A new analysis of two phase flow on hydrogen production from water electrolysis

It is clear that the entire world have to research, develop, demonstrate and plan for alternative energy systems for shorter term and also longer term. As a clean energy carrier, hydrogen has become increasingly important. It owes its prestige to the increase within the energy costs as a result of the equivocalness in the future availability. Two phase flow and hydrogen gas flow dynamics effect on performance of water electrolysis. Hydrogen bubbles are recognized to influence energy and mass transfer in gas-evolving electrodes. The movement of hydrogen bubbles on the electrodes in alkaline electrolysis is known to affect the reaction efficiency. Within the scope of this research, a physical modeling for the alkaline electrolysis is determined and the studies about the two-phase flow model are carried out for this model. Internal and external forces acting on the resulting bubbles are also determined. In this research, the analytical solution of two-phase flow analysis of hydrogen in the electrolysis is analyzed.     

Development of high pressure membraneless alkaline electrolyzer

A technology for cyclic generation of hydrogen and oxygen using electrodes made of variable valency material that does not need the use of separating ion-exchange membranes is presented. The technological solution enables to fabricate electrolyzers for uninterrupted producing high-pressure hydrogen with reduced energy intensity of the production. The total work for compressing 1 m³ of hydrogen and 0.5 m³ of oxygen has been estimated. Results of investigation of influence of discrete supply of DC current to the electrolysis cell, in order to improve the processes of gas evolution and to simplify the power systems of the electrolysis plant, have been considered. There is also considered an electrolysis installation equipped with a thermosorption compressor in which LaNi₅ is used as a hydride-forming compound. The comparative characteristics of the developed electrolyzer and the currently used hydrogen generators are given.     

癸二酸二甲酯与1,2,2,6,6-五甲基哌啶醇的酯交换反应

对癸二酸二甲酯与1,2,2,6,6-五甲基哌啶醇的酯交换反应进行了研究;分别考察了四异丙基钛酸酯、氨基锂、氧化二辛基锡3种催化剂的性能;采用氢核磁共振确定了产物的结构;考察了以四异丙基钛酸酯为催化剂时反应温度、反应时间、原料配比和催化剂用量对反应的影响。实验结果表明,四异丙基钛酸酯催化剂的催化效果最好;在癸二酸二甲酯与1,2,2,6,6-五甲基哌啶醇摩尔比1∶1.79、四异丙基钛酸酯催化剂的用量为反应物总质量的0.31%、反应温度180℃、反应时间6h的条件下,所得产物中单(1,2,2,6,6-五甲基-4-哌啶基)癸二酸甲酯(简称单酯)质量分数为23%和双(1,2,2,6,6-五甲基-4-哌啶基)癸二酸酯(简称双酯)质量分数为73%,单双酯质量比为1∶3.17,产物收率为93.3%。该方法可得到理想的单双酯比例及产物收率,具有很好的工业应用前景。     

碱法造纸黑液驱油研究

在玻璃细珠充填柱人造岩心模型上进行了碱法造纸黑液驱替稠油的实验研究，考察了稠油酸值、盐、温度、岩心渗透率、注入量和注入方式的影响。在实验条件下碱法造纸黑液驱稠油的采收率较水驱提高２５％     

甘油三乙酸酯超临界酯交换反应及其动力学研究

研究了在超临界条件下甘油三乙酸酯与甲醇或乙醇的酯交换反应,分别考察了超临界状态下醇油摩尔比和温度对反应的影响。实验结果表明,甲醇或乙醇与甘油三乙酸酯的摩尔比为14、反应温度为350℃、反应时间为20m in时,乙酸甲酯或乙酸乙酯的收率分别达100%和60%。对超临界状态下动力学的研究结果表明,甘油三乙酸酯与甲醇或乙醇的酯交换反应为拟一级反应,在相同的反应条件下,采用甲醇时酯交换反应速率比用乙醇时快,相应的甘油三乙酸酯的转化率也高;甘油三乙酸酯在超临界甲醇或乙醇中酯交换反应的表观活化能分别为58.7 kJ/mol和75.1 kJ/mol,甘油三乙酸酯与甲醇酯交换反应的活化能低于与乙醇酯交换反应的活化能,表明碳链短的醇更易进行酯交换反应。     

纳米钛酸盐催化合成碳酸二正丁酯

以廉价的偏钛酸为原料,采用水热法和乙醇热法制备了纳米钛酸盐(简称钛酸盐),并对其进行了X射线粉末衍射和X射线光电子能谱表征。考察了钛酸盐的种类、制备方法、晶型对催化碳酸二甲酯(DMC)与正丁醇酯交换反应的影响。实验结果表明,乙醇热法比水热法制备的钛酸盐粒径小;对于不同的钛酸盐,随钛酸盐碱性的增强,催化活性提高,但由于三价钛的存在,钛酸锂对产物碳酸二正丁酯(DBC)的选择性低于钛酸钡;钛酸钾的催化活性最高,DMC转化率达到65%,DBC选择性达到100%,DBC收率达到65%,并在5次循环使用过程中,催化性能稳定;对于同种钛酸盐,催化活性随粒径的增加而减小;对于钛酸钡,立方相结构的催化活性优于四方相结构。     

利用高酸值餐饮废油脂制备生物柴油

以高酸值餐饮废油脂为原料,在酯化反应后再经两步酯交换反应制备生物柴油。在酯化反应中添加吸水剂可降低油脂的酸值,经一次酯化反应即可将油脂的酸值降至2m g/g左右,满足酯交换反应的要求。考察了酯化反应中吸水剂的添加方式、种类及其用量对酯化反应的影响,以及酯交换催化剂的种类及用量对脂肪酸甲酯(FAME)收率和产物组成的影响。实验结果表明,以凹凸棒土为吸水剂(用量为餐饮废油脂中游离脂肪酸质量的3%),且在酯化反应30m in时加入,酯化效果较好;以质量比为1∶1的NaOH和KOH混合物为催化剂进行两步酯交换反应时,催化剂的最佳用量依次为1.00%和0.75%(质量分数,基于油脂的质量),FAME收率最高达到96.33%。