RPBs. Copyright © 2004 Society of Chemical Industry     

臭氧氧化-光催化降解水中的五氯酚

利用臭氧氧化-光催化技术降解水中的有机污染物五氯酚(PCP)。对比了紫外光照射、臭氧氧化、光催化、臭氧氧化-光催化4种方法降解PCP的情况。考察了臭氧氧化-光催化体系中臭氧流量、臭氧产量、PCP初始质量浓度、pH和CO23-等因素对PCP降解率的影响。实验结果表明,臭氧氧化-光催化法比单独使用紫外光照射、臭氧氧化、光催化法更能有效的去除PCP;增加臭氧流量和臭氧产量有利于提高PCP的降解率;降低PCP的初始浓度,PCP的降解率显著提高;pH对PCP的降解效果影响不明显;CO23-的存在显著降低了PCP的降解率。在臭氧氧化-光催化体系中,除臭氧直接氧化降解PCP外,臭氧与TiO2协同作用产生的.OH对PCP的降解也起到了重要作用。     

Efficacy and Safety Evaluation of Ozonation to Degrade Aflatoxin in Corn

ABSTRACT: This study determined the efficacy and safety of ozonation in degrading aflatoxin in corn. Ozonation (10 to 12 wt%) reduced aflatoxin levels by 92% and no reversion to the parent compound was observed. Ozonation had minimal effect on fatty acids of uncontaminated corn, but had significant effect on fatty acids of contaminated corn. Crude extracts showed no mutagenic potential in the Ames assay using TA98 and TA100. Clean-up using hexane increased their mutagenic potentials. Clean-up using Mycosep columns increased the mutagenic potentials 18 to 617%. Hexane extracts from ozone-treated contaminated corn had lower inhibitory effect. This suggested that a fat-soluble mutagen is being formed or natural inhibitors of mutagenicity are being destroyed.     

Catalytic ozonation of NH4+-N in wastewater over composite metal oxide catalyst

Large amounts of water containing-ammonium nitrogen(NH₄⁺-N)have attracted increasing attention.Catalytic ozonation technology,involving the generation of hydroxyl radical(OH)with strong oxidation ability,was originally utilized to degrade organic-containing wastewater.In this paper,Ce/MnOx composite metal oxide catalysts prepared with different preparation conditions were used to degrade wastewater containing inorganic pollutant(NH₄⁺-N).The as-prepared catalyst features were characterized using X-ray diffraction(XRD),Brunauer-Emmett-Teller method(BET),scanning electron microscopy(SEM),energy dispersive X-ray spectroscopy(EDS),Fourier transform infrared spectroscopy(FTIR),X-ray photoelectron spectroscopy(XPS)and H₂-temperature programmed reduction(H₂-TPR)techniques.The results show that the catalyst,prepared by conditions with precipitant Na₂CO₃ and Ce/Mn molar ratio 1:2 calcined at 400℃for 3 h in pH 11.0,displays the optimal performance,with the removal rate of NH₄⁺-N and selectivity to gaseous nitrogen,88.14 wt%and 53.67 wt%,respectively.The effects of several operating factors including solution pH,initial NH₄⁺-N concentrations and scavengers were evaluated.In addition,XRD patterns of catalyst with the best performance and the comparative study on decontamination of NH₄⁺-N by various processes(O₃,catalyst and catalyst/O₃)show that the primary metal oxides are CeO₂ and MnO₂ in Ce/MnOx composite metal oxide catalysts,which have a synergistic effect on the catalytic ozonation of NH₄⁺-N,and the new phase MnO₂ plays a great role.After 5 consecutive use cycles,the degradation efficiency is declined slightly,and can still achieve better than 70 wt%over 1 h reaction.Additionally,the application of catalytic ozonation for actual wastewater on the removal rate of NH₄⁺-N was investigated.Possible mechanism and degradation pathway of NH₄⁺-N were also proposed.In a word,the application of CeO₂-MnO₂ composite metal oxide catalysts in catalytic ozonation can be regarded as an effective,feasible and promising method for the treatment of NH₄⁺-N.     

Catalytic Degradation of Nitrobenzene and Aniline in Presence of Ozone by Magnesia from Natural Mineral

In this work, magnesia from natural brucite mineral has been used firstly for catalytic degradation of nitrobenzene and aniline in presence of ozone. Compared with single ozonation, the catalytic ozonation accelerated markedly the degradation of nitrobenzene and aniline. The influences of hydroxyl radical scavengers, pH values, and reaction temperatures on degradation were investigated. It was found that the essential of catalysis was the homogeneous catalysis of hydroxyl ions in water, which accelerated the generation of hydroxyl radicals. As a catalyst, magnesia from natural brucite has supplied an economical and feasible choice for catalytic ozonation of nitrobenzene and aniline in industrial wastewater.     

Preparation and structural characterization of Co/Al2O3 catalysts for the ozonation of pyruvic acid

A series of Co/Al₂O₃ catalysts were prepared by the incipient wetness impregnation method using γ-Al₂O₃ support and (CH₃COO)₂Co·4H₂O solutions, followed by calcination at 500–800 °C. Characterization of catalysts was accomplished by several techniques such as thermogravimetric analysis (TGA), differential scanning calorimetry (DSC), physisorption of nitrogen, mercury and helium-based pycnometries, Fourier transform-infrared spectroscopy (FT-IR), X-ray diffraction (XRD) and pH of zero charge (PZC). Impregnation of support produced a moderate decrease of its surface area and pore volume and also led to minor changes of its PZC. Depending on preparation conditions (i.e., calcination atmosphere and temperature and metal loading), one or more of the following Co-containing compounds were identified: CoO, Co₃O₄ and CoAl₂O₄. The support and prepared Co/Al₂O₃ catalysts were tested to catalyze the ozonation of aqueous pyruvic acid at pH 2.5. Pyruvic acid was shown refractory towards single ozonation but the use of γ-Al₂O₃ and Co/Al₂O₃ catalysts resulted in 56–96% pyruvic acid conversion and 41–78% decrease in DOC after 2 h of ozonation of phosphate-buffered solutions. In the absence of the buffer, conversion rate was enhanced likely as a result of pH increase during the course of the process thus giving rise to the indirect way of ozonation through hydroxyl radicals. Acetic acid was found as the main by-product of pyruvic acid ozonation. Depending on the catalyst used, yield of acetic acid varied from 32 to 49%, values noticeably lower that that obtained from the control non-catalytic ozonation experiment (73%). Differences in catalytic activity amongst the various Co/Al₂O₃ catalysts investigated were attributed to the different Co active phases deposited on the γ-Al₂O₃ surface. The following sequence of increasing activity can be inferred from experimental results: CoO, CoAl₂O₄ and Co₃O₄. All the Co/Al₂O₃ catalysts prepared showed good stability as the percentage of cobalt leached out was rather low.     

Decolourisation of aqueous dyes by sequential oxidation treatment with ozone and Fenton's reagent

Combined oxidation with ozone and Fenton's reagent (‘Fentozone’ process) for decolourisation of aqueous dyes was studied and compared with traditional Fenton's reagent. Although the ‘Fentozone’ process was found to be effective at a wide range of pH values, the maximum colour removal was achieved at pH 4. The effect of pre‐ozonation on colour removal efficiency of aqueous dyestuffs in the subsequent treatment with Fenton's reagent was investigated. The reaction kinetics using water‐soluble acid and reactive dyes were also studied. Our experimental results show that pre‐ozonation can considerably accelerate decomposition of dyestuffs in the subsequent treatment with Fenton's reagent. Different concentrations of ferrous sulfate were used to investigate their influences on the removal of colour. The rate of reaction increased with increasing doses of ferrous sulfate. © 2002 Society of Chemical Industry     

对硝基苯酚臭氧化反应动力学研究

在T=298K,pH=2.1～6,采用停流光谱仪研究了对硝基苯酚与臭氧在水溶液中的臭氧化反应动力学。实验结果表明,对硝基苯酚臭氧化总的反应是2级,对臭氧浓度和对硝基苯酚浓度分别为1级。臭氧化反应速率常数随溶液pH值的增大而增大;T=298K时,当pH值从2.1变化到6,总的反应速率常数从5.88×104L(mol·s)-1增大到1.56×106L(mol·s)-1。为了验证其适用性,对臭氧在搅拌釜中在对硝基苯酚溶液中的吸收过程进行了模拟。采用MATLAB软件求解臭氧在搅拌釜中在对硝基苯酚溶液中吸收过程的质量平衡方程,模拟得到了吸收过程中臭氧和对硝基苯酚浓度的变化,并与实验值进行了比较。结果表明,在85%的对硝基苯酚降解之前,模拟值和实验值能很好地一致。在反应末期,模拟值和实验值出现了一定的偏差。     

污泥臭氧减量对淹没式生物膜工艺运行效能的影响

针对淹没生物膜法(SBF)和污泥臭氧化各自在污泥减量方面的优点,提出了化学臭氧化和复合生物膜法相结合的污泥减量工艺,并对臭氧化对SBF运行效能的影响进行了实验研究。通过2个并行的SBF系统污泥臭氧化结果进行对比,结果显示臭氧化能够显著降低系统的污泥产率(0.043 kg/kg,较不加臭氧化的SBF系统下降了76%),同时不对硝化和有机物的去除作用产生明显的影响,系统出水水质良好。     

臭氧─活性炭吸附技术处理含酚废水实验研究

为提高含酚废水的处理技术,改善水生态平衡,分别采用臭氧氧化、活性炭吸附─臭氧氧化和臭氧氧化─活性炭吸附联用等方法处理含酚废水。试验结果表明:臭氧氧化─活性炭吸附联用技术处理含酚废水效果最好;得出的最佳试验条件为:活性炭加入量为30g/L、吸附时间为20min、臭氧流量为8mg/min、反应时间为20min及溶液初始p H值为8.5。在最佳试验条件下,臭氧氧化─活性炭吸附联用工艺对CODCr的去除率为74.60%。