Nitrogen-doped hierarchically porous carbon obtained via single step method for high performance supercapacitors

In the present work, nitrogen doped hierarchically activated porous carbon (APC) samples have been synthesized via single step scalable method using ethylene di-amine tetra acetic acid (EDTA) as precursor and KOH as activating agent. Activated porous carbons with different pore sizes have been developed by varying the activation temperature. SEM, TEM and SAXS analysis suggest that with variation of activation temperature, a hierarchical porous structure with interconnected meso-pore and micro pores has been achieved. The sufficiently high surface area of the synthesized materials provides active sites to enhance the diffusion of ions between the electrolyte and the carbon electrodes. The electrode prepared at 800 °C activated sample exhibited highest specific capacitance of 274 Fg^-1 in two electrode setup, at a current density of 0.1 Ag^-1 in 1 M aqueous H₂SO₄. Along with this, it showed maximum energy density of 9.5 Whkg^?1 at a power density of 64.5 Wkg^-1. The remarkable electrochemical performance reveals that the synthesized nitrogen doped activated carbon electrodes derived from EDTA can be tuned to have optimum pore structure and pore size distribution for better electrochemical performance, so it can be considered as a potential electrode material for applications in electrochemical energy storage.     

锰铜基高阻尼合金中锌量的测定──硫氰酸盐萃取分离络合滴定法

基于甲基异丁基甲酮于稀盐酸介质中定量地萃取Ｚｎ￣（２＋）与ＣＮＳ￣－形成的络阴离子。从而达到与共存的锰、镍、铝、铬的完全分离。在有氟化物、硫脲存在时Ｆｅ￣（３＋）、Ｃｎ￣（２＋）和Ａｇ￣＋也不被萃取。有机相中的锌于ＰＨ５．５“六胺”缓冲介质中返萃取回水相，用ＥＤＴＡ滴定。在文中给定的条件下锌的一次被萃取率可达９９％以上，成功地解决了锰铜基高阻尼合金中共存离子对锌量测定的干扰问题。     

电位滴定法快速测定洗衣粉中的聚磷酸盐含量

用强酸分解洗衣粉中的聚磷酸盐，以电位滴定法间接测定其中的聚磷酸盐含量。该法简便，快速，结果可靠。     

迭代回归法计算T型电位滴定中试液含量

本文将迭代回归法计算Ｔ型电位滴定中，叙述了其原理及数学推导，并运算了一批实验数据，结果表明，该法准确度较高，且不需空白溶液校正。     

示波极谱滴定法测定工业氯化钙主要成份

在氯化铵-氨水(pH=11)支持电解质中用微银汞膜电极进行试验,锰、铁不干扰测定,用EDTA滴定氯化钙获得令人满意的结果。对三种样品进行分析,变异系数为0.08％—0.11％。该法快速准确,适用于氯化钙主要成份的测定。     

微机模拟处理pH络合滴定法研究——Ⅱ.终点确定方法和最佳实验条件模拟估计程序

本文利用简便的滴定过程模型,确立了微机模拟处理实验数据,方便、准确地求解络合滴定等当点的方法。设计了最佳实验条件模拟估计程序。该法测定Zn~(2+),Pb~(2+),Cu~(2+),Fe~(3+)结果的相对误差Δ<1％。pH=6-7时,测定Ca~(2+)的相对误差为-1.61％;σ<0.001mmol,(N=5)。     

The initial behaviour of freshly etched copper in moderately acid, aerated chloride solutions

When freshly etched samples of various types of copper were exposed in moderately acid, aerated chloride solutions, two phenomena were observed. First the corrosion potential and the pH of the solution decreased over a shorter time, then the potential increased over a long period (600-1500 min), following an s-shaped pattern. Increase in pH during the second stage was avoided using a pH-stat. The corrosion rate increased little or not at all over the entire period. A tentative interpretation of the short-term behaviour is presented with some reservation. The long-term development of the potential suggests phase formation or transformation following the Avrami pattern. By suitable derivations it was possible to fit the development of potentials to the Avrami equation. Subsequent examinations by Auger spectroscopy proved the presence of thin layers of Cu₂O on the copper surfaces, increasing in thickness with exposure time. The dissolution kinetics can be described in terms of two parallel electrochemical reactions and a simultaneous non-electrochemical dissolution reaction.     

稀土溶液标准物质的研制

选择7种稀土元素:La、Ce、Sm、Eu、Yb、Lu、Y为研究对象,采用高纯稀土氧化物(≥99 99%)为原料,经ICP MS及ICP AES对纯度进行分析后,分别制备成浓度为1000μg mL的稀土溶液标准物质。采用准确、可靠并能溯源的EDTA络合滴定法进行量值核对、均匀性及稳定性检验。对标准物质的不确定度进行了全面的评定。研制的稀土溶液一级标准物质,总不确定度优于0 6%,稳定性达两年以上。     

双氧水冷漂助剂液中润湿剂的分离和鉴测

双氧水冷漂助剂液中的润滑剂——烷基硫酸钠可以在四级氧化铝柱上用氯仿和乙醇—水的淋洗体系进行分离而获得纯品;用NMR和GC法进行结构分析;两相滴定法测定其含量。     

佛尔哈德法测定氯化除汞上清液中的氯量

控制pH4-6，用锌粉还原氯化除汞上清液中的汞（Ⅱ）离子，取置换后液加入过量的硝酸银标准溶液，以硫酸铁铵溶液作指示剂，用硫氰酸钾标准滴定溶液滴定来测定氯量。该方法的检出限：0．25mg／100mL，回收率：98％-101％。