Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

Insight into the chemical reaction of CH2OH with NO: Formation of N-hydroxy formamide as an isocyanic acid precursor

This study has explored the potential energy surface on the chemical reaction of CH₂OH with NO by using ab initio calculation. We have found the new reaction pathway producing N-hydroxy formamide, which can further decompose to generate isocyanic acid as a reducing agent of hydrocarbons selective catalytic reduction.     

Single and combined deactivating effect of alkali metals and HCl on commercial SCR catalysts

Two commercial SCR catalysts, with a nominal W content of about 9 wt.% and a V nominal content of 0.55 and 1.8 wt.%, respectively, were contacted with different amounts of Na and K and with HCl vapours in order to simulate poisoning by species more specifically contained in exhaust gases from MSW combustion. Catalysts were characterised using XRD analysis, SEM/EDX analysis, BET and pore size distribution measurements, NH₃ TPD, TG analysis. Poisoning agents do not cause loss of surface area nor pore occlusion. A significant loss of surface acidity was observed upon alkali metals poisoning whereas a decreasing of vanadium content was observed for the more concentrated catalysts upon HCl poisoning. Catalysts deactivation is proportional to the number of acid sites neutralised by alkali metals adsorbing ammonia in the temperature range typical of SCR process. HCl promotes the formation of new acid sites showing a lower activity compared to the original one.     

一种小电流下的引弧及稳弧方法

介绍一种小电流直流TIG焊中的引弧及稳弧方法，并对实现此功能的控制电路进行了详细的分析。简单介绍了此种小型焊机的特点及用途。     

超超临界锅炉喷氨优化与调整

某厂超超临界燃煤火电机组已完成超低排放改造,实现烟尘、SO₂和NO_x排放浓度远低于10 mg/Nm³、35 mg/Nm³和50 mg/Nm³。但锅炉中脱硝系统氨逃逸过大,导致脱硝系统后面的烟道内空预器及低温省煤器堵塞严重,严重影响了机组运行安全。通过测量该锅炉SCR反应器出口NOx浓度及氨逃逸量等参数,基于实测数据分析对锅炉喷氨量进行优化调整,降低SCR反应器出口氨逃逸量,从而有效缓解空预器及低温省煤器的堵塞状况,保证机组的高效安全运行。     

铈基SCR脱硝催化剂研究进展

近年来铈（Ce）基脱硝催化剂成为低温脱硝领域的研究热点,按载体类型可分为金属氧化物催化剂、二氧化钛载体催化剂、分子筛载体催化剂、活性炭及氧化铝载体催化剂等。按催化剂种类分别介绍了掺杂改性、制备工艺、反应条件等对催化剂性能的影响,并阐述了可能的原因机理。目前,铈基催化剂大多处于实验室阶段,工业化应用尚存在问题,尤其作为低温脱硝催化剂,活性中心堵塞问题更加突出,并且催化剂成本较高。未来可从催化剂制备工艺入手解决催化剂成型问题,以实现工业应用。同时探讨催化剂中毒机理,进一步提升其抗中毒能力。另外,寻求适宜的材料与铈掺杂组合,达到高效脱硝和经济效益最大化。     

NO reduction by CH4 over Pd/Co-sulfated zirconia catalysts

A series of sulfated zirconia supported Pd/Co catalysts was synthesized by the sol–gel method and examined for NO_x reduction by methane. The NO conversion increased up to a Co/S ratio of 0.43, and then decreased at a higher Co loading (Co/S = 0.95). Sulfate content was also essential for obtaining high selectivity to molecular nitrogen. A catalyst loaded with 0.06 wt.% Pd, 2.1 wt.% Co and 2.1 wt.% S (Pd/Co-SZ-2) exhibited remarkable performance under lean conditions and displayed stability in a long-term durability test using a synthetic reaction mixture containing 10% water vapor. This catalyst exhibited the highest sulfur retention most probably as cobalt sulfide. Besides, the catalytic oxidation of NO to NO_y groups was confirmed by FT-IR, in agreement with the general mechanism for the SCR of NO by hydrocarbons. In the absence of oxygen in the feed stream, the catalyst was highly active for NO reduction with methane. IR stretching bands assigned to N₂O and adsorbed nitro groups were identified upon adsorbing NO on Pd/Co-SZ-2. This indicates that under rich conditions disproportionation of NO to N₂O and NO₂ occurs and confirms that the formation of NO₂ species is an essential step for NO reduction by CH₄.     

Low temperature SCR of NO with NH3 over carbon nanotubes supported vanadium oxides

A novel multiwalled carbon nanotube (CNTs) supported vanadium catalyst was prepared. The structure of catalyst prepared was characterized by TEM, BET, FTIR, XRD and temperature-programmed desorption (TPD) methods. The results indicated that vanadium particles were highly dispersed on the wall of carbon nanotubes. The V₂O₅/CNT catalysts showed good activities in the SCR of NO with a temperature range of 373–523 K. The Lewis acid sites on the surface of V₂O₅/CNT are the active sites for the selective catalytic reduction (SCR) of NO with NH₃ at low temperatures. It was suggested that the reaction path might involve the adsorbed NH₃ species reacted with NO from gaseous phase and as well as the adsorbed NO₂ species. The diameter of CNTs showed positive effect on the activities of the catalysts. Under the reaction conditions of 463 K, 0.1 Mpa, NH₃/NO = 1, GHSV = 35,000 h⁻¹, and V₂O₅ loading of 2.35 wt%, the outer diameter of CNTs of 60–100 nm, the NO conversion was 92%.     

Pd/Al2O3催化剂上CH4选择性还原NO的研究

考察了Pd/Al₂O₃、In/Al₂O₃和Co/Al₂O₃对甲烷选择性还原NO的催化活性。结果表明，采用浸渍法制备的Pd/Al₂O₃、In/Al₂O₃和Co/Al₂O₃三种催化剂，在有氧气氛下，用CH₄作还原剂催化还原NO时，Pd/Al₂O₃催化剂的活性最佳，热稳定性好，在550 ℃，用CH₄选择还原NO，Pd/Al₂O₃催化剂表现出较强的催化能力，NO的转化率达到100%。在高空速实验中，该催化剂亦表现出较高的活性，其活性顺序为Pd/Al₂O₃>In/Al₂O₃>Co/Al₂O₃。实验研究了助催化剂、氧含量以及空速对Pd/Al₂O₃催化剂活性的影响。     

新型碳质催化剂用于NH3选择性催化还原NOx的研究

以城市污水处理厂剩余污泥为原料制备了一种新型碳质催化剂。通过试验考察了催化剂在NH₃选择催化还原NO中的应用效果。结果表明,催化性能较好，最佳的制备和催化反应条件为：锌铁物质的量比1∶0.5，热解温度750 ℃，反应温度400 ℃，O₂浓度15%。在此条件下，NOx的最大转化率达98.3%。通过考察证明催化剂自身具有一定的还原性能。对催化剂进行了FTIR、TG、SEM和BET分析，结果表明，催化剂具有很丰富的孔结构、活性粒子和表面官能团，比表面积较大，最大可达307 m²·g^-1，分析结果显示具有良好的催化条件。