Processing of Yttria-Alumina Coated Silicon Nitride Slips by Slip Casting

Si₃N₄powders coated with 6 wt% Y₂O₃and 4 wt% Al₂O₃were prepared by coprecipitation. The resulting powders were dispersed in water at different pH values and with addition of various amounts of ammonium polyacrylate (NH₄PA) to produce 32 vol% slips. The influence of the amount of NH₄PA solution added and pH on the rheological properties of 32 vol% coated Si₃N₄slips were studied. In addition, the sintered density of cast samples was determined and related to the degree of slip dispersion. The adsorption of the NH₄PA on the coated particle surface was rather high and the surface became saturated near 0.86 mg/m²at pH 9.2. High NH₄PA concentrations (1.7–3 wt%) were necessary to obtain well dispersed 32 vol% coated Si₃N₄slips at pH 9.2. The best stabilization was obtained with the addition of 2.3 wt% NH₄PA; in this condition, the viscosity reached a minimum value of 35 mPa.s at 100 s^–1. The slip viscosity increased with increasing pH from 9.2 to 10.2. Slips with low viscosities gave a more dense packing of cast samples and consequently higher sintered density values.     

某铁路医院加速器室大体积防射线混凝土施工

结合大同铁路分局中心医院直线加速器室工程实际，介绍了大体积防射线混凝土的特点及施工中应注意的事项，并阐述了具体的施工技术。     

无线电引信被干扰率及抗干扰率

本文从无线电引信相对杀伤比率出发，引伸出引信被干扰率及抗干扰率的定义及计算公式。     

Pullout tests of epoxy-coated reinforcement in concrete

The bond strength and slip of epoxy-coated reinforcing bars in concrete have been evaluated by carrying out single pullout and double pullout tests. In extended single pullout tests, slip measurements were made while tensile force was applied to reinforcing bars embedded in concrete. In double pullout tests, 20 cycles of load were applied at levels of steel stress between zero and 0·5 times characteristic steel strength. Strains were measured by electrical resistance strain gauges glued inside the bars. Both epoxy-coated and uncoated bars were used in the investigation, to obtain comparative results. The strain gradient along the bar was found to be less for the coated reinforcement. In general, the epoxy coating was found to increase slip in bond and thereby reduce the bond performance of coated bars.     

仲胺衍生物柴油流动改进剂

考察了十八种胺衍生物改善高含蜡柴油低温流动性的作用规律。结果表明，仲胺衍生物主要是通过增溶柴油中的长链正构烷烃，使浊点、冷滤点降低，从而改善柴油低温性能。仲胺衍生物与T1804流动改进剂（乙烯-醋酸乙烯酯聚合物）复合可以改善蜡晶的分散性能，对降低柴油冷滤点有增效作用。     

CARS光谱测温及仪器狭缝函数对测量的影响

设计了一种利用光参量振荡器(OPO)来代替染料激光器的宽带相干反斯托克斯喇曼散射(CARS)光谱测温实验装置。为了提高CARS测量温度的精度,测量和分析了检测系统中狭缝函数对测量结果的影响,确定了狭缝函数的具体形式。将测量结果与热电偶读数比较,发现在温度范围300K～1200K内,温度测量的不确定度小于2%。     

溶胶-凝胶法制备TEOS-DOS基SiO2疏水减反射膜:溶胶微结构对膜性能的影响

以乙醇为溶剂,正硅酸乙酯(TEOS,tetraethoxysilane)在氢氧化铵催化下水解缩聚为纳米尺度的无定型SiO2溶胶颗粒,二甲基二乙氧基硅烷(DDS,dimethyldiethoxysilane)在盐酸催化下水解缩聚为线状聚二甲基硅氧链.用混合溶胶在玻璃基片上旋转镀膜,然后于80℃空气气氛下热处理.实验证明通过DDS将疏水的双甲基链引入镀膜胶体,使膜兼具疏水性和减反射性能.利用激光散射粒度分析仪和电子显微镜研究了溶胶颗粒的粒度变化和聚集情况等溶胶微结构,用物理吸附仪研究了膜的孔结构,考察了热处理前后膜的疏水性和透射谱,得到了溶胶微结构与膜性能之间的关联.     

Characterization of the flow behaviour of sausage emulsions with a simple tube viscometer

A specially designed tube viscometer was used to measure apparent viscosity during flow of Bologna type sausage emulsions moving through a pipe. Emulsions varied in fat content (from 21.8 to 44.3%) and in moisture/protein ratio (from 3.7 to 5.6), and the effects of added sodium chloride, sodium diphosphate, starch and blood plasma were investigated in a 36% fat, 3.7 moisture/protein emulsion.
The shear stresses determined as a function of shear rate were fitted by a power law. Yield stress of the emulsions was negligible relative to the applied stress. However, inspection of the flow profiles indicated that considerable slip of the sausage emulsion occurred at the pipe wall. Both emulsion flow and slip contribute to overall flow behaviour, so a kind of effective viscosity is determined. Intrinsic rheological properties and wall slip will both be affected by the composition of the sausage emulsion.     

卷烟信息网络防伪系统的构建及应用

介绍了卷烟信息网络防伪管理系统构建原理、技术特点和功能 ,及其在烟草行业中的应用。