航天产品多源可靠性信息的收集与整理--建立可靠性信息数据库

航天产品可靠性信息的来源多样，可靠性信息的时间性、随机性、有价性、时效性和可追溯性等特征，决定了可靠性数据收集应满足真实性、连续性、完整性等基本要求。同时，对多源信息的收集应遵循先进行需求分析，再确定数据收集点并制定数据收集表格的程度进行。给出了信息的适用性准则和信息分类的三维模型。最后结合具体型号航天产品的可靠性工作的要求，给出了可靠性信息数据库系统的整体方案设计。     

柠檬酸三酯三季铵盐阳离子表面活性剂的合成

采用柠檬酸、环氧氯丙烷和十二烷基二甲基叔胺合成三烷基三季铵盐阳离子表面活性剂。得到较佳工艺条件:n(柠檬酸)∶n(十二烷基二甲基叔胺)∶n(环氧氯丙烷)为1∶3∶3,于85℃下反应12 h,得到产率大于90%的目的产物。测定了产物的cmc为3.3×10-4mol/L。研究了反应条件对目的产物产率的影响。结果表明:随反应温度的升高,产率逐渐增加,当升温到一定程度后,产率略有下降;反应12 h后产率基本不再变;十二烷基二甲基叔胺及环氧氯丙烷与柠檬酸的投料比大于3时,对三烷基三季铵盐阳离子表面活性剂产率的增加影响不大;异丙醇溶剂有利于反应产率的提高,但随着溶剂量的增多,反应产率会下降。     

三(苄基硫醇)锑的合成及其应用性能

以苄基硫醇、三氧化二锑 (或三氯化锑 )等为原料 ,研究了三 (苄基硫醇 )锑的最佳合成工艺条件 ,产率分别达到 90 %和 95 %。用元素分析法及红外光谱技术对产品进行了表征 ,热分析技术 (TG和DSC)研究表明 ,含合成产物的聚氯乙烯 (PVC)制品的初始分解温度在 2 2 0℃以上 ,其热分解效应为 1 1 5 5J/g。热老化研究表明 ,当合成产物添加量达 1 5份 (PVC质量为 1 0 0份 )时 ,PVC树脂的热稳定时间为 1 8min(2 0 0℃ ) ,当其与硫醇钡以质量比 3∶1复配时 ,可显著提高PVC制品的长期热稳定性     

Reactive extraction of itaconic acid using tri‐n‐butyl phosphate and aliquat 336 in sunflower oil as a non‐toxic diluent

Itaconic acid finds a place in various industrial applications. It can be produced by biocultivation in a clean and environment friendly route but recovery of the acid from the dilute stream of the bioreactor is an economic problem. Reactive extraction is a promising method to recover carboxylic acid but suffers from toxicity problems of the diluent and extractant employed. So there is need for a non‐toxic extractant and diluent or a combination of less toxic extractants in a non‐toxic diluent that can recover acid efficiently. Effect of different extractants: tri‐n‐butylphosphate (TBP) (an organophosporous compound) and Aliquat 336 (a quaternary amine) in sunflower oil was studied to find the best extractant–sunflower oil combination. Equilibrium complexation constant, K_E, values of 1.789 and 2.385 m³ kmol^?1, respectively, were obtained for itaconic acid extraction using TBP and Aliquat 336 in sunflower oil. The problem of toxicity in reactive extraction can be reduced by using a natural non‐toxic diluent (sunflower oil) with the extractant. Copyright © 2010 Society of Chemical Industry     

Physical Properties of Soybean Oleogels and Oil Migration Evaluation in Model Praline System

The present study examined the physical properties of soybean oleogels and commercial confectionery filling fats and evaluated the oil migration properties in model praline systems. Soybean oleogels were prepared using different oleogelators namely monoglyceride (MAG oleogels) and a mixture of sorbitan tri‐stearate (STS) with lecithin (50:50) (Lec‐STS oleogels). Both MAG oleogels and Lec‐STS oleogels demonstrated a flat solid fat content (SFC) profile with zero SFC at 40 °C. At low temperature, MAG oleogels and Lec‐STS oleogels demonstrated a non‐flowing gel‐like property due to the ability of the oleogelator to entrap liquid oil. In addition, oleogels also showed thixotropic behavior indicating the possible capability to prevent migration of filling fats to coatings and also good flow ability during pumping though manufacturing equipment. The textural property of oleogels also did not change significantly upon storage indicating good structural stability. When used as in a model praline system, oleogels demonstrated a migration delaying property.     

高纯度溴代三嗪的制备方法研究

本文研究了由苯酚与三聚氯氰反应合成2,4,6-三苯氧基-1,3,5-三嗪,然后溴化合成溴代三嗪的反应条件,得到合成2,4,6-三苯氧基-1,3,5-三嗪合适的工艺条件:用氯苯作溶剂,无水三氯化铝做催化剂,苯酚与三聚氯氰在回流温度下保温反应3h。     

岩体破坏准则及其参数研究

首先对Coulumb-Mohr准则,Hoek-Brown准则,Drucker-Prager准则,以及π平面准则的物理含义及表达式进行了分析,继而依托岩体三轴试验结果,通过回归分析确定了上述破坏准则中的材料常数;而后结合各破坏准则同岩体参数之间的关系,分析了试件岩体的物理力学参数;最后分析了所得参数及上述破坏准则的有效性.     

Comparitive study on facilitated pertraction of succinic acid using TRI‐n‐octylamine without and with 1‐octanol

Succinic acid has been pertracted with TOA using free liquid membranes without or with 1‐octanol. The addition of the alcohol led to the increase of up to 2.8–3 times of the acid's initial and final mass flows. At the same time, the influence of 1‐octanol on the transport capacity of the pertraction system was negative, its addition inducing the accumulation of succinic acid into the liquid membrane. A mathematical model describing the acid accumulation inside the liquid membrane has been developed for pertraction systems without and with 1‐octanol and offers good concordance with the experimental data. © 2012 Canadian Society for Chemical Engineering